Homework Answers
Add Answer to:
2. An oil having density of 833 kg/m3 and a viscosity of 3.3 x 103 Pa.s...
Oil (density = 910Kg/m3 and viscosity 3.1 x10-3 Pa-s) is pumped from an open tank to...
Oil (density = 910Kg/m3 and viscosity 3.1 x10-3 Pa-s) is pumped from an open tank to a pressurized tank held at 400KPa gauge. The oil is pumped from an inlet at the side of the open tank through a line of commercial steel pipe (inside diameter 0.8m) at a rate of 5x10-3 m3/s. The length of the straight pipe is 150 m, and the pipe contains 4 (90-degree) elbows and two globe valve half open. The level of the liquid...
Water, with density of 1000 kg/m3 and kinematic viscosity of 1.0 x 10- m2/s, is pumped through a ...
Water, with density of 1000 kg/m3 and kinematic viscosity of 1.0 x 10- m2/s, is pumped through a total length of 60 m of pipe from a lower reservoir to a higher reservoir. The inner diameter of the pipe is 30 cm. Both reservoirs are open to the atmosphere, and the water surface of the higher reservoir is 10 m above that of the lower reservoir. The entrance from the lower reservoir to the pipe is sharp-edged, and along the...
A liquid with density of 59 lb / ft ^ 3 and viscosity of 7cp is transported at 105.4 gpm by a pum...
a liquid with density of 59 lb / ft ^ 3 and viscosity of 7cp is transported at 105.4 gpm by a pump 70% efficiency of a # 1 tank operating at 15psig to another tank # 2 that operates at 55psig. The level of liquid in tank # 2 is 86 ft above the liquid level in tank # 1. Between both tanks there is 350 ft of linear tube with internal diameter of 2.25in and e / D...
A liquid chemical is pumped from a storage tank open to the atmosphere, into a reactor...
A liquid chemical is pumped from a storage tank open to the atmosphere, into a reactor with pressure of 2.0 atm gauge above the liquid level. The liquid density is 1200 kg/m3 and viscosity is 1.45 cP. The required volumetric flow rate is 1.25 x 103 m/s. The pipeline is 100 m long in total, made of commercial steel pipe, 2 in. size and Schedule 40. The gate valve is wide open. 10 m Reactor Calculate: (a) The discharge velocity...
An oil with a density of 340 lbm / ft3 and a viscosity of 15 cp...
An oil with a density of 340 lbm / ft3 and a viscosity of 15 cp is in a very large and atmospheric cylinder-shaped tank. The oil is 5 ft. High from the bottom. It will be pumped to the top of a tank at a rate of 30 gal / min with a system of 3 inches inside diameter and 75 ft. Length of steel pipe, 1 full open slide valve, 1 T connection and 4 90 ° bends....
Oil with a density of 850 kg/m and kinematic viscosity of 0.00062 m2/s is being discharged...
Oil with a density of 850 kg/m and kinematic viscosity of 0.00062 m2/s is being discharged from a 5-mm-diameter, 40-m-longhorizontal pipe from a storage tank open to the atmosphere. The height of the liquid level above the center of the pipe is 3-m. If the friction factor (f) of the pipe is 0.006. Disregarding the minor losses, determine the flow rate of oil through the pipe. 11. 3 m Oil tank 5 mm
You need to pump water at 20 C from an open reservoir at flow rate of...
You need to pump water at 20 C from an open reservoir at flow rate of 1.4 x 10^-3 m3/s through a pipe with an inside diameter of 0.03m, using a centrifugal pump having an (NPSH)aq =2.5 m and the equivalent length on the suction side is 3m. There are several minor losses: four standar 90 flanged elbows, and fully open flanged globe valve, fully open flanged gate valve, and the Entrance. What is the the maximum distance above the...
Oilspecific gravity 0.85 and dynamic viscosity 1.52 x 103 Pa.s to flow in a 550 mm diameter uPVC ...
help me to answer question 9,11,13 please
Oilspecific gravity 0.85 and dynamic viscosity 1.52 x 103 Pa.s to flow in a 550 mm diameter uPVC pipe. The allowable friction head loss is imited to 15 m and length of pipe is 100 m. al using Darcu-Weisbach formula, determine the flow velocity, the friction factor and the flow rate. using Hazen-Wiiams formula, determine the velocity and the flow rate. MoN 10 Water must flow in a straight 450 mm diameter galvanized...
Water (density 998 kg/mº, dynamic viscosity 0.001 Pa s) is pumped between two reservoirs at a...
Water (density 998 kg/mº, dynamic viscosity 0.001 Pa s) is pumped between two reservoirs at a volumetric flow rate of 0.006 m/s through a 120-m long pipe of 5 cm diameter. The roughness ratio of the pipe is a/d = 0.001. There are some fittings and valves in the pipe system, as shown in Figure Q1. The loss coefficients of the valves and fittings can be found in Table Q1. The Darcy friction factor can be found in the Moody...
Send somit Click Submit to complete this assessment. Question 4 p 4 uestion 4 30 points...
Send somit Click Submit to complete this assessment. Question 4 p 4 uestion 4 30 points You need to pump water at 20°c from an open reservoir at flow rate of 1.4*103 m/s through a pipe with an inside diameter of 0.03 m, using a centrifugal pump having un (NPS)req - 2.5 m and the equivalent length on the suction side is 3 m. There are several minor losses: four standard 90 flanged elbows, and fully open fanged globe valve,...
Water, with density of 1000 kg/m3 and kinematic viscosity of 1.0 x 10- m2/s, is pumped through a total length of 60 m of pipe from a lower reservoir to a higher reservoir. The inner diameter of the pipe is 30 cm. Both reservoirs are open to the atmosphere, and the water surface of the higher reservoir is 10 m above that of the lower reservoir. The entrance from the lower reservoir to the pipe is sharp-edged, and along the...
A liquid chemical is pumped from a storage tank open to the atmosphere, into a reactor with pressure of 2.0 atm gauge above the liquid level. The liquid density is 1200 kg/m3 and viscosity is 1.45 cP. The required volumetric flow rate is 1.25 x 103 m/s. The pipeline is 100 m long in total, made of commercial steel pipe, 2 in. size and Schedule 40. The gate valve is wide open. 10 m Reactor Calculate: (a) The discharge velocity...
Oil with a density of 850 kg/m and kinematic viscosity of 0.00062 m2/s is being discharged from a 5-mm-diameter, 40-m-longhorizontal pipe from a storage tank open to the atmosphere. The height of the liquid level above the center of the pipe is 3-m. If the friction factor (f) of the pipe is 0.006. Disregarding the minor losses, determine the flow rate of oil through the pipe. 11. 3 m Oil tank 5 mm
help me to answer question 9,11,13 please
Oilspecific gravity 0.85 and dynamic viscosity 1.52 x 103 Pa.s to flow in a 550 mm diameter uPVC pipe. The allowable friction head loss is imited to 15 m and length of pipe is 100 m. al using Darcu-Weisbach formula, determine the flow velocity, the friction factor and the flow rate. using Hazen-Wiiams formula, determine the velocity and the flow rate. MoN 10 Water must flow in a straight 450 mm diameter galvanized...
Water (density 998 kg/mº, dynamic viscosity 0.001 Pa s) is pumped between two reservoirs at a volumetric flow rate of 0.006 m/s through a 120-m long pipe of 5 cm diameter. The roughness ratio of the pipe is a/d = 0.001. There are some fittings and valves in the pipe system, as shown in Figure Q1. The loss coefficients of the valves and fittings can be found in Table Q1. The Darcy friction factor can be found in the Moody...
Send somit Click Submit to complete this assessment. Question 4 p 4 uestion 4 30 points You need to pump water at 20°c from an open reservoir at flow rate of 1.4*103 m/s through a pipe with an inside diameter of 0.03 m, using a centrifugal pump having un (NPS)req - 2.5 m and the equivalent length on the suction side is 3 m. There are several minor losses: four standard 90 flanged elbows, and fully open fanged globe valve,...
Most questions answered within 3 hours.
-
What mechanisms Drive speciation??
(I.e. what was Dawins theory on the orgin of species, and how...
asked 19 minutes ago -
The manager at a car assembly plant believes that the mean
assembly time for a car...
asked 1 hour ago -
Which of the following is true of electron capture?
A) It decreases the nuclide's mass number...
asked 2 hours ago -
Assuming an efficiency of 43.10%, calculate the actual yield of
magnesium nitrate formed from 114.9 g...
asked 3 hours ago -
The highly pathogenic bacterium Clostridium
perfringens causes gangrene, a disease that results in the
destruction of...
asked 5 hours ago -
In the context of situation analysis, which of the following is
a category for analysis in...
asked 5 hours ago -
In a study of the gas phase decomposition of sulfuryl chloride
at 600 K SO2Cl2(g)SO2(g) +...
asked 5 hours ago -
75 g of 2-propanol (C3H8O) and 25 g of pentane are mixed in a
200 mL...
asked 5 hours ago -
The 2800-turn coil in a dc motor has an area per turn of 1.1 ×
10-2...
asked 5 hours ago -
Draw a combinational logic circuit diagram with a symbol inside
the box for two I/P of...
asked 5 hours ago -
The cliché we use quite a lot in finance is: there is a need to
maximize...
asked 5 hours ago -
In class we discussed the addition of HCl to alpha pinene. Would
you expect one or...
asked 5 hours ago