student took a sample of vinegar with a 5 ml volumetric pipet and then emptied all of the liquid in an Erlenmeyer flask by blowing out the sample
Ans: The student might get some error in the result. The measuring equipment should be the same for measuring all liquid. Since the student measure vinegar with the volumetric pipet and other with Erlenmeyer flask, there might be a small error. So a student should take the same equipment for all the cases.
student took a sample of vinegar with a 5 ml volumetric pipet and then emptied all...
a student uses 10.o mL volumetric pipet to measure the volume of the sample. when emptying the pipet, the student blows all of the liquid out of the pipet. how will this change the calculated density of the liquid?
You diluted a 12.96 ml vinegar sample into a 100 ml volumetric flask with distilled water. You titrated a 25.00 mL aliquot of that solution and determined the concentration of acetic acid to 0.048 M. What was the concentration of acetic in the original sample.
What piece of glassware would a student use to deliver 4.00mL of solution? A. 25 mL volumetric flask B. 10 mL beaker C. 5mL Erlenmeyer flask D. 25mL graduated cylinder E. 10mL volumetric pipet
. Student dissolves a tablet of Vitamin C in 100.0 mL of water. 2. Using 5.00 mL volumetric pipet, student transfers 5.00 mL of the tablet solution in to an Erlenmeyer flask. 3. After adding starch indicator, student titrated Vitamin C containing solution with standard solution of Iodine (5.00E-3 M). It took 17.73 mL of Iodine solution. MM of vitamin c = 176.1 g/mol Calculate mass of Vitamin C in the tablet.
Use a volumetric pipet to deliver 2 mL of 4 M sodium hydroxide solution to each of seven 100-mL volumetric flasks. Add 2,4, 6, 8, and 10 mL, respectively, of the salicylic acid stock solution to 5 of the labeled flasks. Calculate the concentrations of the standard solutions. Use a pipet to place 10 mL of the unknown solution into another volumetric flask and label Unknown 1. Dilute each solution to the mark with DI water. The seventh flask that...
The mass of water delivered by a 5-mL volumetric pipet at 24.0oC and standard pressure was 4.851 g. What volume of water was delivered by the pipet? Answer in mL.
a 25.0 ml aliquot of vinegar was diluted to 250 ml in volumetric flask. Titration of 50.0 ml aliquots of diluted solution required an average of 34.88 ml of 0.09600 M NaOH. Express the acidity of the vinegar in terms of percentage (w/v) of acetic acid.
1aYou are measuring 10.00mL of liquid with a volumetric pipet. While you are drawing the liquid into the pipet, you remove the tip of the pipet from the solution and suck up a little bit of air into the pipet. You adjust the liquid so that the meniscus is at the calibration line, but you notice there are some air bubbles in the pipet. 1a.) How do the bubbles impact the amount of liquid that you will dispense? Will you...
A student weighs out 14.6 g of AlBrz, transfers it to a 300 mL volumetric flask, adds enough water to dissolve the solid and then adds water to the 300 mL mark on the neck of the flask. Calculate the concentration (in molarity units) of aluminum bromide in the resulting solution? Calculate the mass, in grams of sodium iodide that must be added to a 250 mL volumetric flask in order to prepare 250 mL of a 0.138 M aqueous...
In the laboratory, a student adds 19.3 g of potassium acetate to a 125 mL volumetric flask and adds water to the mark on the neck of the flask. Calculate the concentration in mol/L) of potassium acetate, the potassium ion and the acetate ion in the solution [KCH3COO) - [K] [CH3C00] = 1 A student wishes to prepare 300-ml of a 0.236 M iron(III) acetate solution using solid iron(III) acetate, a 300-ml volumetric flask, and deionized water (a) How many...