1)A mechanical load is driven by an electric motor at an equilibrium speed Wa.
The load is Tl = 20+0.6w and the load moment of inertia is Jl= 2kgm^2
The speed-torque relation of the motor is w=100-0.1T and the moment of inertia
is Jm = 0.2 kgm^2.
a) Calculate the power requirement for Wc operation speed
b) Calculate the stopping time of the motor when its turned off at the
continuous operating W
c)Draw torque-speed characteristics of motor and load in the same graphic.
d)Comment on the stability of the operating system
1)A mechanical load is driven by an electric motor at an equilibrium speed Wa. The load...
Electrical machine control A motor has the following parameter: Un=110V, Ra=0.5ohm, armature inductance L=75mH, moment of inertia J=1kgm2,Total torqu due to mechanical losses Tm=0.7Nm 1)Given Io=1.8A Deduce the factor k such that T=k.I hence deduce the no load speed. 2) the machine is running without load and we couple suddenly (at t=0) a mechanical load presenting a resistive torque of Tr=13Nm. Write the differential equations linking torque to angular speed and hence the KVL equations during the transient mode of...
1. A 20 hp, 230 V, 60 Hz, four-pole, three-phase induction motor operating at rated load has rotor copper loss of 331 W, and a combined friction, windage, and stray power loss of 249 W. Determine, (a) Mechanical power developed; (b) Air-gap power; (c) Shaft speed; (d) Shaft torque (10 pts.)
QUESTIONS Question-3: Draw "speed vs. torque" curve using data in Table-1. The completed graph represents the speed vs. torque characteristics of a typical DC shunt-wound motor. Terax Question-4: Calculate the speed regulation (full load - 12 lbf.in) using the equation: 2-143) 143 (no load Regulation (full load speed) Speed regulation- % Part-II - Motor Efficiency Calculation: Set the dynamometer control knob at its full CW position (to provide the maximum starting load for the shunt-wound motor). Turn on the power...
43 Questions 1. Using Figure 4-2, determine the electrical relationship characterizing a standard DC motor. Express the relationship in the Laplace domain. L. i,o, M ry Figure 4-2 DC Motor Electric Circuit 2. Determine and evaluate the motor electrical time constant, τ.. This is done by assuming that the shaft is stationary. You can find the parameters of the motor in Table B-1. 3. Assume τ. is negligible and simplify the motor electrical relationship determined in question 1. What is...
14. The following details are known about a 200 hp, 500 V, 435 rpm de shunt motor: full-load current is 330 A, insulation class is H, weight is 3400 kg, external diameter of the frame is 915 mm and length of the frame is 1260 mm. If the motor is running at full-load, calculate: a. the total losses and efficiency. b, the approximate shunt field exciting current if the shunt field causes 15% of the total losses. the value of...
1. IP A turntable with a moment of inertia of 5.2×10−3 kg⋅m2 rotates freely with an angular speed of 3313rpm . Riding on the rim of the turntable, 19 cm from the center, is a cute, 32 g mouse.A) If the mouse walks to the center of the turntable, will the turntable rotate faster, slower, or at the same rate? (Answer is Slower)B) Explain.C) Calculate the angular speed of the turntable when the mouse reaches the center.2. One elevator arrangement...