1.) Consider the gas turbine with air-standard Brayton cycle shown below Temperature, T and Pressure, P...
1.) Consider the gas turbine with air-standard Brayton cycle shown below Temperature, T and Pressure, P are measured at the following points in the cycle: Turbine: input: TH = 1200 K, PH = 800 kPa output: TL = 662.4 K, PL = 100 kPa Compressor: input Tc = 300 K, Pc = 100 kPa output: Th = 543.4 K, Ph = 800 kPa Note: the working fluid is air which has Cp = 1.005 kJ/kg.K, k = 1.4, R = 287 J/kg.K If the air flow rate in the cycle is 2 kg/sec., determine the following:
i) (10%) Heat input rate, QH
ii) (15%) Net work output Wnet
iii)(10%) Heat rate of this power plant
Homework Answers
Add Answer to:
1.) Consider the gas turbine with air-standard Brayton cycle
shown below Temperature, T and Pressure, P...
An air-standard Brayton cycle includes a regenerator which is shown in the below figure. The air...
An air-standard Brayton cycle includes a regenerator which is shown in the below figure. The air enters the compressor at 100 kPa, 20℃. The pressure ratio across the compressor is 9:1. The highest temperature in the cycle is 1100℃, and the flow rate of the air is 10 kg/s. The regenerator operates at effectiveness 80 percent. Both the efficiencies of the turbine and the compressor are 85%. Do not use Table A-22. Assuming constant specific heat ( cp = 1.004...
An aircraft engine operates on a simple ideal Brayton cycle with a pressure ratio rp of...
An aircraft engine operates on a simple ideal Brayton cycle with
a pressure ratio rp of 9. Heat is added to the cycle at a rate of
490 kW; air passes through the engine at a rate of 1.1 kg/s; and
the air at the beginning of the compression is at P1 = 71 kPa and
T1 = 0 oC. Use constant specific heats at room temperature. The
properties of air at room temperature are cp =1.005 kJ/kg.K and k...
Need help for this Brayton Cycle problem. Please help me 4. (30 marks) A gas-turbine power plant operates on the simple...
Need help for this Brayton Cycle problem.
Please help me
4. (30 marks) A gas-turbine power plant operates on the simple Brayton cycle between the pressure limits of 100 kPa and 800 kPa. The T-s diagram of this cycle is shown in Fig. 2. Air enters the compressor at 30°C and leaves at 330°C at a mass flow rate of 200 kg/s. The maximum cycle temperature is 1400 K. During operation of the cycle, the net power output is measured...
Use a simple Brayton cycle gas turbine as the baseline for the following questions. Use a...
Use a simple Brayton cycle gas turbine as the baseline for the
following questions. Use a cold-air-standard analysis (R=0.287
kJ/kg-K, k=Cp/Cv=1.40, Cp= (k/(k-1))*R = 1.0045 kJ/kg-K) with the
following specifications:
Use a simple Brayton cycle gas turbine as the baseline for the following questions. Use a cold-air-standard analysis (R=0.287 kJ/kg-K, k=Cp/Cv=1.40, Cpr (k/(k-1))*R = 1.0045 kJ/kg-K) with the following specifications: Mass Inlet Press. Pressure Turbine Isentropic Eff Neglect combustion chemistry Flowrate T p Ratio Inlet T Comp Turb Neglect minor...
in Problem II: The Brayton cycle is an idealized gas turbine power cycle that can be...
in Problem II: The Brayton cycle is an idealized gas turbine power cycle that can be modeled through the four reversible steady flow devices shown in the diagram. Use air as the working fluid with variable specific heats. Heat If the thermal source is at 700°C, and the thermal sink is at 35℃ what is the maximum thermal efficiency for a cycle operating between these two thermal reservoirs? (5 pts) A. CompressorTurbine B. In the real cycle, air enters the...
2. Consider a combined gas steam power cycle. The gas cycle is a simple Brayton cycle...
2. Consider a combined gas steam power cycle. The gas cycle is a
simple Brayton cycle that has a pressure ratio of 7. Air enters at
9.8 kg / s at the compressor at 15 ° C and 100 kPa, and at the gas
turbine at 950 ° C. The steam cycle is a Rankine cycle with
overheating between the pressure limits of 6 MPa and 10 kPa. The
water vapor is heated in the heat exchanger at a rate...
The refrigerant gas which is air, enters the compressor of a Brayton refrigeration cycle at 101...
The refrigerant gas which is air, enters the compressor of a Brayton refrigeration cycle at 101 kPa, 280 K. If the compressor pressure ratio is 5 and the turbine inlet temperature is 330 K. The compressor has an isentropic efficiency of 70% and the turbine has an isentropic efficiency of 80%. Using air table rather than constant-specific-heat theory, determine (a) the net work input per unit mass of air flow, (b) the refrigeration capacity, in kJ/kg, (c) the coefficient of...
A brayton cycle operates with a gas mixture of 78% nitrogen, 21% oxygen, and 1% carbon...
A brayton cycle operates with a gas mixture of 78% nitrogen, 21% oxygen, and 1% carbon dioxide by volume. The gas mixture enters the isothermal compressor at 100 kPa and 298 K, and exits the compressor at 800 kPa. In the constant pressure heat exchanger, the gas mixture is heated to 1000 K. At the exit of the turbine, the gas mixture is at 400 K. Determine a) the work input to the compressor, b) the heat addition in the...
A simple ideal Brayton cycle operates with air with minimum and maximum temperatures of 27°C and...
A simple ideal Brayton cycle operates with air with minimum and
maximum temperatures of 27°C and 727°C. It is designed so that the
maximum cycle pressure is 2000 kPa and the minimum cycle pressure
is 100 kPa. The isentropic efficiency of the turbine is 96 percent.
Determine the net work produced per unit mass of air each time this
cycle is executed and the cycle’s thermal efficiency. Use constant
specific heats at room temperature. The properties of air at room...
2. Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 300 K,...
2. Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 300 K, with a volumetnc flow rate of 20 m'/s. The turbine inlet temperature is 1500 K. For compressor pressure ratios of 20 find a) the heat addition and rejection in kW b) the net power developed, in kW c) the thermal efficiency of the cycle d) the back work ratio.
An aircraft engine operates on a simple ideal Brayton cycle with
a pressure ratio rp of 9. Heat is added to the cycle at a rate of
490 kW; air passes through the engine at a rate of 1.1 kg/s; and
the air at the beginning of the compression is at P1 = 71 kPa and
T1 = 0 oC. Use constant specific heats at room temperature. The
properties of air at room temperature are cp =1.005 kJ/kg.K and k...
Need help for this Brayton Cycle problem.
Please help me
4. (30 marks) A gas-turbine power plant operates on the simple Brayton cycle between the pressure limits of 100 kPa and 800 kPa. The T-s diagram of this cycle is shown in Fig. 2. Air enters the compressor at 30°C and leaves at 330°C at a mass flow rate of 200 kg/s. The maximum cycle temperature is 1400 K. During operation of the cycle, the net power output is measured...
Use a simple Brayton cycle gas turbine as the baseline for the
following questions. Use a cold-air-standard analysis (R=0.287
kJ/kg-K, k=Cp/Cv=1.40, Cp= (k/(k-1))*R = 1.0045 kJ/kg-K) with the
following specifications:
Use a simple Brayton cycle gas turbine as the baseline for the following questions. Use a cold-air-standard analysis (R=0.287 kJ/kg-K, k=Cp/Cv=1.40, Cpr (k/(k-1))*R = 1.0045 kJ/kg-K) with the following specifications: Mass Inlet Press. Pressure Turbine Isentropic Eff Neglect combustion chemistry Flowrate T p Ratio Inlet T Comp Turb Neglect minor...
in Problem II: The Brayton cycle is an idealized gas turbine power cycle that can be modeled through the four reversible steady flow devices shown in the diagram. Use air as the working fluid with variable specific heats. Heat If the thermal source is at 700°C, and the thermal sink is at 35℃ what is the maximum thermal efficiency for a cycle operating between these two thermal reservoirs? (5 pts) A. CompressorTurbine B. In the real cycle, air enters the...
2. Consider a combined gas steam power cycle. The gas cycle is a
simple Brayton cycle that has a pressure ratio of 7. Air enters at
9.8 kg / s at the compressor at 15 ° C and 100 kPa, and at the gas
turbine at 950 ° C. The steam cycle is a Rankine cycle with
overheating between the pressure limits of 6 MPa and 10 kPa. The
water vapor is heated in the heat exchanger at a rate...
A simple ideal Brayton cycle operates with air with minimum and
maximum temperatures of 27°C and 727°C. It is designed so that the
maximum cycle pressure is 2000 kPa and the minimum cycle pressure
is 100 kPa. The isentropic efficiency of the turbine is 96 percent.
Determine the net work produced per unit mass of air each time this
cycle is executed and the cycle’s thermal efficiency. Use constant
specific heats at room temperature. The properties of air at room...
2. Air enters the compressor of an ideal air-standard Brayton cycle at 100 kPa, 300 K, with a volumetnc flow rate of 20 m'/s. The turbine inlet temperature is 1500 K. For compressor pressure ratios of 20 find a) the heat addition and rejection in kW b) the net power developed, in kW c) the thermal efficiency of the cycle d) the back work ratio.
Most questions answered within 3 hours.
-
Industry: Telecommunications in India
Here, you need to discuss the sources of the growth pattern
and...
asked 16 minutes ago -
Hydrobromic acid
dissolves solid iron according to the followiaung reaction:
Fe(s)+2HBr(aq)→
FeBr2(aq)+ H2(g)
Part A. What...
asked 1 hour ago -
Verify the following vector identity in SPHERICAL
COORDINATES.
div(curl(A)) = 0
asked 3 hours ago -
The work function (Φ) for a metal is 7.50×10-19 J.
What is the longest wavelength (nm)...
asked 4 hours ago -
1. Would the following procedural changes cause the
calculated mass percent Ni2+ ion in Ni(NH3)nCl2 to...
asked 5 hours ago -
1. Why does the voltage of the capacitor vary with frequency?
where does this missing voltage...
asked 7 hours ago -
p p please write each step out clearly
3. A manager of a company is considering...
asked 6 hours ago -
On October 1, Ebony Ernst organized Ernst Consulting; on October
3, the owner contributed $83,540 in...
asked 7 hours ago -
A.)As an electron moves through a region of space, its speed
decreases from 9.60 × 106...
asked 7 hours ago -
In java with the netbeans program do:
Through object programming
Create a class "ContadorP", which is...
asked 7 hours ago -
Pattern Corporation acquired all of Science
Company's outstanding stock on January 1, 2016 for $600,000 cash....
asked 7 hours ago -
Here are all accounts Tyler Co. maintains.
Tax expenses $4,750
Common stocks $48,840
SG&A expenses $2,500...
asked 7 hours ago