Homework Answers
Add Answer to:
A unity gain negative feedback system has an open-loop transfer function given by 4. s) =...
A unity feedback system has the following open-loop gain function 10 s(s+2) Use MATLAB to plot...
A unity feedback system has the following open-loop gain function 10 s(s+2) Use MATLAB to plot the Bode plot of this system Find the gain and phase margin. Identify these margins on the Bode plot. Is the G(s) a. b. system stable?
3. Construct the bode plot on a semilog Graph-paper for a unity feedback system whose open...
Construct the bode plot on a semilog Graph-paper for a unity feedback system whose open looptransfer function is given by \(G(S)=\frac{100}{S(S+1)(2+S)} .\) From the bode plot determinea) Gain and phase crossover frequencies.b) Gain and Phase margin, andc) Stability of the closed loop system
Spring 2019 3. Given a closed-loop control system with unity feedback is shown in the block...
Spring 2019 3. Given a closed-loop control system with unity feedback is shown in the block diagram. G(s) is the open-loop transfer function, and the controller is a gain, K. 1. (20) Calculate the open-loop transfer function tar →Q--t G(s) (10) Calculate the steady-state error to a step input of the open-loop system. 7. (in Bode Form) from the Bode plot. (10) Calculate the shortest possible settling time with a percentage overshoot of 5% or less. 8. 2. (10)Plot the...
QUESTION 4 A unity feedback system has open-loop transfer function G(S). Polar plot of G(jw) is...
QUESTION 4 A unity feedback system has open-loop transfer function G(S). Polar plot of G(jw) is shown in the figure below. The gain margin (GM) and the phase margin (ØM) of the feedback system are None of the answers is correct b. GM = 0.3 and ØM = 112.33º O GM = -0.3 and ØM = 112.33 d. GM = 3.33 and ØM = 67.67° QUESTION 8 A unity feedback system as open-loop transfer function G(s) = 5(1 +ST) The...
1. A unity feedback system has open-loop transfer function given by an 100 G(s)s2)(s +4) a....
1. A unity feedback system has open-loop transfer function given by an 100 G(s)s2)(s +4) a. Use analytical techniques (i.e. without using any plots) to estimate the closed-loop: i. Resonant frequency, w (8 marks) ii. Resonance peak, Mp (in decibels) (2 marks) i. Phase at w = 3rad/s (2 marks) b. Obtain a table for the response of the open-loop transfer function for a set S of frequency values, where S {1.5,3,5,7, 10, 15, 20} rad/s (8 marks) Hence draw...
Problem 3. For the above feedback system, the bode diagram of the stable open-loop transfer function...
Problem 3. For the above feedback system, the bode diagram of the stable open-loop transfer function G(s) is plotted below: (a) Find the approximate gain margin and phase margin of the system? Is the closed-loop system stable? (b) Suppose in the closed-loop system (s) is replaced with KG(8). What is the range of K so that the closed-loop system is stable? (C) Determine the system type of G(s). (d) Estimate the steady-state errors of the closed-loop system for tracking the...
7. For a negative feedback control system with unit feedback gain, its open-loop 100 transfer function...
7. For a negative feedback control system with unit feedback gain, its open-loop 100 transfer function is G (s) Design a PID controller, so that the open s(10s) corresponding closed-loop poles are -2+jl and -5. (10 scores)
7. For a negative feedback control system with unit feedback gain, its open-loop 100 transfer function is G (s) Design a PID controller, so that the open s(10s) corresponding closed-loop poles are -2+jl and -5. (10 scores)
1. A unity feedback system has open-loop transfer function given by an 100 G(s)s2)(s +4) a....
1. A unity feedback system has open-loop transfer function given by an 100 G(s)s2)(s +4) a. Use analytical techniques (i.e. without using any plots) to estimate the closed-loop: i. Resonant frequency, w (8 marks) ii. Resonance peak, Mp (in decibels) (2 marks) i. Phase at w = 3rad/s (2 marks) b. Obtain a table for the response of the open-loop transfer function for a set S of frequency values, where S {1.5,3,5,7, 10, 15, 20} rad/s (8 marks) Hence draw...
5. The open loop transfer function of a control system is s(1 +0.5s)(1 0.67s) Draw a Bode diagram...
5. The open loop transfer function of a control system is s(1 +0.5s)(1 0.67s) Draw a Bode diagram for the system and determine the phase margin and gain margin. Is the closed loop system stable? (a) (17 marks) (b) By how much must the gain be adjusted for a phase margin of 50°? (8 marks)
5. The open loop transfer function of a control system is s(1 +0.5s)(1 0.67s) Draw a Bode diagram for the system and determine the phase...
please solve If a system has the open-loop transfer function G(s) s(s+25n) with unity feedback, then the closed-loop tr...
please solve
If a system has the open-loop transfer function G(s) s(s+25n) with unity feedback, then the closed-loop transfer function is given b T(s) s2+20ns+wf Verify the values of the PM shown in Fig. 6.36 for = 0.1,0.4, and 0.7. Figure 6.36 Damping ratio versus 1.0 0.8 PM 2 0.6 0,4 0.2 0 0° 10° 20° 30° 40° 50 60° 70° 80° Phase margin Damping ratio,
If a system has the open-loop transfer function G(s) s(s+25n) with unity feedback, then...
A unity feedback system has the following open-loop gain function 10 s(s+2) Use MATLAB to plot the Bode plot of this system Find the gain and phase margin. Identify these margins on the Bode plot. Is the G(s) a. b. system stable?
Construct the bode plot on a semilog Graph-paper for a unity feedback system whose open looptransfer function is given by \(G(S)=\frac{100}{S(S+1)(2+S)} .\) From the bode plot determinea) Gain and phase crossover frequencies.b) Gain and Phase margin, andc) Stability of the closed loop system
Spring 2019 3. Given a closed-loop control system with unity feedback is shown in the block diagram. G(s) is the open-loop transfer function, and the controller is a gain, K. 1. (20) Calculate the open-loop transfer function tar →Q--t G(s) (10) Calculate the steady-state error to a step input of the open-loop system. 7. (in Bode Form) from the Bode plot. (10) Calculate the shortest possible settling time with a percentage overshoot of 5% or less. 8. 2. (10)Plot the...
QUESTION 4 A unity feedback system has open-loop transfer function G(S). Polar plot of G(jw) is shown in the figure below. The gain margin (GM) and the phase margin (ØM) of the feedback system are None of the answers is correct b. GM = 0.3 and ØM = 112.33º O GM = -0.3 and ØM = 112.33 d. GM = 3.33 and ØM = 67.67° QUESTION 8 A unity feedback system as open-loop transfer function G(s) = 5(1 +ST) The...
1. A unity feedback system has open-loop transfer function given by an 100 G(s)s2)(s +4) a. Use analytical techniques (i.e. without using any plots) to estimate the closed-loop: i. Resonant frequency, w (8 marks) ii. Resonance peak, Mp (in decibels) (2 marks) i. Phase at w = 3rad/s (2 marks) b. Obtain a table for the response of the open-loop transfer function for a set S of frequency values, where S {1.5,3,5,7, 10, 15, 20} rad/s (8 marks) Hence draw...
Problem 3. For the above feedback system, the bode diagram of the stable open-loop transfer function G(s) is plotted below: (a) Find the approximate gain margin and phase margin of the system? Is the closed-loop system stable? (b) Suppose in the closed-loop system (s) is replaced with KG(8). What is the range of K so that the closed-loop system is stable? (C) Determine the system type of G(s). (d) Estimate the steady-state errors of the closed-loop system for tracking the...
7. For a negative feedback control system with unit feedback gain, its open-loop 100 transfer function is G (s) Design a PID controller, so that the open s(10s) corresponding closed-loop poles are -2+jl and -5. (10 scores)
7. For a negative feedback control system with unit feedback gain, its open-loop 100 transfer function is G (s) Design a PID controller, so that the open s(10s) corresponding closed-loop poles are -2+jl and -5. (10 scores)
1. A unity feedback system has open-loop transfer function given by an 100 G(s)s2)(s +4) a. Use analytical techniques (i.e. without using any plots) to estimate the closed-loop: i. Resonant frequency, w (8 marks) ii. Resonance peak, Mp (in decibels) (2 marks) i. Phase at w = 3rad/s (2 marks) b. Obtain a table for the response of the open-loop transfer function for a set S of frequency values, where S {1.5,3,5,7, 10, 15, 20} rad/s (8 marks) Hence draw...
5. The open loop transfer function of a control system is s(1 +0.5s)(1 0.67s) Draw a Bode diagram for the system and determine the phase margin and gain margin. Is the closed loop system stable? (a) (17 marks) (b) By how much must the gain be adjusted for a phase margin of 50°? (8 marks)
5. The open loop transfer function of a control system is s(1 +0.5s)(1 0.67s) Draw a Bode diagram for the system and determine the phase...
please solve
If a system has the open-loop transfer function G(s) s(s+25n) with unity feedback, then the closed-loop transfer function is given b T(s) s2+20ns+wf Verify the values of the PM shown in Fig. 6.36 for = 0.1,0.4, and 0.7. Figure 6.36 Damping ratio versus 1.0 0.8 PM 2 0.6 0,4 0.2 0 0° 10° 20° 30° 40° 50 60° 70° 80° Phase margin Damping ratio,
If a system has the open-loop transfer function G(s) s(s+25n) with unity feedback, then...
Most questions answered within 3 hours.
-
The lifetime of a physical mechanism is given as f(x) = {(c/x^2
if 1< x <...
asked 3 minutes ago -
Please help me with this problem below
What is wrong with the following code?
if income...
asked 12 minutes ago -
The following information for the past year is available from
Thinnews Co., a company that uses...
asked 16 minutes ago -
Suppose you work for Allstate, and insurance company and the
data shows the following for auto...
asked 16 minutes ago -
The fresh fruit market and frozen dinner market are
currently in equilibrium. Fresh fruit is a...
asked 21 minutes ago -
(1 point) Golf-course designers have become concerned that old
courses are becoming obsolete since new technology...
asked 19 minutes ago -
The active retelling of dominant cultural stories is known
preserves which concept?
hegemony
heterodoxy
doxa
myth
asked 23 minutes ago -
1. Which of the following statements is true of money?
It is anything accepted in exchange...
asked 23 minutes ago -
BASED ON THE AIRBNB, ETSY, UBER: GROWING FROM ONE THOUSAND TO
ONE MILLION CUSTOMERS HARVARD CASE:...
asked 49 minutes ago -
Which of these methods cause sterilization?
Autoclaving
Dry heat
Gamma irradiation
Ethylene oxide
A.
Yes
No...
asked 55 minutes ago -
A biologist wishes to estimate the effect of an antibiotic on
the growth of a particular...
asked 1 hour ago -
O’Deesha Company has the following information available:
Quality engineering of
products
$20,000
Quality training of
employees &n
asked 1 hour ago