Question

2. Using the dilution equation (Eq. 3), calculate the concentration of the three Fe) standards that will be prepared 3. What

i need answers to all 3 of them
0 0
Add a comment Improve this question Transcribed image text
Answer #1

Question 2.

Here, the data (Eq. 3) is not given.

Question 3.

Here also, the data (procedure for the preparation of extracted iron) is not given. Anyhow, conceptually, when a solution is diluted, its molarity will obviously decrease because of molarity = no. of moles/volume of solution.

Question 3.

Here also the data (Eq. 1) is not given. Anyhow, conceptually higher the reduction potential of an electrode, the corresponding electrode will undergo reduction, whereas lower the reduction potential, the corresponding electrode will undergo oxidation.

Add a comment
Know the answer?
Add Answer to:
i need answers to all 3 of them 2. Using the dilution equation (Eq. 3), calculate...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Table A. Preparation of Standard solutions of FeSCN2+ 1.0 M HNO3 0.002 M 0.200 M Solution...

    Table A. Preparation of Standard solutions of FeSCN2+ 1.0 M HNO3 0.002 M 0.200 M Solution KSCN (mL) Fe(NO3)3 (mL) 0.5 5 [FeSCN2+] (mol/L)* 1 4.0x10^-5 Add 1.0 M 2 1.0 5 8.0x10^-5 HNO3 3 1.5 5 1.2x10^-10 4 2.0 5 1.6x10-4 to each to adjust the volume to 25 mL. 5 2.5 5 2.0x10-4 * Calculate the concentrations of FeSCN2+ in each beaker, assuming that all SCN-ions exist as FeSCN2+. In other words, [FeSCN2+] (in Soln 1) = [SCN-]...

  • I need the answers for page 2 and three do not pay attention to the first...

    I need the answers for page 2 and three do not pay attention to the first page! EXPERIMENT 10: DETERMINATION OF THE ELECTROCHEMICAL SERIES QUESTIONS Which metal was not oxidized by any of the other half-cells? 1. Using Table 1, what are two metal half-cells that would oxidize the metal from question #1? 2 3. Which metal was oxidized by all of the other half-cells? 4. Using Table 1, what are two metal half-cells that the metal from question #3...

  • Please I need Answers for ALL THESE QUESTIONS with explanation 2 A solution containing 52.4 mg/100ml...

    Please I need Answers for ALL THESE QUESTIONS with explanation 2 A solution containing 52.4 mg/100ml of B (335 g/mole) has a transmittance of 45.2% in a 1.0 cm cell at 400nm. Calculate the "ABSORPTIVITY" of "B" at this wavelength Inna m L v inole -,.С/.x103 i-moll A Iron is treated with excess color 3.A 2.5ml aliquot of a solution containing 7.9ppm reagent to give a colored "Complex-product"; this was then diluted to 50ml with buffer. is 7,000 L/Mol/cm、.rm /つのフ...

  • please I need answers to all these questions! Name 3 HW Electrochemistry Submit before Nov 20,...

    please I need answers to all these questions! Name 3 HW Electrochemistry Submit before Nov 20, 2019 at 12 PM D2L Submission: Submit one file containing all calculations and the original paper Assessments Assign ments HW Electrochemistry 1) Which two of the following half-reactions will combine to give the galvanic cell with the highest cell potential? Reduction Half-Reaction E (V) Metal Al3+ 3e- Al(s) Aluminum -1.66 Mn + 2e Mn(s) - 1.18 Manganese Zn 2e Zinc Zn(s) -0.76 Cr3 Зе-...

  • the guiding questions. the max absorbance is 460. Guiding questions complex turque . Compare the molar...

    the guiding questions. the max absorbance is 460. Guiding questions complex turque . Compare the molar absorptivity coefficients you obtained with SCN and Fe" as limiting reagents. Would you expect them to be the same? Why or why not? (Week 1) • The accepted molar absorptivity coefficient for FeSCN is 7.0x10' M'cm''. Find the bias and relative bias of your values and suggest possible sources of errors. (Week 1) • Which molar absorptivity coefficient will you use to calculate the...

  • just need help with questions 3. a & b always rate!!! Introduction Titration is a common...

    just need help with questions 3. a & b always rate!!! Introduction Titration is a common analytical technique that is used to verify the concentrations of chemicals before they are sold as commercial products, in a process known as quality control. In this lab, you will be using a redox titration to find the concentration of the strong oxidizing agent hypochlorite (CIO) which is the active ingredient in bleach. Oxidizing and reducing agents are often determined using a redox titration....

  • Hi, can anyone please help me with this? i have no clue how to define if...

    Hi, can anyone please help me with this? i have no clue how to define if a reaction is Oxidation reduction or not. Thanks a lot OXIDATION-REDUCTION Introduction Chemists refer to reactions which involve a transfer of electrons from one reactant to another as oxidation reduction reactions of just "redox" reactions. Oxidation is defined as a loss of electron and reduction as a gain of electron by a substance during a chemical reaction. The loss of electrons by one substance...

  • Can you answer question 4 & 5? The experiment and porcedure is posted below Question 4...

    Can you answer question 4 & 5? The experiment and porcedure is posted below Question 4 & 5 CHM3120C Analytical Chemistry Lab Lab 7. Spectrophotometric Determination of Iron in Mohr's Salt with o-Phenanthroline Required Reagents and Supplies: 50 mL of 0.0005M -0.0006 M of Mohr's solution (unknown), 10 g of Hydroxylamine hydrochloride (NH2OH, HCI), 500 mL of o-phenanthroline solution (contains 0.5 g of o-phenanthroline monohydrate), 83 g of sodium acetate (NaOAc. 3H20) in 500 mL of water (for 1.2 M...

  • What is the purpose of the acid added in the beginning of the experiment? CHM3120C Analytical...

    What is the purpose of the acid added in the beginning of the experiment? CHM3120C Analytical Chemistry Lab Lab 7. Spectrophotometric Determination of Iron in Mole's Salt with e-Phenanthroline Required Reagents and Supplies 50 mL of 0.0005 -0.0006 M of Moher's solution unknown. 10 of Hydroxylamine hydrochloride (NH2OH, HCT, 500 ml of phenantholine solution contains 05 of-phenanthroine monohydrate). 83 g of sodium acetate (NOAC3H20) in 500 ml of water (for 1.2 M of phl 5 buffer som minimum 3 of...

  • need help with the Molarity of both parts EXPERIMENT 8: AN OXIDATION-REDUCTION TITRATION DATA SHEET 0.2M...

    need help with the Molarity of both parts EXPERIMENT 8: AN OXIDATION-REDUCTION TITRATION DATA SHEET 0.2M 10 m2 Concentration of original KMnO solution Volume of Original KMnO4 solution used Molarity of KNOWN HOCg04 D.ISOM Standardization of KMnO solution. Sample 3 Sample 1 Volume H2C204 11.00ML Initial buret reading (KMnO4) .00 mc Final buret reading (KMnO4) 12.00ML Volume KMnO4 12.00ml Molarity KMnO4 Average (KMnO4) Sample 2 4:00ML 12.00mL 13.5ML . SOL Determination of Unknown Solution Sample 3 Sample 1 4ml Volume...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT