PLEASE GIVE POSITIVE RATING IF YOU LIKE THE ANSWER.THANK YOU
.....HAVE A GOOD DAY.
3. An ISO M12x1.75 class-12.9 bolt is used to fasten three members as shown in Fig. Q3. Dimensions are in millim...
3. An ISO M12x1.75 class-12.9 bolt is used to fasten three members as shown in Fig. Q3. Dimensions are in millimeters. The first member is cast iron, the second is low-carbon steel and the third is aluminum. The static loading safety factor is 2.5. Determine a) Total bolt length, threaded length and threaded length in the joint. (6 pts) b) Bolt and joint stiffness using a 30° cone. (14 pts) c) Preload for permanent connections. (5 pts) d) Maximum static...
3. An ISO M12x1.75 class-12.9 bolt is used to fasten three members as shown in Fig. Q3. Dimensions are in millimeters. The first member is cast iron, the second is low-carbon steel and the third is aluminum. The static loading safety factor is 2.5. Determine a) Total bolt length, threaded length and threaded length in the joint. (6 pts) b) Bolt and joint stiffness using a 30° cone. (14 pts) c) Preload for permanent connections. (5 pts) d) Maximum static...
An M30 × 3.5 ISO grade 8.8 bolt is used in a joint at a preload level recommended for reused connections, and the joint is subject to a repeated tensile fatigue load of P = 65 kN per bolt. The joint constant is C = 0.25. Determine the static load factors; [12 pts.] The factor of safety guarding against a fatigue failure based on the Goodman fatigue criterion. [18 pts.]
[3]. (3 marks) Figure below shows a bolted joint subjected to an external force P that fluctuates from 0 to 7 kips The steel bolt specification is 5/8"-11 UNC, SAE grade 5 material with rolled threads. The clamped members are steel of length 1.25 in each (with a total length of 2.5 in). Plain wide washers are utilized at both ends of the bolt. [a]. Using the Goodman line, determine the factor of safety guarding against fatigue failure for the...
131- (3 marks) Figure below shows a bolted joint subjected to an external force P that fluctuates from 0 to 7 kips. The steel bolt specification is 5/8"-11 UNC, SAE grade 5 material with rolled threads. The clamped members are steel of length 1.25 in each (with a total length of 2.5 in). Plain wide washers are utilized at both ends of the bolt. [a]. Using the Goodman line, determine the factor of safety guarding against fatigue failure for the...
1. The section of the sealed joint shown in Fig. Q.1 is loaded by P 6.0 kip. The members have E-16 Mps, All bolts have been carefully preloaded to F. 25 kip a. If hardened-steel washers (American Standard, Narrow) are to be used under the head and nut, what length of bolts should be used (round up to the nearest 0.1 in)? (8 pts) b. Find kb, km (using 30° cone) and C. (24 pts) c Using the modifed Goodman...
our professor uses shigley's mechanical engineering
design 9th edition
The section of the sealed joint shown in Fig. Q.1 is loaded by P 6.0 kip. The members have E-16 Mpsi. All bolts have been carefully preloaded to Fi 25 kip each. a. If hardened-steel washers (American Standard, Narrow) are to be used under the head and nut, what length of bolts should be used (round up to the nearest 0.1 in)? (8 pts) b. Find kb, Km (using 30° cone)...