We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
fluid mechanics SECTION A Petroleum distilate is pumped from one large diameter tank to another higher...
NO QUESTIONS DURING T Water is to be pumped from a reservoir (ZA30 /s- to another reservoir at a higher elevati rate of elevation (Zn THE EXAM! n) through a long pipe, as shown in the figure at a volume ow olume flow rate has been calculated and is 11 m he head loss in the pipe at this usefuf pump ) Demostrate that wh en a pump moves a fluid from one reservoir to ano e elevation difference between...
fluid Q1: A venture meter is fitted in a pipe of 30 cm diameter inclined at 40° to the horizontal to measure the flow rate of petrol having a specific gravity of 0.8. The ratio of areas of main pipe and throat is 5 and the throat is at 1 m from the inlet along its length. The difference in manometer head is 40 mm of mercury. Assuming the coefficient of discharge as 0.96. Calculate the discharge through the venture...
A 3-m-diameter tank is initially filled with water 2 m above the center of a sharp-edged 10-cm-diameter orifice. The tank water surface is open to the atmosphere, and the orifice drains to the atmosphere through a 100-m-long pipe. The friction coefficient of the pipe is taken to be 0.015 and the effect of the kinetic energy correction factor can be neglected. In order to drain the tank faster, a pump is installed near the tank exit. Water tank Pump Required...
A 3-m-diameter tank is initially filled with water 2 m above the center of a sharp-edged 10-cm-diameter orifice. The tank water surface is open to the atmosphere, and the orifice drains to the atmosphere through a 100-m-long pipe. The friction coefficient of the pipe is taken to be 0.015 and the effect of the kinetic energy correction factor can be neglected. In order to drain the tank faster, a pump is installed near the tank exit. Water tank Pump 6...
Task 1: You were asked to check up the status of the water system. Water at 24 °C is to be pumped from a Lower reservoir with 100 m elevation to another reservoir at a higher elevation 112 m through 150-m-long pipe as shown in Figure (1). The pipe is made of steel, and the diameter of the pipe is equal to 30 cm. Water is to be pumped by a 72% efficient motor-pump combination that draws 33 A of...
Oil (density = 910Kg/m3 and viscosity 3.1 x10-3 Pa-s) is pumped from an open tank to a pressurized tank held at 400KPa gauge. The oil is pumped from an inlet at the side of the open tank through a line of commercial steel pipe (inside diameter 0.8m) at a rate of 5x10-3 m3/s. The length of the straight pipe is 150 m, and the pipe contains 4 (90-degree) elbows and two globe valve half open. The level of the liquid...
1) Water is pumped steadily through a 0.10 m diameter pipe from one closed, pressurized tank to another as shown in the figure. The pump adds 4 kW to the water and the head loss of the flow is 10 m. Determine the velocity of the water leaving the pipe. Draw energy and hydraulic grade lines. Ppupn= A(Ans= 5m/s) ar 300 kPa Tank I 35 m pa = 500 kPa 15 m Tank II DUMD 0.10 m diameter pipe
2 The industrial coolant with density of 900 kg/m' is to be pumped from large open processing tank to a large open storage tank. The pipe diameter throughout the length of the pipe is 0.153 m and the total length of the pipe between the pipe entrance and pipe exit is 200 m. The Minor loss coefficients for the entrance and exit effects are 1 and 1.5. The experimental values of minor loss coefficients due to the elbows are calculated...
The industrial coolant with density of 900 kg/m' is to be pumped from large open processing tank to a large open storage tank. The pipe diameter throughout the length of the pipe is 0.153 m and the total length of the pipe between the pipe entrance and pipe exit is 200 m. The Minor loss coefficients for the entrance and exit effects are 1 and 1.5. The experimental values of minor loss coefficients due to the elbows are calculated as...
A 3-m-diameter tank is initially filled with water 2 m above the center of a sharp-edg 10-cm-diameter orifice. The tank water surface is open to the atmosphere, and the orifice drains to the atmosphere through a 100-m-long pipe. The friction coefficient the pipe is taken to be 0.015 and the effect of the kinetic energy correction factor ca be neglected. In order to drain the tank faster, a pump is installed near the tank exit Water tank Pamp Required infor...