Question
Please answer the bonus mark

Trent Introductory Physics Lab Kirchhoffs Circuit Lawa and Equv Resistors connected in parallel, I1 1 multimeter I Measuring the equivalent resistance, Rniz Calculating the equivalent resistance, R2 Gombine R, and R in paralel and measure the equivalent resistance, Ruilam Rma measured 25o Now calculate RAla.cae, using your individual measured actual resistances of Ra and Ra Ralacak calculated = [44-2% , Repeat this parallel resistance measurement and calculation with Rc and R Retinmea, measured = Ronca k calculated-l e +Apr-1-133.37 ,Agi)-、 For a bonus mark, calculate &R when R RA, R Re. No help will be given. Hint: step 1. z-1.So ne Rul δ(1/x + 1/y) fe(1/x))2+(6(1/y))2 (Addition Rule) Hint: step 2, Hint: step 3. let w=倫惴) then (\)-ari and, from above, 6(1/Rat 1/RB) (1/RA +1/RB) then-RallB.meas-6([1/Ra+ 1/Rel-1)ー Step 4, Final step. = RAİB.meas- [1/RA + 1/RoTĩ δRABmeas RA Bernas ± (The Rule)
0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
Please answer the bonus mark Trent Introductory Physics Lab Kirchhoff's Circuit Lawa and Equv Resistors connected...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Please what the answer for these two questions!? I attached the data rent Introductory Physics Lab...

    Please what the answer for these two questions!? I attached the data rent Introductory Physics Lab Kirchhoff's Circuit Lawas and Equivalent The multimeter manual specifies measurementermanual specifies that the relative uncertainty is 0.5% for any Recall that if Calculate the absolute uncertainty () and (o)2 for each component in table 1 then, by the o uncertainty propagation addition rule. (last column in the table) Table 1, Measured voltages from the circuit for the study of Kirchhoff's Voltage Law uncertainty calculations...

  • Please solve the pre-lab х + Launch Meeting - Zoom В6 yi ilаа Х Online Lab...

    Please solve the pre-lab х + Launch Meeting - Zoom В6 yi ilаа Х Online Lab - 193-EE-204-52(Fun X webdav/pid-1183350-dt-content-rid-11108302 1/courses/193-EE-204-merged-rakan/EE204_Lab_Manual.pdf Fundamentals of Electrical Circuits Laboratory Manual 204 Experiment No. 4 Current and Voltage Divider Rules Objective: To experimentally verify the Current Divider Rule (CDR) for parallel circuits and the voltage divider rule for series circuits. Pre-Lab Assignment: For the circuit shown in Figure 1 and Figure 2, calculate: 1. The unknown voltages and currents shown. Vs=10V. 2- The equivalent...

  • can you help me answer question #6 please the first circuit was series the second circuit...

    can you help me answer question #6 please the first circuit was series the second circuit was parallel and the third circuit was both thank you 4) Calculate the EXPECTED voltage through each resistor for each of the circuits (#1, 2) in PART II from the total current and the equivalent resistance. Calculate %error for one your measurements based on the calculated value from this question. 5) Calculate the EXPECTED current THROUGH EACH RESISITOR for each of the circuits (#1,...

  • Answer 4 & 5 please! thank you! R values = Resistor value, R1 = 990 Ohms...

    Answer 4 & 5 please! thank you! R values = Resistor value, R1 = 990 Ohms Resistor value, R2 = 2050 Ohms 4. Connect the 2nd resistor in parallel with the 1st resistor and connect that combination to the battery.          Measure the following:               The current passing through the R1, I1 = ___0.0058____ A               The current passing through the R2, I2 = ___0.0031____ A               The current supplied by the battery, I = ___0.0092____ A              Calculate I1 + I2 =...

  • Pease answer questions 4 and 5! Thank you so much! 4. Connect the 2nd resistor in...

    Pease answer questions 4 and 5! Thank you so much! 4. Connect the 2nd resistor in parallel with the 1st resistor and connect that combination to the battery.          Measure the following:               The current passing through the R1, I1 = ___0.0058____ A               The current passing through the R2, I2 = ___0.0031____ A               The current supplied by the battery, I = ___0.0092____ A              Calculate I1 + I2 = ____________ A                     Is the following statement true? I = I1 +...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT