A solution of ethanol is pumped to a vessel 25 m above
a reference level through a 25-mm-inside-diameter steel
pipe at a rate of 10 m3
/h. The length of pipe is 30 m and
contains two elbows with friction equivalent to 20 diameters
each. Compute the power requirements of the pump.
Solution properties include density of 975 kg/m3 and
viscosity of 4 3 1024 Pa s.
We need at least 6 more requests to produce the answer.
4 / 10 have requested this problem solution
The more requests, the faster the answer.
Oil (density = 910Kg/m3 and viscosity 3.1 x10-3 Pa-s) is pumped from an open tank to a pressurized tank held at 400KPa gauge. The oil is pumped from an inlet at the side of the open tank through a line of commercial steel pipe (inside diameter 0.8m) at a rate of 5x10-3 m3/s. The length of the straight pipe is 150 m, and the pipe contains 4 (90-degree) elbows and two globe valve half open. The level of the liquid...
2. An oil having density of 833 kg/m3 and a viscosity of 3.3 x 103 Pa.s is pumped from an open tank to a pressurized tank held at 345 k Pa gauge. The oil is pumped from an inlet at the side of the open tank through a line of commercial steel pipe having an inside diameter of 0.07792 m at the rate of 3.494 x 103 m'/s. The length of the straight pipe is 122 m and the pipe...
fluid mechanics SECTION A Petroleum distilate is pumped from one large diameter tank to another higher tank, via a pumping station in an oil refinery. The petroleum is pumped at a speed of 2 ms through a 150 m long pipeline of 100 mm internal diameter. The vertical distance pumped is 20 m. The sum of the entry, exit and other component losses is equivalent to 5 times the velocity head, Table Q1 Fluid density Friction factor f for the...
Prior to making a polymer solution for coating plastic film a solvent is pumped into a jacketed carbon steel, Teflon®-lined vessel that is 3 m in diameter with a straight side of 4 m. The liquid depth is 3 m and the jacket extends 3 m up the vessel side. The vessel has an agitator installed. The impeller is a glass-lined hydrofoil that is 1210 mm in diameter with a power number of 0.39 operating at 125 RPM. The fluid...
Q 3 Ninety-eight per cent sulphuric acid is pumped at 4.5 tonne/hour through a 25 mm diameter pipe, 30 m long to a reservoir 12 m higher than the feed point. Calculate the pressure drop in the pipeline. It is given that the viscosity of acid is 25 mN.s/m2 and the density of acid is 1840 kg/m3 and the roughness of the pipe is 0.05mm. Recalculate the pressure drop if the roughness of the pipe is 0.5 mm. Q 3...
Question 5 a) As shown in Figure Q5 (a), crude oil at 60°C with ρ-860 kg/m3 and μ-3.91 x 10" kg s/m (about four times of viscosity of water) is pumped across from City A to City B pipeline, a 1286 m long, 1.22 m diameter steel pipe ( 0.0125), at a maximum rate of Q- 3.31 m'ls. Investigate the horsepower (unit in hp) needed for the pumps that drive this large system. (Neglect minor losses in the system) Oil:...
You need to pump water at 20 C from an open reservoir at flow rate of 1.4 x 10^-3 m3/s through a pipe with an inside diameter of 0.03m, using a centrifugal pump having an (NPSH)aq =2.5 m and the equivalent length on the suction side is 3m. There are several minor losses: four standar 90 flanged elbows, and fully open flanged globe valve, fully open flanged gate valve, and the Entrance. What is the the maximum distance above the...
can somebody help me with problem 4 please 3. A fluid of viscosity 5 Pa s and density 1,025 kg/m' is being pumped through a cast iron pipe (€ = 259 x 10m) of length 14 m and diameter 8 cm at the rate of 4 kg/s. What is the power required for this? 4. In the above problem, calculate the power requirement if three gate valves (1/4 closed), four globe valves (fully open), and two regular 45 threaded elbows...
A centrifugal pump test yields the following data: Pump Head Flow (m)(L/min) 30 25 20 40 The pump curve can be approximated by a parabola. This pump draws water from a large reservoir. The discharge of the pump feeds 150 m of 1.5 cm inside diameter pipe and then 225 m of 3 cm inside diameter pipe.. The two pipes both have a roughness of 0.5 mm The 3 cm pipe discharges to atmosphere a distance 40 m below the...
A pumped-storage hydroelectric plant generates high value electricity during peak demand times, by allowing water (density 1,000 kg/m3) to run through a pipe from an elevated reservoir through a bank of turbines and then into a lower level reservoir. It then uses low-cost, off-peak electricity to pump the water back up into the upper reservoir The water surface in the very large upper reservoir (A) is 600 m above datum whilst that in the very large lower reservoir (B) is...