03. A 220V single phase induction motor had an input current of 8 amps before the centrifugal switch operated. At t...
A 220V single phase induction motor had an input current of 8 amps before the centrifugal switch operated. At that stage the motor operated with a lagging power factor of 0.8. The current in the main winding was 5 amps, and it was lagging the line voltage by 40 degrees Q3 a) Determine the magnitude and phase angle of the current in the auciliary winding Show your work) showing the line current, main winding b) Draw sucat the auxiliary winding...
A three-phase delta-connected synchronous induction motor is connected to a 415 volt, 50 Hz supply. The winding resistance is negligible and the synchronous reactance per phase is 5 ohms. The input power is 20 kW and the motor has a leading power factor of 0.8. Draw the phasor diagram for this machine: ii) use the IXs phasor and the V phasor to construct the phasor for E. iii) measure or calculate the magnitude of E iv) By construction and/or by...
A single-phase electrical motor draws a current of 20 A from 240, 60 Hz line. A Fluke wattmeter is connected into line gives an active power (P) reading of 3,792 W. with line, neutral, appropriate fuse, switch, and motor itself. (DO NOT forget chassis ground of the motor for the safety of people working in/around the motor). Show a simple wiring diagram (a) Calculate the power factor (cost) of the motor and reactive power () it absorbs. (b) If we...
A single-phase, 230 V, 50 Hz, 8 pole, Induction Motor has the following equivalent circuit parameters: Z1 = 1.7 + j 2.7 Ω ZF = 12 + j 20 Ω ZB = 1.2 + j 2.4 Ω If the core loss is 84 W, while the friction and windage loss is 100 W at 5% slip. Determine: The line current drawn by the machine. (4) The power factor. (1) The input power. (2) The air-gap power. (3) The converted power. ...
Problem#(50 points) The nameplate for a three phase induction motor is shown below. The "NEMA NOM. EFF." of 93.6% can be taken to be the efficiency. Keep in mind that voltage and current in a 3PH system are specified as line voltage and current SIEMENS PE 21 PLUS PREMUM EFFICE 40 LL AND CHEMICAL DUITY QUALL Part A Assume the motor is run at the rated nameplate conditions: (a) Find the real electrical input power. (b) Find the numerical value...