Electronic Power Converter - PWM duty cycles and sketch 2 (15 pts) You are asked to...
DC-DC Converter Machine Drives D QUE D EA TI C+ ata at I A separately excited DC motor is powered by a full bridge power converter using MOSFET power transistors and freewheeling diodes as shown above, Converter: Vs - 250 V Switching frequency - 5 kHz. Two-quadrant mode: Q3 always open and Q4 always closed. Assume ideal switches and diodes. DC machine: R-50 m2 LA = 300 H Ex -0.2 V/(r/min) Ignore rotational losses and brush voltage drop Answer the...
Q3 A MOSFET is used as a low-side switch to control a 15 2 resistive load from a 24 V DC supply. The MOSFET has Rps,on = 0.2 and fon foff= 40 ns. [2] (a) Draw a suitable circuit. (b) Calculate both the drain current ip and drain-source voltage vps when the MOSFET is off and when it is on. [6] (c) Calculate the power dissipated in the load and in the MOSFET while they switched on. are [4] (d)...
O bructe CONFIDENTIAL 2 limitatio of Flyb Q2 (a) With the aid of respective topology, point out three (3) basic de-de converters ( 3 marks) (b) Discuss the energy transfer in on each circuit by refering the circuits drawn in Q2(a) (3 marks) (c) Design a boost converter for continuous inductor current and an output nipple voltage of less than 1% that will have an output of 30 V from a 12 V source, Assume the load resistance of 50...
O bructe CONFIDENTIAL 2 limitatio of Flyb Q2 (a) With the aid of respective topology, point out three (3) basic de-de converters ( 3 marks) (b) Discuss the energy transfer in on each circuit by refering the circuits drawn in Q2(a) (3 marks) (c) Design a boost converter for continuous inductor current and an output nipple voltage of less than 1% that will have an output of 30 V from a 12 V source, Assume the load resistance of 50...
Please answer all the parts of the question clearly and fully! Thank you! Numerical Answers: (b) (0.0 A, 24 V), (approximately 1.6 A, 0.32 V) (c) 38.4 W, 0.5 W (e) 0.26 W + 1.5 mW SECTION B: Attempt any Two) questions 150 marks total! Q3 A MOSFET is used as a low-side switch to control a 15 2 resistive load from a 24 supply. The MOSFET has RDSan VDC 0.2 ? and ton-tof-40 ns. (a) Draw a suitable circuit....
DC-AC inverters have many commercial and residential applications, including uninterruptible power supply (UPS) units, adjustable speed drives (ASD) for AC motors, and electronic frequency changer circuits. They are also used in solar electrical systems where batteries are charged from solar panels and used as the input DC voltage source. The inverter circuit converts the DC into AC voltage of desired frequency. Most of us are also familiar with HVDC transmission systems, where high voltages are first converted from AC to...