Question

5. What was the purpose of the NaNO3 solution in this experiment? 6. Could a solution of NaCl be used instead of NaNO3? 7. Wh
EXPERIMENT 10 DETERMINATION OF THE ELECTROCHEMICAL SERIES PURPOSE To determine the standard cell potential values of several
Brial Na M -1.85 M Berim A Manganese Chromium Tron Cadmium Nickel + 2e Cd N Sn . + 2e AI Mn. 2 ) Cria) Fe ) Cd) Ni() Sn.) Pb(
E R OV - Since Ecell is positive, we were correction in the w de came out negative, we would have to reverse the role of the
PROCEDURE PARTI - SETUP 1. Obtain an 11.0 cm diameter piece of filter paper 2. Draw seven circles onto the filter paper with
PART II - DATA RECORDER SETUP O n a Data Recorder from the changing in non the data recorder by holding the button the other
the voltage reading is negative, reverse the end of the women (+) end of the sensor to Cu and the black ) end of the t e hat,
0 0
Add a comment Improve this question Transcribed image text
Answer #1

Solution:

5) NaNO3 solution is working as a salt bridge. A salt bridge is used to establish an electrical contact between two half cells.A salt bridge must be unreactive in nature.

6) No

A salt bridge must be unreactive and posses nearly equal transference number for both cation and anion. Sodium chloride can reacts with the electrolytic solution to form precipitate, hence does not used as salt bridge.

Add a comment
Know the answer?
Add Answer to:
5. What was the purpose of the NaNO3 solution in this experiment? 6. Could a solution...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • need help with the rest of the table EXPERIMENT 10 DETERMINATION OF THE ELECTROCHEMICAL SERIES PURPOSE...

    need help with the rest of the table EXPERIMENT 10 DETERMINATION OF THE ELECTROCHEMICAL SERIES PURPOSE To determine the standard cell potential values of several electrochemical coll INTRODUCTION The basis for an electrochemical cell is an oxidation reduction Corredor be divided into two half reactions reaction. This reaction can Oxidation half reaction Gloss of electrons) takes place at the anode, which is the positive electrode that the anions migrate to Chence the name anode) Reduction half reaction (gain of electrons)...

  • how would you go about solving this problem via using equations just looking for the equation order i should go about solving this problem In this experiment you will be using the two half rea...

    how would you go about solving this problem via using equations just looking for the equation order i should go about solving this problem In this experiment you will be using the two half reactions Cu?"/Cu and Zn2 /Zn. The standard electrode potential, E°, for these half reactions is +0.34V and-0.76V respectively, so the Nernst Equation for these half reactions is the following Cu ea)+2e - Cus) E - 0.34V 0.0592V Cu2+] 0.0592V Zn 2 Note that solids by definition...

  • A copper/magnesium electrochemical cell was constructed. EXPERIMENT S Volumetric Analysi Acid-Bse Titration Part Il: Answer each...

    A copper/magnesium electrochemical cell was constructed. EXPERIMENT S Volumetric Analysi Acid-Bse Titration Part Il: Answer each of the following questions about the copper/magnesium electrochemical cell you built in this experiment. Answer for the single cell, do not worry about the series configuration. 65 Copper Which electrode is the cathode? Magnesium Copper Which electrode is the anode? 2 Magnesium 3. Write the equation for the half-reaction that occurs at the copper electrode, and indicate whether it is an oxidation or a...

  • Is #3 correct? "Sn(s)/Sn+2(aq) // Cu+2(aq)/Cu(s)" Also, I need help with #4 and #5. Thanks! (will...

    Is #3 correct? "Sn(s)/Sn+2(aq) // Cu+2(aq)/Cu(s)" Also, I need help with #4 and #5. Thanks! (will rate!) Section A. Constructing a Small-Scale Electrochemical Cell Objective To construct a small-scale electrochemical cell using a redox system, to measure the cell potential and derive thermodynamic quantities. Procedures 1. Connect the red and black alligator clips to the multimeter to read voltage. Set up the multimeter to read DC (direct current) voltage using the tab at the top. 2. Cut the filter paper...

  • Page 1 and 2 are instructions. Please help me solve K for page 3 and page...

    Page 1 and 2 are instructions. Please help me solve K for page 3 and page 4 and please check the other work on Page 3. Thanyou very much. Will Rate! CHM 112 Electrochemical Cells and Thermodynamics Section A. Constructing a Small-Scale Electrochemical Cell Woodbridge Campus Objective To construct a small-scale electrochemical cell using a redox system, to measure the cell potential and derive thermodynamic quantities. Procedures 1. Connect the red and black alligator clips to the multimeter to read...

  • i need help with all of these questions Chem 103A Electrochemistry 5. A voltaic cell is...

    i need help with all of these questions Chem 103A Electrochemistry 5. A voltaic cell is to be constructed using the Ag/Ag half cell and the Pb/Pb half-cell. Measurement shows that the silver electrode is positive. a) Write balanced half-reactions and the overall spontancous reaction, without using a table of half-cell potentials. b) Diagram the cell, labeling electrodes as anode and cathode, labeling the salt bridge, showing what ions are in solution, and showing the direction of electron flow in...

  • 9. In Part 2 of this experiment, you will observe the reaction of aluminum in an...

    9. In Part 2 of this experiment, you will observe the reaction of aluminum in an aqueous CuCl, solution. a) Given the following half-reactions, predict if aluminum will dissolve in a CuCl, solution. A13+ (aq) + 3e + Al(s) E = - 1.70 V Cu2+ (aq) + 2e - → Cu (s) E = 0.34 V b) The more positive the cell potential the more spontaneous the reaction will be. What precautions should you take in performing this experiment if...

  • help did i do this correct? a ws4 wws C PRE-L AX I Mycs aws4 Panapowe...

    help did i do this correct? a ws4 wws C PRE-L AX I Mycs aws4 Panapowe LUCY Name Electrochemical Cell Potentials and the Activity Series Report Form All data and calculations MUST be in your la notebook Part A. Electrochemical Cell Potentials Measured Potentials: NOTE - Remember that the positive electrode is attached to the red wire and the negative electrode is attached to the black wire.) Electrode Systems Used Anode (oxidation) Negative Cathode (reduction) Positive Measured Potential (V) an)...

  • Can you help explaim and solve how to find delta G along with anything related to...

    Can you help explaim and solve how to find delta G along with anything related to half-cells I dont even know where to begin, thank you! WILL probe to the piece of metal foil • Read and record the voltape. Do not forget the NOTE : The The filter paper string should be placed in the welis just prior to measuring the voltage 10. Reverse the probes Record what happens to the sign and switch the meter off NOTE: The...

  • with the information and tables provided, can you help me answer questions 2,3,4,and 5? thank you!...

    with the information and tables provided, can you help me answer questions 2,3,4,and 5? thank you! DATA ANALYSIS - ONLINE SIMULATION DATA Record your collected data here. Black Red E (V) Cu Zn -1.10 Cu Sn -0.48 Cu Mg -2.71 Cu Ag 0.46 QUALITY OF DATA This section awards marks based on the quality of your Ell values. Quality of data Your standard cell potentials are in the expected order. EXPECTED DATA The expected data is given below. Use the...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT