Consider the following experimental system: 1. Three squared plates with cross section of 150 mm and...
Three plates are joined with a 12 mm diameter pin as shown. Determine the maximum load P that can be transmitted by the joint if:(a)The maximum normal stress on a cross-section of the plates at the pin must not exceed 372 MPa.(b)The maximum bearing stress between a plate and the pin must not exceed 612 MPa.(c)The maximum shear stress on a cross-section of the pin must not exceed 268 MPa.(d)The punching shear resistance of the material in the top and...
Indicate whether the following experimental mistake will increase, decrease, or have no effect on the calculated value of R. A student completed the experiment without waiting for the test tube to cool after heating. Select ALL of the correct answers. a. All measurements should be made at the same temperature. b. The volume measured from the beaker will be high. c. The measured temperature is room temperature. d. The calculated value of Ris low. e. The calculated value of Ris...
can you write a conclusion for the report? Thermal Conductivity Lab Introduction The objective of this lab is to explore the thermal conductivity of various materials using Fourier’s Law and a steady state system. Certain materials are more effective heat conductors than others. The effectiveness of a given material at heat conduction is influenced by many factors, including density, molecular structure, and chemical composition. Fourier’s Law takes these factors into account to calculate Q, or the joules per second rate...
Please summarise the following content:(no word limit) EXPERIMENTAL PROCEDURES Animals All animals including pregnant ICR mice, neonatal Wistar rats, and NOD-SCID mice (8 weeks old, male) were purchased from CLEA Japan (Tokyo). All exper- imental procedures and protocols were approved by the Animal Care and Use Committee of Keio University and conformed to the National Institutes of Health Guide for the Care and Use of Laboratory Animals. Cells Mouse ESCs were obtained from the Laboratory of Pluripotent Cell Studies, RIKEN...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...