Question

Calculate the work that the friction force (air resistance) does on a ball over a vertical fall.

Heigh which the ball is dropped from: 800m

mass of ball: 0.046kg

Friction force is defined as:

f=k\cdot v^2

k 4.4 . 10-4

0 0
Add a comment Improve this question Transcribed image text
Answer #1

The initial condition:

distance covered by the ball = 0m
Force on the ball = tg ,
m is the mass of the ball.

Lets imagine an arbitrary position at distance s from the release point with velocity v.

acceleration,

ds (When v =0 s-0, v-v then s-s kv2 also substituting u-g and integrating) -log.

We put in s = 800m and
Putting in all the values in this equation we get.

u1025.59 - this is the final kinetic energy.

Initial potential energy,

mqh- 0.046 9.81 800361.0.J

So work done by the friction:

W-23.5-361.0-_337.5J
(near about 340J)

Add a comment
Know the answer?
Add Answer to:
Calculate the work that the friction force (air resistance) does on a ball over a vertical...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • A ball is thrown straight up at speed in the presence of gravity. (a) Ignoring air...

    A ball is thrown straight up at speed in the presence of gravity. (a) Ignoring air resistance at first, what is the maximum height the ball reaches? (b) Now include Newtonian (quadratic) air resistance, with drag coefficient c. Letting the direction point upwards, write down the equation of motion (be careful with the signs). (c) Solve the equation of motion to find v(t)(= (t)). Remember to check that v(0) = . (d) Without integrating anything yet, calculate the time at...

  • Red and blue balls fall from rest at the same instant and encounter no appreciable air...

    Red and blue balls fall from rest at the same instant and encounter no appreciable air resistance, but the red ball started from a height above the ground that was three times as high as that for the blue ball. If the red ball takes time T to reach the ground, the time that the blue ball takes is: A. B. C. D. We were unable to transcribe this imageWe were unable to transcribe this imageWe were unable to transcribe...

  • A rod of length L, mass m , and R resistance slides down with no friction....

    A rod of length L, mass m , and R resistance slides down with no friction. A set of two conducting, parallel railings with negligible resistance (held at an angle to the ground). A constant magnetic field B is present everywhere and is directed upwards (perpendicular to the ground) For the following values: What is the velocity of the rod at equilibrium ? (g=10m/s^2) We were unable to transcribe this imageWe were unable to transcribe this image

  • A rod of length L, mass m , and R resistance slides down with no friction....

    A rod of length L, mass m , and R resistance slides down with no friction. A set of two conducting, parallel railings with negligible resistance (held at an angle to the ground). A constant magnetic field B is present everywhere and is directed upwards (perpendicular to the ground) For the following values: What is the velocity of the rod at equilibrium ? (g=10m/s^2) We were unable to transcribe this imageWe were unable to transcribe this image

  • A ball of mass M is attached to one end of a spring of stiffness k...

    A ball of mass M is attached to one end of a spring of stiffness k and relaxed length L0. The other end of the spring is attached to the ceiling. When the ball hangs at rest in equilibrium at the end of the spring it is located at the origin of the coordinate system shown and the spring’s length is Leq. a. The figure shows the ball at position . What are the components of the vector Li that...

  • 1. A formula that could be used to measure the force of friction is Ff <...

    1. A formula that could be used to measure the force of friction is Ff < mFN. If you were given a force measuring device (e.g., spring scale, force probe) and an object, describe in a few sentences the procedure that one could use to determine the coefficient of static friction. If you were given a force measuring device (e.g., spring scale, force probe) and an object, describe in a few sentences the procedure that one could use to determine...

  • A 60-cm-diameter, 300 g beach ball is dropped with a 4.0 mg ant riding on the...

    A 60-cm-diameter, 300 g beach ball is dropped with a 4.0 mg ant riding on the top. The ball experiences air resistance, but the ant does not. What is the magnitude of the normal force exerted on the ant when the ball's speed is 3.5 m/s? Can you explain and show in detail how to get the answer. What would rho and the drag coefficient be? I've tried using 1.2 kg/m3 as rho and .5 for the drag coefficient, where...

  • A heavy ball of mass m moves in an inclined tube (making an angle with the...

    A heavy ball of mass m moves in an inclined tube (making an angle with the vertical), which rotates at a constant angular speed about a vertical axis. Determine the law of motion and the lateral pressure on the wall. We were unable to transcribe this imageWe were unable to transcribe this image

  • a particle of mass m is given velocity on rough horizontal surface Coefficient of friction is...

    a particle of mass m is given velocity on rough horizontal surface Coefficient of friction is there is also variable external force acts on particle given by F=kV where K is constant & V is instaneous velocity direction of force at any instant is perpendicular to velocity the particle moves in an instaneous circular path of variable radius then time taken by particle to stop is time taken to reduce the angle between acceleration and velocity from to is Total...

  • A square loop of length a and resistance R, is dropped from a height of h....

    A square loop of length a and resistance R, is dropped from a height of h. A magnetic field exists everywhere, perpendicular to the loop area which varies with height according to: Given: a=8.3 m, R=2.3, h=0.7m, =6.9T, D=5.9m What is the current in the loop at the moment of impact with the group? Neglect the force the magnetic field exerts on the loop, give a positive answer in ampere, and use g=10m/s^2 We were unable to transcribe this imageWe...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT