Homework Answers
Q.no (a) ,and (b) are solved given below:-
Add Answer to:
TO 2, the signal m(t) 20 sinc ( 400't) is an input to a ring modulator...
the message signal input to the modulator is given as x(t)=4cos(2pi*10^4t) and the carrier Xc(t)=10cos(pi*10^8t) if...
the message signal input to the modulator is given as x(t)=4cos(2pi*10^4t) and the carrier Xc(t)=10cos(pi*10^8t) if freq modulation is performed with freq sensitivity as being kf=1000pi verify that the modulated signal Meets the criteria for being narrow band FM also obtain an expression for the modulated signal and its spectrum sketch the spectrum
The sinusoidal modulating wave is applied to a phase modulator with phase sensitivity kp. The unmodulated carrier wave has frequency fc and amplitude Ac. a) Determine the spectrum of the resulting ph...
The sinusoidal modulating wave is applied to a phase modulator with phase sensitivity kp. The unmodulated carrier wave has frequency fc and amplitude Ac. a) Determine the spectrum of the resulting phase-modulated signal, assuming that the maximum phase deviationP4es not exceed 0.3 radians. b) Construct a phasor diagram for this modulated signal, and compare it with that of the corresponding narrow-band FM signal.
The sinusoidal modulating wave is applied to a phase modulator with phase sensitivity kp. The unmodulated carrier...
stion 2) [20 marks] Switching modulator is used to generate a modulated signal s(t) Assume m(t)...
stion 2) [20 marks] Switching modulator is used to generate a modulated signal s(t) Assume m(t) = 4πcos(Zhoot) and c(t) = 32cos(2m10,000t) i. [1 marks] What type of modulation can the above modulator generate? ii. [3 marks] Draw a block diagram of the switching modulator. iii. [1 marks] Find the bandwidth of m(t) iv. [3 marks] Sketch the spectrum of s(t), then find its bandwidth. v. [2 marks] Is the transmission over modulated? Explain. vi. 12 marks] Modi fy the...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f ar...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f are kf = 105, kp-25 respectively. 108 Hz, and frequency and phase deviation constants Find the maximum and minimum frequency deviation for FM, and sketch the FM wave for a duration of 103 seconds shown in the above figure (5 points). a. b. Find the maximum and minimum frequency deviation for PM, sketch the PM wave for a duration of 103 seconds shown...
4. (20%) An AM modulator operates with the message signal m(t) - 9 cos(207t)-8 cos(60!). The unmodulated carrier is...
4. (20%) An AM modulator operates with the message signal m(t) - 9 cos(207t)-8 cos(60!). The unmodulated carrier is given by 110 cos 200r), and the system operates with an index of 0.8. (10%) (a) Given that the minimum value ofm(t) is-12.9, write the equation for m, (t). and determine the power of m,(r) (i.e.. m,())) (b) Determine the efficiency of the modulator 5%) (500) (c) Sketch the double-sided spectrum of the modulator output AM signal.
4. (20%) An AM...
Consider the message signal m(t) = 20 sin c(40nt) and the carrier signal c(t) = 4...
Consider the message signal m(t) = 20 sin c(40nt) and the carrier signal c(t) = 4 cos(2007t). Sketch the spectrum and write the frequency-domain and time- domain expressions for a VSB modulated signal with a VSB filter characteristic as shown below. Note that Hyse (f)=(f -85)/30 for 85<f<115. Hys(f) A 0 85 100 115 130 f
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amp...
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amplitude spectrum, SPM(f), is shown below: Amplitude spectrum of the frequency modulated signal 2 -2 5000 4000 3000 2000 -1000 1000 2000 3000 4000 5000 frequency f [Hz] a) What is the carrier frequency fe? b) What is the message frequency fm c) What is the FM modulation index Bf? Is it a narrowband or a wideband signal? d) Using Carson's rule, estimate the transmission...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(t) (Hint. sin(a) cos(b) 0.5 sin(a +b) +0.5sin a-b)) b. Sketch the spectrum of DSB-CS signal m(t)cos(10000mt) C ldentify the upper sideband {USB) and lower sideband (LSB) spectra d. Give the black diagram of the receiver to receive DSB-CS signal in (b). 2. baseband signal m(r)--0.5 + Σ..小(t-n)-u(t-0.5-n)] where ult) is the Given unit step function, an amplitude modulated signal is as SAM 107+ m(0cos...
[15 points] You are asked to design a DSB-SC AM modulator to generate a modulated signal km(t)cos...
[15 points] You are asked to design a DSB-SC AM modulator to generate a modulated signal km(t)cos(wt+0), where m(t) is a signal band-limited to B Hz. The following figure shows a DSB- SC AM modulator available in the stockroom. The carrier generator available generates not cos(wct), but cos (wct). Explain whether you would be able to generate the desired signal using only this equipment. You may use any kind of filter you like. 3. What kind of filter is required...
In a coherent detection process, a sinusoidally modulated DSB-SC wave, s(t) = c(t)m(t) where the carrier...
In a coherent detection process, a sinusoidally modulated DSB-SC wave, s(t) = c(t)m(t) where the carrier wave is c(t) =Accos(2πfct) and the message signal is m(t) = Amcos(2πfmt), is applied to a product modulator using a locally generated sinusoid of Ac’ amplitude and is out of phase by φ with respect to the sinusoidal carrier used in the modulation. (a) Draw the block diagram of the coherent detection process and label the block diagram with the information provided above accordingly....
The sinusoidal modulating wave is applied to a phase modulator with phase sensitivity kp. The unmodulated carrier wave has frequency fc and amplitude Ac. a) Determine the spectrum of the resulting phase-modulated signal, assuming that the maximum phase deviationP4es not exceed 0.3 radians. b) Construct a phasor diagram for this modulated signal, and compare it with that of the corresponding narrow-band FM signal.
The sinusoidal modulating wave is applied to a phase modulator with phase sensitivity kp. The unmodulated carrier...
stion 2) [20 marks] Switching modulator is used to generate a modulated signal s(t) Assume m(t) = 4πcos(Zhoot) and c(t) = 32cos(2m10,000t) i. [1 marks] What type of modulation can the above modulator generate? ii. [3 marks] Draw a block diagram of the switching modulator. iii. [1 marks] Find the bandwidth of m(t) iv. [3 marks] Sketch the spectrum of s(t), then find its bandwidth. v. [2 marks] Is the transmission over modulated? Explain. vi. 12 marks] Modi fy the...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f are kf = 105, kp-25 respectively. 108 Hz, and frequency and phase deviation constants Find the maximum and minimum frequency deviation for FM, and sketch the FM wave for a duration of 103 seconds shown in the above figure (5 points). a. b. Find the maximum and minimum frequency deviation for PM, sketch the PM wave for a duration of 103 seconds shown...
4. (20%) An AM modulator operates with the message signal m(t) - 9 cos(207t)-8 cos(60!). The unmodulated carrier is given by 110 cos 200r), and the system operates with an index of 0.8. (10%) (a) Given that the minimum value ofm(t) is-12.9, write the equation for m, (t). and determine the power of m,(r) (i.e.. m,())) (b) Determine the efficiency of the modulator 5%) (500) (c) Sketch the double-sided spectrum of the modulator output AM signal.
4. (20%) An AM...
Consider the message signal m(t) = 20 sin c(40nt) and the carrier signal c(t) = 4 cos(2007t). Sketch the spectrum and write the frequency-domain and time- domain expressions for a VSB modulated signal with a VSB filter characteristic as shown below. Note that Hyse (f)=(f -85)/30 for 85<f<115. Hys(f) A 0 85 100 115 130 f
Question 4: (20 points) An FM signal is modulated with message m(t)Am cos(2Tmt). The measured amplitude spectrum, SPM(f), is shown below: Amplitude spectrum of the frequency modulated signal 2 -2 5000 4000 3000 2000 -1000 1000 2000 3000 4000 5000 frequency f [Hz] a) What is the carrier frequency fe? b) What is the message frequency fm c) What is the FM modulation index Bf? Is it a narrowband or a wideband signal? d) Using Carson's rule, estimate the transmission...
1. Given a baseband signal m(t) sin(1000mt) cos(3000nt) + cos(3700nt a. Sketch the spectrum of m(t) (Hint. sin(a) cos(b) 0.5 sin(a +b) +0.5sin a-b)) b. Sketch the spectrum of DSB-CS signal m(t)cos(10000mt) C ldentify the upper sideband {USB) and lower sideband (LSB) spectra d. Give the black diagram of the receiver to receive DSB-CS signal in (b). 2. baseband signal m(r)--0.5 + Σ..小(t-n)-u(t-0.5-n)] where ult) is the Given unit step function, an amplitude modulated signal is as SAM 107+ m(0cos...
[15 points] You are asked to design a DSB-SC AM modulator to generate a modulated signal km(t)cos(wt+0), where m(t) is a signal band-limited to B Hz. The following figure shows a DSB- SC AM modulator available in the stockroom. The carrier generator available generates not cos(wct), but cos (wct). Explain whether you would be able to generate the desired signal using only this equipment. You may use any kind of filter you like. 3. What kind of filter is required...
Most questions answered within 3 hours.
-
In a performance test, each of two cars takes 8.9 s to
accelerate from rest to...
asked 1 minute from now -
Sapphire Aerospace operates 52 weeks per year, and its cost of
goods sold last year was...
asked 1 minute ago -
A. Suppose your manager indicates that for a normally
distributed data set you are analyzing, your...
asked 2 minutes ago -
For each the following molecules draw the best possible
structure based on formal charges for each...
asked 2 minutes ago -
A proton moves in the plane of this paper toward the top of the
page. A...
asked 12 minutes ago -
different divisions differing lines of business use
different costs of capital because their cost of equity...
asked 8 minutes ago -
Give an algorithm to determine whether or not the elements
of
an array of integers are...
asked 15 minutes ago -
. Gravimetric analysis. The gravimetric analysis that we will
perform in lab occurs according to the...
asked 34 minutes ago -
Learning curve problem:
A company was ordered to make 6 custom made parts. the labor
costs...
asked 31 minutes ago -
When you don’t recall operator precedences you can Guess
Experiment with the compiler Look in a...
asked 34 minutes ago -
GST – Complex issues:
Instructions: The following case study is related to complex tax
issues. You...
asked 38 minutes ago -
We are evaluating a project that costs $836,117, has an
eight-year life, and has no salvage...
asked 37 minutes ago