Create blocks for the given revision block formats. The dimensions within the dimension li...

Create blocks for the given revision block formats. The dimensions within the dimension lines are inches; the dimensions within the brackets are millimeters.

Design a shape that will support the hole patterns shown in Exercises through. Design for a minimum amount of material and to satisfy the following parameters:

1. The edge distance of the material may be no closer to the center of a hole than a distance equal to the radius of the hole.

2. The minimum edge distance from any internal cutout to the edge of the part may be no less than the distance calculated in step 1.

3. The minimum inside radius for a cutout is 5 millimeters, or 0.125 inch.