Question

Interactive Exercises 4.03: Position and Velocity in Two Dimensions (Space Debris) In a far off galaxy, space debris is blasted into very small (and hence harmless) fragments by means of explosive torpedoes that are fired from special guns. An engineer is to program two such guns to destroy a large asteroid in an interplanetary region-where the effects of gravity are negligible. The first gun is at the origin of an ry coordinate system, as shown in the simulation (linked below). The coordinates of the asteroid are also shown in the simulation. ▼ Question 1 At what angle θ, measured in degrees counterclockwise from the +x axis, should the gun at the origin (gun #1) be aimed if its torpedo is to strike the asteroid? Note: Because there is no gravity (or anything else) to affect the motion of the torpedo, it travels at constant velocity from the moment it leaves the gun until it strikes something. Run the animation now the tolerance is +/-296 By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: o of s used SAVE FOR LATER SUBMIT ANSWER SUBMIT ANSWER Question 2 With what speed must the torpedo be fired from gun #1 if it is to reach the asteroid 5.00 seconds after it is fired? m/s the tolerance is +/-2% By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: 0 of s used SAVE FOR LATER SUBHIT ANSWER SUBMIT ANSWER

Question 3 At3.50s, what is the x component of the torpedos velocity? m/s the tolerance is +-2% By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor. Attempts: 0 of 5 used SAVE FOR LATER SUBMIT ANSWER Question 4 At3.50s, what is the torpedos x coordinate? the tolerance is +-2% By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor. Attempts: 0 of 5 used SAVE FOR LATER SUBMIT ANSWER Question 5 Suppose gun #2 s fixed in position on they axis at y m t can fire a torped in the + r direction at the same speed as gun must you wait to fire gun #2 if you desire for the two torpedoes to reach the asteroid at the same instant? rou program gu··to fire sto ped at how long the tolerance is +/-2%

Atdelay 0.000 Show Both Torpedoes Asteroid : 100 m 150 m Motion in Two Dimensions with Constant Velocity In a far off galaxy, space debris is blasted into very small (and hence harmless) fragments by means of explosive torpedoes that are fired from special guns. An engineer is to program two such

guns to destroy a large asteroid in an interplanetary region-where the effects of gravity are negligible. The first gun is at the origin of an xy coordinate system, as shown in this graphic. The coordinates of the asteroid are also shown in the graphic. When the animation runs, the first gun is fired and the torpedo travels toward the asteroid. When the option Show Both Torpedoes is selected, a second torpedo is fired from the y axis with a delay from the first torpedo set by the slider labeled Δ1delay.

0 0
Add a comment Improve this question Transcribed image text
Answer #1


soon : 100m L70 H 150m 1) tan@= 100 – 0.667 ) TO = 33.699 15. 12) V = V1100) 50)? S9 V(100)+(50) 2 = 180.278 m 2 . MI = m =

Add a comment
Know the answer?
Add Answer to:
Interactive Exercises 4.03: Position and Velocity in Two Dimensions (Space Debris) In a far off galaxy,...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Interactive Exercises 5.04: Newton's Second Law in Two Dimensions A piece of space equipment is to...

    Interactive Exercises 5.04: Newton's Second Law in Two Dimensions A piece of space equipment is to be observed in a deep-space reference frame, which we assume is an inertial frame. The equipment is initially at rest relative to this frame, and at t = 0, two forces Fi and F2 are applied to the object. Both forces are constant, with Fi acting in the +x direction and F2 acting in the ty direction. The magnitudes of the two forces are:...

  • Problem 1.36 (Multistep) A spacecraft traveling at a velocity of <-14.87,-66.92, 29.74 > m/s is observed...

    Problem 1.36 (Multistep) A spacecraft traveling at a velocity of <-14.87,-66.92, 29.74 > m/s is observed to be at a location < 200, 300,-SOO > m reletive to an origin located on neerby asteroid. Atょleter time the spacecraft is at location <-380,-2310, 600 > m. Part 1 (a) How long did it take the spacecraft to travel between these locations? the tolerance is +-2% By accessing this Question Assistance, you will learn while you earn points based on the Point...

  • Checkpoint 3.03 (Multistep) A roughly spherical asteroid has a mass of 2.8 x 10 kg and...

    Checkpoint 3.03 (Multistep) A roughly spherical asteroid has a mass of 2.8 x 10 kg and a radius o, question part ▼ Part1 Your answer is incorrect. Try again. (a) What is the value of the constant g at a location on the surface of the asteroid? 2.8e20 the tolerance is +/-246 By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: 1 of 9 used SAVT...

  • Interactive Exercises 3.04: Vector Addition Using Components The simulation (linked below) shows two displacement vectors, labeled...

    Interactive Exercises 3.04: Vector Addition Using Components The simulation (linked below) shows two displacement vectors, labeled a and b(See the blue and red, open tipped arrows, respectively.) The simulation also shows an xy coordinate system, and a series of grid lines, where the spacing between adjacent lines is 2 km. Question 1 What are the components ax and ay of the first displacement? ax km dy km By accessing this Question Assistance, you will learn while you earn points based...

  • Interactive Exercises 3.02: Components of a Vector The simulation (linked below) shows a graphical representation of...

    Interactive Exercises 3.02: Components of a Vector The simulation (linked below) shows a graphical representation of a vector a located in an xy coordinate system. With a mouse or your finger, you can move the head of the vector throughout the visible region of the coordinate system. The simulation shows the projection of the vector onto the x axis, which is the vector's x component ax. The simulation also shows the projection of the vector onto the y axis, which...

  • Problem 6.70 (Multistep) Two protons are a distance 4 x 10-9 m apart. Part 1 (a)...

    Problem 6.70 (Multistep) Two protons are a distance 4 x 10-9 m apart. Part 1 (a) What is the electric potential energy of the system consisting of the two protons? Ua= joules the tolerance is +/-2% By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor. Attempts: 0 of 10 used SAVE FOR LATER SUBMIT ANSWER Part 2 (b) If the two protons move closer together, will the...

  • Interactive Exercises 5.07: Normal Force and Accelerating Particle For a physics class experiment, you place a...

    Interactive Exercises 5.07: Normal Force and Accelerating Particle For a physics class experiment, you place a Red Delicious apple (mass m = 0.100 kg) at rest on a bathroom scale, and place the combination on the floor of an elevator in a tall building. The elevator is initially at rest-see Interactive Fig. 5.7.1 Cable ty Elevator Apple Bathroom scales Interactive Figure 5.7.1: An apple sits on a bathroom scale that rests on the floor of an elevator. Initially, the elevator...

  • Interactive Exercises 5.12: Applying Newton's Laws (Alpine Skier) An alpine skier-see Fig. 5.12.1-has total mass (including...

    Interactive Exercises 5.12: Applying Newton's Laws (Alpine Skier) An alpine skier-see Fig. 5.12.1-has total mass (including equipment) of m 75.0 kg and is skiing down a smooth slope that makes an angle of strong wind blows directly up the slope, which results in a force of 50.0 N acting on the skier opposite to his motion 30.0 to the horizontal. It is a windy day and a Interactive Figure 5.12.1: An alpine skier travels downhill. His motion is modeled as...

  • Interactive Exercises 1.02: Comparing Time Units A delivery truck travels in a straight line on a...

    Interactive Exercises 1.02: Comparing Time Units A delivery truck travels in a straight line on a horizontal roadway at constant speed : 5 52.5 km h kilometers per hour The ruck trave sa distance of△ O in. ▼ Question 1 How much time is required Δ1 for this trip in seconds? the tolerance is +/-296 By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor. Attempts: 0 of...

  • Interactive Exercises 1.02: Comparing Time Units A delivery truck travels in a straight line on a...

    Interactive Exercises 1.02: Comparing Time Units A delivery truck travels in a straight line on a horizontal roadway at constant speed v = 52.5 km/h (kilometers per hour). The truck travels a distance of Δx = 75.0 km. Question 2 How much time is required Δt for this trip in years? yr the tolerance is +/-296 By accessing this Question Assistance, you will learn while you earn points based on the Point Potential Policy set by your instructor Attempts: 0...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT