Homework Answers
SOLUTION : According to the question,
The pressure at any point in a container depends only on the depth of that point from the surface but not on the shape of the container.
Pressure = (density of liquid)* (acceleration due to gravity)*(depth from surface to that point)
P = 
*g*h
As every point A,B,C and D are located at depth "h" from surface of those given containers, so pressure at those points are also same.
Hence OPTION -E is correct answer.
Add Answer to:
Q1. (5 points) Fluid fills the container shown in the figure. At which of the indicated...
Question 5 (2 points) In the U-tube below, the density of the fluid that fills the...
Question 5 (2 points) In the U-tube below, the density of the fluid that fills the upper part of the left-hand portion is 831 kg/m3. The density of the fluid that fills the right-hand portion is unknown. PA PB Th3 The heights of three different sections as labeled on the diagram are h1 = 7.0 cm, ha = 3.0, cm and h3 = 5.0 cm, respectively. The density of the fluid on the right side of the U-tube is most...
OBJECT 12. Consider an object fully submersed in fluid as shown in the figure. Based on...
OBJECT 12. Consider an object fully submersed in fluid as shown in the figure. Based on our discussion of Archimedes' Principle, which of the conditions below would cause the object to experience a downward acceleration? a. Pfluid > Pobject b. Pfluid = Pobject C. Pfluid Pobject d. None of the above; the object's acceleration is not dependent on relative density between the fluid and the object. 13. A friend of yours, who also happens to be a professional ballerina, hears...
please help ?? a) As shown in the Figure below, a fluid flows down an inclined...
please help ??
a) As shown in the Figure below, a fluid flows down an inclined surface. Show that the velocity distribution of that fluid is u=[pgsin0/(2)]/(2hy - y²)) by using Navier-Stokes equations. (Show assumptions that you make and every each step) [13 points) b) Laminar viscous flow between two parallel plates are shown in the figure below. Both bottom plate and top plate moving in the same direction, their velocities are U,Ut respectively and they are not equal to...
The fluid domain shown in Figure A6 has a gap width of into the paper. If...
The fluid domain shown in Figure A6 has a gap width of into the paper. If the general form of the velocity profile is given by 1 u(y) = Op2 2ur Then a) Show that the specific profile is given by Uy + Op 2 u(y) [5 marks] b) Find the shear stress if the fluid is Newtonian [5 marks] c) Evaluate the average velocity. [5 marks d) Sketch the velocity profile in the domain when the pressure gradient is...
laser region is shown in the figure in the fluid is helium at 20 C and...
laser region is shown in the figure in the fluid is helium at 20 C and I am and it 108 ms and som T-20°C loto 4-10 8mo What is the maximum velocity? Show it on the figure? (5 points) - Is the trud 2-Dor 3-D? Explain your rational. (5 points) c) What is the velocity of the fluid at the wall? (5 points) d) Estimate the wall shear stress, Twin Pa (10 points) e Find the position in the...
Q1(a) Show whether the following structures shown in Figure Q1(a) and Q1(b) are structurally stable. (5...
Q1(a) Show whether the following structures shown in Figure Q1(a) and Q1(b) are structurally stable. (5 marks) (b) Determine the determinacy of each structure. (5 marks) Figure Q1(a) Figure Q1(b)
A container is filled with water and the pressure at the bottom of the container is...
A container is filled with water and the pressure at the bottom of the container is P. Then the container is emptied halfway and topped off with oil of density 800 kg/m3, which floats on top of the water. What is the pressure at the bottom of the container now? A) A pressure > P B) The same pressure P C) A pressure < P D) This is not possible to answer with the information given 4. A camper heats...
fluid mechanics E (a) (b) (c) (d) The four devices shown in Figure rest on frictionless...
fluid mechanics
E (a) (b) (c) (d) The four devices shown in Figure rest on frictionless wheels, are restricted to move in the x direction only, and are initially held stationary. The pressure at the inlets and outlets of each is atmospheric, and the flow is incompressible. The contents of each device is not known. When released, which devices will move to the right and which to the left? Please draw control volume and explain!!! This question will not be...
The system shown in Figure Q1 consists of a crank lever AOD, 3 pulleys and container...
The system shown in Figure Q1 consists of a crank lever AOD, 3 pulleys and container fill-up with mass of 30 kg attached with in-elastic cable. If all the viscous dampers are ignored, calculate the natural frequency of oscillation of the system when the crank lever is displaced with a small angular displacement and released. Take point A as point of transfer. к Given:- KA с 0.2 m 0 = 0.1 B Pulley 3 K=2 kN/m C=0 Ns/m Mass of...
fluid mechanics please fast 1. (15 points) Water (p-1g/cm) is flowing in pipes shown in Figure...
fluid mechanics please fast
1. (15 points) Water (p-1g/cm) is flowing in pipes shown in Figure below. Use Bernoull's equation to calculate velocity of water at point B. - Fluid velocity in the large diameter pipe is 1m/s. - Pressure at point 2 is measured with U-tube mercury manometer (Pmercury-13,600kg/m) - h1-0.3m, h2-6cm - assume that the acceleration gravity g-10m/s 2 Manometer shows 0.7kPa pressure Ji h1
Question 5 (2 points) In the U-tube below, the density of the fluid that fills the upper part of the left-hand portion is 831 kg/m3. The density of the fluid that fills the right-hand portion is unknown. PA PB Th3 The heights of three different sections as labeled on the diagram are h1 = 7.0 cm, ha = 3.0, cm and h3 = 5.0 cm, respectively. The density of the fluid on the right side of the U-tube is most...
OBJECT 12. Consider an object fully submersed in fluid as shown in the figure. Based on our discussion of Archimedes' Principle, which of the conditions below would cause the object to experience a downward acceleration? a. Pfluid > Pobject b. Pfluid = Pobject C. Pfluid Pobject d. None of the above; the object's acceleration is not dependent on relative density between the fluid and the object. 13. A friend of yours, who also happens to be a professional ballerina, hears...
please help ??
a) As shown in the Figure below, a fluid flows down an inclined surface. Show that the velocity distribution of that fluid is u=[pgsin0/(2)]/(2hy - y²)) by using Navier-Stokes equations. (Show assumptions that you make and every each step) [13 points) b) Laminar viscous flow between two parallel plates are shown in the figure below. Both bottom plate and top plate moving in the same direction, their velocities are U,Ut respectively and they are not equal to...
The fluid domain shown in Figure A6 has a gap width of into the paper. If the general form of the velocity profile is given by 1 u(y) = Op2 2ur Then a) Show that the specific profile is given by Uy + Op 2 u(y) [5 marks] b) Find the shear stress if the fluid is Newtonian [5 marks] c) Evaluate the average velocity. [5 marks d) Sketch the velocity profile in the domain when the pressure gradient is...
laser region is shown in the figure in the fluid is helium at 20 C and I am and it 108 ms and som T-20°C loto 4-10 8mo What is the maximum velocity? Show it on the figure? (5 points) - Is the trud 2-Dor 3-D? Explain your rational. (5 points) c) What is the velocity of the fluid at the wall? (5 points) d) Estimate the wall shear stress, Twin Pa (10 points) e Find the position in the...
Q1(a) Show whether the following structures shown in Figure Q1(a) and Q1(b) are structurally stable. (5 marks) (b) Determine the determinacy of each structure. (5 marks) Figure Q1(a) Figure Q1(b)
fluid mechanics
E (a) (b) (c) (d) The four devices shown in Figure rest on frictionless wheels, are restricted to move in the x direction only, and are initially held stationary. The pressure at the inlets and outlets of each is atmospheric, and the flow is incompressible. The contents of each device is not known. When released, which devices will move to the right and which to the left? Please draw control volume and explain!!! This question will not be...
The system shown in Figure Q1 consists of a crank lever AOD, 3 pulleys and container fill-up with mass of 30 kg attached with in-elastic cable. If all the viscous dampers are ignored, calculate the natural frequency of oscillation of the system when the crank lever is displaced with a small angular displacement and released. Take point A as point of transfer. к Given:- KA с 0.2 m 0 = 0.1 B Pulley 3 K=2 kN/m C=0 Ns/m Mass of...
fluid mechanics please fast
1. (15 points) Water (p-1g/cm) is flowing in pipes shown in Figure below. Use Bernoull's equation to calculate velocity of water at point B. - Fluid velocity in the large diameter pipe is 1m/s. - Pressure at point 2 is measured with U-tube mercury manometer (Pmercury-13,600kg/m) - h1-0.3m, h2-6cm - assume that the acceleration gravity g-10m/s 2 Manometer shows 0.7kPa pressure Ji h1
Most questions answered within 3 hours.
-
EXPLAIN HOW NEGATIVE AFFECTIVITY IS RELATED TO JOB SATISFACTION.
INCLUDE AN EXAMPLE. MUST BE ANSWERED TWO...
asked 13 minutes ago -
On December 31, 2019, Lincoln Inc. sold a used industrial crane
for $660,000 cash. The original...
asked 1 hour ago -
a runner jogs 3.4 miles every morning. how many kilometers does
this represent
asked 1 hour ago -
A 60.80 gram sample of iron (with a heat capacity of 0.450
J/g◦C) is heated to...
asked 1 hour ago -
Question 1 2 pts
The preprocessor executes after the compiler.
False
True
Question 2 2 pts...
asked 2 hours ago -
Explain how a spinal cord injury above C3 could result in a
respiratory arrest
asked 2 hours ago -
You are a statistician and wish to estimate, with 90%
confidence, the proportion of adults who...
asked 5 hours ago -
A man is standing 3.40 m in front of a convex spherical mirror
of radius of...
asked 5 hours ago -
Match the annual percentage rate to each of these trade credit
terms:
__ 1/5, NET 60...
asked 5 hours ago -
ORGANIC CHEMISTRY QUESTION 5
PART A--------
Describe a chemical test for the identification of a double...
asked 9 hours ago -
Both Terence and Tong work at a local actuarial consulting firm
in Des Moines.
Terence arrives...
asked 9 hours ago -
QUESTION 11
. THE RESTING POTENTIAL IS CAUSED BY
.
. A.
. the rotation of...
asked 9 hours ago