Once a metal ion has become fully hydrated to become a metal hydrate, the resulting complex can exhibit behavior that is characteristic of a: Select the correct answer below:
strong acid
weak acid
strong base
weak base
The resulting complex i.e.if a metal is fully hydrated, metal hydrate is formed. The exact behavior of metal hydride depends on type of M-H bond where M is metal and H is hydride and their electronic properties.
Once a metal ion has become fully hydrated to become a metal hydrate, the resulting complex...
A complex ion is formed from a Lewis acid metal ion bound to Lewis base ligands. Select one: True False
A complex ion is formed from a Lewis acid metal ion bound to Lewis base ligands. Select one: True False In the coordination compound [Zn(NH3)4](NO3)2 the ammonia serves as a counter ion. Select one: True False One way to increase the solubility of Fe(OH)3 is to add nitric acid to the solution. A second way is to add highly concentrated potassium hydroxide. Select one: True False
A complex ion that forms in solution has a structure that: Select the correct answer below: can be determined simply by stoichiometry can be predicted on the basis of electrical charge can only be determined experimentally cannot be determined
10. The formation of complex ions causes the solubility of a slightly soluble solid to: A increase B. decrease C. stay the same D. none of the above 11. The equivalence point of a titration occurs: A. when all of the analyte has been titrated (reacted B. usually just before the endpoint. C. Both A and B D. Neither A or B 12. How does a buffer resist change in pH upon addition of a strong acid? A) The strong...
In the complex ion [ML6]n+, Mn+ has five d electrons and L is a strong field ligand. According to crystal field theory, the magnetic properties of the complex ion correspond to how many unpaired electrons? A. 0 B. 1 C. 2 D. 3 E. 5 Which one of these complex ions would absorb light with the shortest wavelength? A. [Co(H2O)6]2+ B. [Co(NH3)6]2+ C. [CoF6]4– D. [Co(CN)6]4– E. [Co(en)6]2+ The ion [Co(NH3)6]2+ is octahedral and high spin. This complex is (4pts)...
i want answer to all questions please Answer: 29) Consider the following generalized buffer solution equilibrium: When a small amount of a strong base such as sodium hydroxide is added to the solution, which of the four species shown would experience an increase in concentration? A) BH B)H C) HO D)B E None of the species would increase in concentration. Answer: ( 30) What is true about a solution whose pH is less than 7 at 25°C? A) It has...
EQUILIBRIUM OF A METAL COMPLEX ION Part 2: Determination of the Equilibrium Constant 1. Write the balanced chemical equation for the reaction we will be studying in this experiment and its associated equilibrium constant expression. 2. What analytical technique will we be using to measure concentrations? Which species can we measure with this technique? State Beer's Law and define its terms. 3. 4. 5. The following data were collected by a student preparing standards for a Beer's Law plot Discuss...
Dissolution of the Precipitate-Basicity of the Anion Phosphate ion, the conjugate base of HPO is one example of an anion of a weak acid. In solution, we can expect phosphate to do two things: Accept an Hion, as well as form precipitates with metal cations such as Fe. These two reactions are shown below: PO. (ag) + H (ap) HPO. (ag) K, for (HPO ) = 4.8 x 10" FePO.(1) Fe (my) + PO. (a) K = 1.3 x 10"...
2. Calculate the concentration of one liter of the resulting calcium chloride solution (assuming you started with 102.7 mg of calcium carbonate) in units of molar and millimolar. Also calculate the concentration in “parts-per-million as CaCO3”. (Refer to section 13.5 of your textbook, if needed.) a. If a standard Ca2+ solution is 100 ppm and 50 mL of solution is used for the standardization, calculate the approximate volume of 2.5 mM EDTA4- solution needed to reach the end point of...
1. Rank the solutions in order of decreasing [H3O+]: 0.10 M HF, 0.10 M HCl, 0.10 M HClO, 0.10 M HC6H5O. 2. The beaker will be filled to the 0.50 L mark with a neutral solution. Set the pH to 3.95 by using the green arrows adjacent to the pH value indicated on the probe in the solution. Once you adjust the pH, note the corresponding OH− ion concentration in M as given in the graphic on the left side...