Kindly upvote if it's helpful for you .
A power MOSFET in a DC-DC converter must sustain power loss of 30 W. The device is manufactured in a TO-220 package, wi...
A power MOSFET in a DC-DC converter must sustain power loss of 30 W. The device is manufactured 1. in a TO-220 package, with Ric-1.2 K/W, and Trmax)-150。C. The manufacturer reports that without a heat sink, the approximate value of Ria is 45 K/W. a) Can the power loss value be handled without a heat sink? b) If not, assume Res 1.0 K/W and design a specification for Rso to meet the maximum junction temperature requirement if ambient temperature is...
0 9 A MOSFET is installed on a heat sink as shown in Fig. 2. The junction-to-case thermal resistance and the case-to- sink thermal resistance of the MOSFET are 1.6°C/W and 0.5°C/W respectively. Power loss of the MOSFET is 4W. If the maximum operating temperature of the MOSFET is 60°C and the temperature of the ambient environment is 30°C, calculate the minimum thermal resistance of the heat sink Pe 2
QUESTION 4(Total 12.5 Marks) The switch current and voltage waveforms of a power converter are shown in the next page. The switch has a maximum junction temperature, T,max140°C and a junction-to-case thermal resistance Rc 0.55°C/w (a) How much power is dissipated by the switch? Sketch the power waveform (7.5 marks) (b) The converter operates in an ambient of 25°C and the switch is mounted on a heat sink. Specify the value of thermal resistance of the heat sink, if a...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...