a student uses 10.o mL volumetric pipet to measure the volume of the sample. when emptying...
a student uses 10.o mL volumetric pipet to measure the volume of the sample. when emptying the pipet, the student blows all of the liquid out of the pipet. how will this change the calculated density of the liquid?
Homework Answers
ANSWER:
In volumetric pipettes, the liquid should not be blown out. The small amount of liquid which remains in the tip. If all liquid is blow out of the pipette, the delivered volume would be more than 10.0 mL.
Therefore, this will change the value of calculated density of the liquid. This is due to density is defined as
To calculate the density of any liquid, a known volume of the liquid (delivered by a vlumetric pipette) is weighed in an analytical balance, then the formula of density is applied.
- If the student blows out all the liquid out of the volumetric pipette, the volume in the flask is a few more than 10.0 mL and it is an unknown volume.
- Then, the observed mass will be registered as the mass of 10.0 mL of liquid. However, this woul be in fact the mass of more than 10.0 mL of liquid.
- When the density calculation is done, the student will used the observed mass and a volume of 10.0 mL. Then, the calculated density will give a value higher then real
Add Answer to:
a student uses 10.o mL volumetric pipet to measure the volume of
the sample. when emptying...
student took a sample of vinegar with a 5 ml volumetric pipet and then emptied all...
student took a sample of vinegar with a 5 ml volumetric pipet and then emptied all of the liquid in an Erlenmeyer flask by blowing out the sample
Make sure that the following questions are answered in your submitted lab report. A student has...
Make sure that the following questions are answered in your submitted lab report. A student has an unknown liquid the theoretical density of which is 1.34 g/mL. He determines the experimental density of the liquid using the method described in the procedure for this experiment Tell whether each of the following errors would cause the experimental value of the density of the liquid to be too large, too small, or unchanged relative to the true value. Explain your reasoning in...
1aYou are measuring 10.00mL of liquid with a volumetric pipet. While you are drawing the liquid...
1aYou are measuring 10.00mL of liquid with a volumetric pipet. While you are drawing the liquid into the pipet, you remove the tip of the pipet from the solution and suck up a little bit of air into the pipet. You adjust the liquid so that the meniscus is at the calibration line, but you notice there are some air bubbles in the pipet. 1a.) How do the bubbles impact the amount of liquid that you will dispense? Will you...
1. What do volumetric glassware measure? What types of volumetric glassware will you be using in...
1. What do volumetric glassware measure? What types of volumetric glassware will you be using in this experiment? 2. What is density? How is it calculated? 3.Define meniscus. State how you use the meniscus in making volumetric measurements. Draw a sketch of a meniscus for water in a graduated cylinder. 4. Define accuracy and precision. Explain what the “reliability of a measurement” means. (These concepts can be found in Chapter 1 of your text.) 5. Why will you calculate accurate...
In the laboratory, a student adds 19.3 g of potassium acetate to a 125 mL volumetric...
In the laboratory, a student adds 19.3 g of potassium acetate to a 125 mL volumetric flask and adds water to the mark on the neck of the flask. Calculate the concentration in mol/L) of potassium acetate, the potassium ion and the acetate ion in the solution [KCH3COO) - [K] [CH3C00] = 1 A student wishes to prepare 300-ml of a 0.236 M iron(III) acetate solution using solid iron(III) acetate, a 300-ml volumetric flask, and deionized water (a) How many...
A student weighs out 14.6 g of AlBrz, transfers it to a 300 mL volumetric flask,...
A student weighs out 14.6 g of AlBrz, transfers it to a 300 mL volumetric flask, adds enough water to dissolve the solid and then adds water to the 300 mL mark on the neck of the flask. Calculate the concentration (in molarity units) of aluminum bromide in the resulting solution? Calculate the mass, in grams of sodium iodide that must be added to a 250 mL volumetric flask in order to prepare 250 mL of a 0.138 M aqueous...
4. Suppose that a student performed the experiment and calculations perfectly as directed except that, unknown...
4. Suppose that a student performed the experiment and calculations perfectly as directed except that, unknown to the student, the balance was not zeroed but weighed 0.100 g too high throughout the experiment. Would the calculated val- ue for the density of the unknown liquid be correct? That is, would it be equal to, higher than, or lower than the true value. Explain your answer in clear and correct English. 16 LABORATORY EXPERIMENTS IN GENERAL CHEMISTRY ed in question 4...
A student was given a 10 mL sample of a clear, colorless liquid. She was assigned...
A student was given a 10 mL sample of a clear, colorless liquid. She was assigned the task of identifying the unknown liquid and was told that the sample could be methanol (CH_3OH), acetone (C_3H_6O), or ethanol (C_2H_5OH). She decided to attempt to determine the molar mass of the liquid by the vapor density method, which involves completely vaporizing a small sample of the liquid, cooling it and determining the mass of the condensed vapor. She also collects the volume...
You are checking the accuracy of a volumetric flask marked 10.00 mL. Measurement| Volume (mL) You...
You are checking the accuracy of a volumetric flask marked 10.00 mL. Measurement| Volume (mL) You measure the volume of water contained in the flask by measuring the mass of the empty flask, the mass of the flask filled with water, taking the difference, correcting for the buoyancy factor, and dividing by the density of the water. The results of eight such measurements are given in the table 10.064 10.063 10.017 10.049 10.020 10.025 10.045 10.008 2 3 4 5...
Please do 2,3 and 4 Experiment 3 Pr 1. A student weigh be 98.595 oth mark,...
Please do 2,3 and 4
Experiment 3 Pr 1. A student weigh be 98.595 oth mark, the stoppered flask is weighed again and the mass is found to be 204.274 & ment s an empty 100 mL. volumetric flask and stopper and finds the mass to g After adding 4.163 g of sugar to the flask, dissolving it, and filling the flask Calculate the density of this solution dm oS 629 2. Explain how to properly prepare a solution in...
Make sure that the following questions are answered in your submitted lab report. A student has an unknown liquid the theoretical density of which is 1.34 g/mL. He determines the experimental density of the liquid using the method described in the procedure for this experiment Tell whether each of the following errors would cause the experimental value of the density of the liquid to be too large, too small, or unchanged relative to the true value. Explain your reasoning in...
In the laboratory, a student adds 19.3 g of potassium acetate to a 125 mL volumetric flask and adds water to the mark on the neck of the flask. Calculate the concentration in mol/L) of potassium acetate, the potassium ion and the acetate ion in the solution [KCH3COO) - [K] [CH3C00] = 1 A student wishes to prepare 300-ml of a 0.236 M iron(III) acetate solution using solid iron(III) acetate, a 300-ml volumetric flask, and deionized water (a) How many...
A student weighs out 14.6 g of AlBrz, transfers it to a 300 mL volumetric flask, adds enough water to dissolve the solid and then adds water to the 300 mL mark on the neck of the flask. Calculate the concentration (in molarity units) of aluminum bromide in the resulting solution? Calculate the mass, in grams of sodium iodide that must be added to a 250 mL volumetric flask in order to prepare 250 mL of a 0.138 M aqueous...
4. Suppose that a student performed the experiment and calculations perfectly as directed except that, unknown to the student, the balance was not zeroed but weighed 0.100 g too high throughout the experiment. Would the calculated val- ue for the density of the unknown liquid be correct? That is, would it be equal to, higher than, or lower than the true value. Explain your answer in clear and correct English. 16 LABORATORY EXPERIMENTS IN GENERAL CHEMISTRY ed in question 4...
A student was given a 10 mL sample of a clear, colorless liquid. She was assigned the task of identifying the unknown liquid and was told that the sample could be methanol (CH_3OH), acetone (C_3H_6O), or ethanol (C_2H_5OH). She decided to attempt to determine the molar mass of the liquid by the vapor density method, which involves completely vaporizing a small sample of the liquid, cooling it and determining the mass of the condensed vapor. She also collects the volume...
You are checking the accuracy of a volumetric flask marked 10.00 mL. Measurement| Volume (mL) You measure the volume of water contained in the flask by measuring the mass of the empty flask, the mass of the flask filled with water, taking the difference, correcting for the buoyancy factor, and dividing by the density of the water. The results of eight such measurements are given in the table 10.064 10.063 10.017 10.049 10.020 10.025 10.045 10.008 2 3 4 5...
Please do 2,3 and 4
Experiment 3 Pr 1. A student weigh be 98.595 oth mark, the stoppered flask is weighed again and the mass is found to be 204.274 & ment s an empty 100 mL. volumetric flask and stopper and finds the mass to g After adding 4.163 g of sugar to the flask, dissolving it, and filling the flask Calculate the density of this solution dm oS 629 2. Explain how to properly prepare a solution in...
Most questions answered within 3 hours.
-
A chemical equation is balanced by adding coefficients in front
of some formulas so that the...
asked 1 minute from now -
From the literature (reference your sources): What are the
lattice parameters of calcite and aragonite? Why...
asked 38 minutes ago -
Your system is rejecting the question am asking which is
preceded by a case study. It...
asked 42 minutes ago -
3. On January 2, 2000, Larry creates a trust with himself as
trustee. Larry as trustee...
asked 39 minutes ago -
A member of the volleyball team spikes the ball. During this
process, she changes the velocity...
asked 46 minutes ago -
Are adult gamers less likely to use a gaming console (Xbox,
PlayStation, Wii, etc...) than teen...
asked 1 hour ago -
The University of
Texas recently reported that 43% of college students aged 18-24
would spend their...
asked 1 hour ago -
The length of stay at a specific emergency department in
Phoenix, Arizona, in 2009 had a...
asked 1 hour ago -
. Please give the mechanism for this type of problem. Step by
Step
The toxin that...
asked 1 hour ago -
If you have a 1M stock solution and you want to dilute 1 :10
with water,...
asked 1 hour ago -
In a load instruction, the effective address is obtained by
A) Retriving the address from a...
asked 1 hour ago -
Use the following information to answer this question.
Windswept, Inc. 2017 Income Statement ($ in millions)...
asked 1 hour ago