1 Award: 10.00 points used to pump water from one large reservoir to another large reservoir that is at a higher elevat...
14-34 A water pump is used to pump water from one large reservoir to another large reservoir that is at a higher elevation. The free surfaces of both reservoirs are exposed to atmo- spheric pressure, as sketched in Fig. P14-34. The dimen sions and minor loss coefficients are provided in the figure. The pump's performance is approximated by the expres- sion Havailable H av?, where the shutoff head H 40 m of water column, coefficient a = 0.053 m/Lpm?, available...
Q2: The performance data of a water pump follow the curve fit Havailable = Ho-a V2 where the pump's shutoff head Ho = 5.30 m, coefficient a = 0.0453 m/(Lpm)?, the units of pump head Hare meters, and the units of V are liters per minute (Lpm). The pump is used to pump water from one large reservoir to another large reservoir at a higher elevation. The free surfaces of both reservoirs are exposed to atmospheric pressure. The system curve...
Task 1: You were asked to check up the status of the water system. Water at 24 °C is to be pumped from a Lower reservoir with 100 m elevation to another reservoir at a higher elevation 112 m through 150-m-long pipe as shown in Figure (1). The pipe is made of steel, and the diameter of the pipe is equal to 30 cm. Water is to be pumped by a 72% efficient motor-pump combination that draws 33 A of...
A pump is used to deliver water from a large reservoir to another large reservoir that is 20 m higher. The net of the pipe is submerged in the one reservoir and the cat is just above the surface of the other reservoir Part A output of the pump so the fow is 0.7 m /s if the triction head loss in the 200-mm-diameter, 4-km-long pipeline is 25 m for every 500 m of pipe length determine Express your answer...
NO QUESTIONS DURING T Water is to be pumped from a reservoir (ZA30 /s- to another reservoir at a higher elevati rate of elevation (Zn THE EXAM! n) through a long pipe, as shown in the figure at a volume ow olume flow rate has been calculated and is 11 m he head loss in the pipe at this usefuf pump ) Demostrate that wh en a pump moves a fluid from one reservoir to ano e elevation difference between...
4. Water is to be moved from one large reservoir to another a higher elevation as indicated in the Figure. The flow rate, Q=2 ft/s and the head loss hz = 60 where Vis the average velocity. the pump power required 15000 ft.lb/s. Determine the pump head loss hp. Section (2) p=1.94 slugs/ft3 P2 = P1 = V1 = V2 = 0 8-in. inside diameter pipe 50 Ft P2 + v +24thp = Section (1) Pump P2 vž ==+ +...
The performance data of a water pump follow the curve fit H available = H0 - aV˙2Havailable = H0 - aV˙2 where the pump’s shutoff head H0 = 7.6 m, coefficient a = 0.0453 m/(Lpm)2, the units of pump head H are meters, and the units of V˙V˙ are liters per minute (Lpm). The pump is used to pump water from one large reservoir to another large reservoir at a higher elevation. The free surfaces of both reservoirs are exposed...
Q4. A pump draws water from a large reservoir and delivers it to another reservoir whose water surface is 10 m higher than the pump centreline and that the pump is 1.5 meter above the suction reservoir. The total suction and deliver pipe used is 21.1 m in length, 9 cm in diameter and has a Darcy friction factor f0.0339. The pump operates at 750 rpm and its characteristic performances are given in table below: Q (m3 s H (m)15...
4. Water is to be moved from one large reservoir to another a higher elevation as indicated in the V 2 Figure. The flow rate, Q =2 ft/s and the head loss hi = 60 where Vis the average velocity. 2g the pump power required 15000 ft.Ib/s. Determine the pump head loss hp. Section (2) p=1.94 slugs/ft P2 = P1 = V1 = V2 = 0 8-in. inside- diameter pipe 50 ft Section (1) Pump P v + + Z1+...
A 60 horsepower pump is used to move water from a large reservoir to another at a higher elevation. Measured data show that the head loss from station 1 to 2 can be calculated from hloss= cV2 where V is the fluid velocity in the pipeline and c is a constant Calculate the volumetric flow rate, Q, if c=2 s2/ft, d=10 in., h=50 ft , and npump=0.85 h Pump A 60 horsepower pump is used to move water from a...