Hydraulic Press 11.0ft Flow 10.0 ft 2.0ft 6 3.0 ft Filter Pump Flow The diagram on the next slide shows a fluid power system for a hydraulic press The following is known: The volume flow rate is...
HELPPPP 5 Hydraulic Press ●4 11.0 ft Flow 10.0 ft 2.0 ft 1 6 3.0 ft Filter Pump Flow The diagram on the next slide shows a fluid power system for a hydraulic press. The following is known: The volume flow rate is 35 gpm. The hydraulic fluid has a specific gravity of 0.87 and v-4.30X10+ ft'/s. The power input to the pump is 20 hp. . The pump efficiency is 80 percent. The filter has a resistance coefficient K-1.85...
The diagram on the next slide shows a fluid power system for a hydraulic press The following is known: The volume flow rate is 35 gpm. The hydraulic fluid has a specific gravity of 0.87 and v-4.30x104 ft/s. The power input to the pump is 20 hp. The pump efficiency is 80 percent. The filter has a resistance coefficient K-1.85 based on the velocity head in the suction line. All piping is 2-in schedule 40 steel. The total length of...
3. Coolant System Q 30 gpm The fluid is H20 at ambient conditions. The resistance coefficient for the filter is K= 2.00. 2 inch Schedule 40 steel use nominal pipe inside diameter. a) Determine the minor head loses for the pump suction piping (Inlet of pump back to the tank) b) If the friction factor for the 10 ft of 2 inch steel pipe is f 025, find the Pressure at the inlet of the pump 4 ft Flow 20...
Fluid Mechanics & Fluid Power Determine the NPSH available. The pressure in the tank is - 20 kPa at 70 °C (atmospheric pressure is 100.5 kPa). The water level in the tank is 2.5 above the pump inlet. The pipe is 1%", schedule 40 with a total length of 12 m. The elbow is standard, and the globe valve is fully open. The flow rate is 95 L/min. FIGURE 13.27 llustration of pump performance for different impeller diameters with net...
#2 The following system sends methyl alcohol (sg-0.789, kinematic viscosity 1.27 x 10* ft'/sec.) at a flowrate of s0 gpm through a cross section given below. The methyl alcohol flows out of the tank at a duct that has the cross section below. In this cross section, the methyl ethyl flows through the outer part of the inner tubes for a distance of 100 feet before it encounters a fluid motor. For this cross section,consider the cross section surface material...
6. Determine the setting of a centrifugal pump, given that flow rate = 2.4 m/min; diameter of intake pipe = 160 mm; entrance losses = one velocity head in suction pipe; required NPSH = 42 kPa; water temperature = 30°C N D1, D2 : inlet and outlet diameters of impeller (rotor) b : impeller width 0,6 : inlet and outlet impeller vane angles (degrees) : speed of rotation of impeller (and its driver) in rpm V, V :tangential and radial...