Question

Description: Install an office signal system with a stenographer's office that can call Bell can call bell "B", and the manager oan call bell "C". The push-buttons are located on the president's desk. Infonnation Usually push-buttons are never connected in serios. However, this is a special circuit were push-buttons "C" are cornectod in series. Specifications; Push-Button "A" controls bell "A" independently. Push-Button "B" controls bell "B" independently. 2. Push-Buttonss "C" must be pressed at the same time to ring bell "C" 3. Procedure I. Connect the hot wire to push-buttons "A", "B" and only one "C". 2 Inter connect both push-buttons C's with a junction wire. 3 Connect the section wire from push-button "A" to bell "A", Connect the section wire from push-button "B to bell "B" Connect the section wire to the remaining terminal of P.B. "C" to bell "C Connect the neutral wire from the remaining terminals of all the bells to the transformer 4 6 Plan Lay-Out BUINAY CDADS BUNAr &'MOAD! BUer A Load' a lau PR.&to 46 PHOATCOnrors Transhaner Questions: 1. Why don't section wires "A" "B" and "C" have splices? 2. What is the definition ofa simple circuit? 3. What is the definition of a parallel circuit? 4. What is the definition ofa series circuit? 5. What is the definition of an independent control circuit?

    questions 1-6

Answer 1

1) The Splices are absent in the section wires as all push Buttons being in series can be Connected with same wire  that do not need to be spliced here.

2) Simple Circuit is defined as the closed loop connection of electric components through which the electric current can flow .

nds w w Series Panallol

3) Parallel Circuit means a circuit in which components are put in between the same two common end points . Parallel Circuit components have same Voltage accross them .

4) Series Circuit means a circuit in which components are joined end to end so that they carry the same amount of current .

5) Independent control circuit is a circuit that have exclusive controlled system or the control system controlling the dedicated load attached with it so that every circuit is controlled by their unique contolller setup .

Example ----->Here every push button circuit (independent contoller  circuit ) contols / Rings its corresponding bell only .