our professor uses shigley's mechanical engineering design 9th edition
our professor uses shigley's mechanical engineering design 9th edition The section of the sealed joint shown in Fig. Q.1 is loaded by P 6.0 kip. The members have E-16 Mpsi. All bolts have been...
1. The section of the sealed joint shown in Fig. Q.1 is loaded by P 6.0 kip. The members have E-16 Mps, All bolts have been carefully preloaded to F. 25 kip a. If hardened-steel washers (American Standard, Narrow) are to be used under the head and nut, what length of bolts should be used (round up to the nearest 0.1 in)? (8 pts) b. Find kb, km (using 30° cone) and C. (24 pts) c Using the modifed Goodman...
T'he section of the sealed joint shown in the figure below is loaded by a repeated force P - 6 kip. The members have E-16 Mpsi. The thread has its was determined as being 2.13 times bolt stiffness. (a) What are the respective values of proof, yield, and ultimate strength of this rolled, and has been carefully preloaded to Fi 25 kip. Joint stiffness bolt material? Show how you determined this. reduced to 5000 lb (assume that the bolt remains...
our professor uses shigley's mechanical engineering design 9th edition 2. A steel plate (Fig. Q.2) is riveted to a vertical pillar. The three rivets have a 15 mm diameter and carry the load and moment resulting from the external load of 8 kN. All length dimensions are in millimeters. The yield strengths of the materials are (Sy)ivet 600 MPa and (Sy)plate 350 MPa. Calculate the safety factors for a. Shear of rivet when Ssy-0.57 Sy (10 pts) Bearing of rivet...