A 2D flow has the pressure and velocity fields given below. Calculate the total force, pressure...
A 2D flow has the pressure and velocity fields given below. Calculate the total force, pressure force, viscous force, and body force acting on a fluid particle located at (?,?)=(2,−2) m. Assume that the density and dynamic viscosity are constant and given by 1000 kg/m3 and 10-3 kg/(m s), respectively.
?̅ =(1+?2)?̂+(1−?2)? ̂ m/s
?=(?+?) kPa
Homework Answers
Add Answer to:
A 2D flow has the pressure and velocity fields given below.
Calculate the total force, pressure...
help Fluid enters to the section of the pipe as shown in the figure below. Density...
help
Fluid enters to the section of the pipe as shown in the figure below. Density and dynamic viscosity of the fluid are 1000 kg/mº and 8.90 x 10-4 Pa's respectively. A pressure of the fluid at point A is 30 kPa and diameter of the pipe is 100 mm. Find the volumetric flow rate of the fluid at B. Flow is laminar and viscous, consider the pressure loss. 4 m B 100 mm
Problem M.7 The velocity and pressure are given at two points in the flow field. Assume...
Problem M.7 The velocity and pressure are given at two points in the flow field. Assume that the two points lie in a horizontal plane and that the fluid density is uniform in the flow field and is equal to 1000 kg/m3. Assume steady flow. Do necessary computation, then determine which of the following statements is true (a) The flow in the contraction is nonuniform and irrotational. (b) The flow in the contraction is uniform and irrotational. (c) The flow...
The drag force Fp on a smooth sphere falling in water depends on the sphere speed...
The drag force Fp on a smooth sphere falling in water depends on
the sphere speed V, the sphere density P. the density p and dynamic
viscosity of water, the sphere diameter Dand the gravitational
acceleration g. Using dimensional analysis with p. V and D as
repeating variables, determine suitable dimensionless groups to
obtain a reneral relationship between the drag force and the other
variables. If the same sphere were to fall through air, determine
the ratio of the drag...
Problem 3. A 2D velocity field for an incompressible Newtonian fluid is given by u 12xy-62.3,...
Problem 3. A 2D velocity field for an incompressible Newtonian fluid is given by u 12xy-62.3, u = 18x2y-4y3, where the velocity has unit m/s and x and y are in meters. (a) Determine the normal stresses ơzz and ơuy, and shear stress Try at the point x-1 m, y 1 m, where the pressure at this point is 6 kPa and dynamic viscosity is 1 Pa.s. (b) Sketch the magnitude and direction of the stress components.
24.54 The pressure gradient for laminar flow through a constant radius tube is given by where p-p...
24.54 The pressure gradient for laminar flow through a constant radius tube is given by where p-pressure (Nm, x (m's), and r= radius (m). distance along the tube's centerline (m), μ dynamic viscosity (N·sm2), Q-flow a. Determine the pressure drop for a 10-cm length tube for a viscous liquid (u 0.005 N s/m2, density - 1x 103 kgm)with a flow of 10x 10-5 m3/s and the following varying radii along its length, x, cm 2 r, mm 2 1.35 1.34...
Required information The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air...
Required information The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air at this pressure and at 25°C flows with a velocity of 12 m/s over a 2.5-mx 5-m flat plate. The dynamic viscosity is independent of pressure, and for air at 25°C, it is H- 1.849 10 kg/m s. The air density at 25°C 298 K and 83.4 kPa is 0.9751 kg/m3 Calculate the drag force acting on the top surface of the plate if...
Question 2 4 pts Question 1lb) If viscous effects are negligible, determine the flow rate Qt (m3/s) at Point 1 in the large pipe if h-5.8 m and V2 66m/s The density of water is 1000 kg/m3. Atm...
Question 2 4 pts Question 1lb) If viscous effects are negligible, determine the flow rate Qt (m3/s) at Point 1 in the large pipe if h-5.8 m and V2 66m/s The density of water is 1000 kg/m3. Atmospheric pressure Patm 101.325 kPa. Gravitational acceleration g- 9.81 m/s Your answer should be in m3/s and accurate to4d.р. Question 3 3 pts If viscous effects are negligible, determine the gauge pressure p1 (kPa) at Point 1 in the large pipe for Q1...
Consider the nozzle given below. The nozzle exit has an area 0.0011 m^2 and a pressure...
Consider the nozzle given below. The nozzle exit has an area
0.0011 m^2 and a pressure of 0 kPa (gauge). Given the mass flow and
cross sectional area of the nozzle entrance, what is the pressure
at the nozzle entrance (P1) ? Give the answer in kPa gauge, but do
not enter the units in the answer box. The fluid is water with a
density of 1000 kg/m^3. Ignore work and friction. The external
force is still unknown.
mass flow...
Question 2 Figure 2: Flow between two inclined plates Consider a two-dimensional plates, as shown in...
Question 2 Figure 2: Flow between two inclined plates Consider a two-dimensional plates, as shown in figure 2. Assume that pressure increases 30°. Acceleration due t o Pa and the channel height is h 10 cm inclined at te the velocity profile of the flow. State your assumptions and show your work. onal Newtonian, steady state, incompressible flow of a fluid be- by 1 kPa/ a dynamic viscosity of H1-1 x 10 amic viscosity of uo wall towards the right....
Q1. (a) For a flow phenomenon governed mainly by viscous forces, derive the scale factors for...
Q1. (a) For a flow phenomenon governed mainly by viscous forces, derive the scale factors for velocity, force and power in terms of 24, , and I, where subscripts L, p and u are length, density and dynamic viscosity respectively and is the ratio of the value of "x" in the prototype to the value of "x" in the model. [4 marks) (b) Volumetric flow rate (discharge) Q through a circular pipe with diameter D can be measured by measuring...
help
Fluid enters to the section of the pipe as shown in the figure below. Density and dynamic viscosity of the fluid are 1000 kg/mº and 8.90 x 10-4 Pa's respectively. A pressure of the fluid at point A is 30 kPa and diameter of the pipe is 100 mm. Find the volumetric flow rate of the fluid at B. Flow is laminar and viscous, consider the pressure loss. 4 m B 100 mm
Problem M.7 The velocity and pressure are given at two points in the flow field. Assume that the two points lie in a horizontal plane and that the fluid density is uniform in the flow field and is equal to 1000 kg/m3. Assume steady flow. Do necessary computation, then determine which of the following statements is true (a) The flow in the contraction is nonuniform and irrotational. (b) The flow in the contraction is uniform and irrotational. (c) The flow...
The drag force Fp on a smooth sphere falling in water depends on
the sphere speed V, the sphere density P. the density p and dynamic
viscosity of water, the sphere diameter Dand the gravitational
acceleration g. Using dimensional analysis with p. V and D as
repeating variables, determine suitable dimensionless groups to
obtain a reneral relationship between the drag force and the other
variables. If the same sphere were to fall through air, determine
the ratio of the drag...
Problem 3. A 2D velocity field for an incompressible Newtonian fluid is given by u 12xy-62.3, u = 18x2y-4y3, where the velocity has unit m/s and x and y are in meters. (a) Determine the normal stresses ơzz and ơuy, and shear stress Try at the point x-1 m, y 1 m, where the pressure at this point is 6 kPa and dynamic viscosity is 1 Pa.s. (b) Sketch the magnitude and direction of the stress components.
24.54 The pressure gradient for laminar flow through a constant radius tube is given by where p-pressure (Nm, x (m's), and r= radius (m). distance along the tube's centerline (m), μ dynamic viscosity (N·sm2), Q-flow a. Determine the pressure drop for a 10-cm length tube for a viscous liquid (u 0.005 N s/m2, density - 1x 103 kgm)with a flow of 10x 10-5 m3/s and the following varying radii along its length, x, cm 2 r, mm 2 1.35 1.34...
Required information The local atmospheric pressure in Denver, Colorado (elevation 1610 m) is 83.4 kPa. Air at this pressure and at 25°C flows with a velocity of 12 m/s over a 2.5-mx 5-m flat plate. The dynamic viscosity is independent of pressure, and for air at 25°C, it is H- 1.849 10 kg/m s. The air density at 25°C 298 K and 83.4 kPa is 0.9751 kg/m3 Calculate the drag force acting on the top surface of the plate if...
Question 2 4 pts Question 1lb) If viscous effects are negligible, determine the flow rate Qt (m3/s) at Point 1 in the large pipe if h-5.8 m and V2 66m/s The density of water is 1000 kg/m3. Atmospheric pressure Patm 101.325 kPa. Gravitational acceleration g- 9.81 m/s Your answer should be in m3/s and accurate to4d.р. Question 3 3 pts If viscous effects are negligible, determine the gauge pressure p1 (kPa) at Point 1 in the large pipe for Q1...
Consider the nozzle given below. The nozzle exit has an area
0.0011 m^2 and a pressure of 0 kPa (gauge). Given the mass flow and
cross sectional area of the nozzle entrance, what is the pressure
at the nozzle entrance (P1) ? Give the answer in kPa gauge, but do
not enter the units in the answer box. The fluid is water with a
density of 1000 kg/m^3. Ignore work and friction. The external
force is still unknown.
mass flow...
Question 2 Figure 2: Flow between two inclined plates Consider a two-dimensional plates, as shown in figure 2. Assume that pressure increases 30°. Acceleration due t o Pa and the channel height is h 10 cm inclined at te the velocity profile of the flow. State your assumptions and show your work. onal Newtonian, steady state, incompressible flow of a fluid be- by 1 kPa/ a dynamic viscosity of H1-1 x 10 amic viscosity of uo wall towards the right....
Q1. (a) For a flow phenomenon governed mainly by viscous forces, derive the scale factors for velocity, force and power in terms of 24, , and I, where subscripts L, p and u are length, density and dynamic viscosity respectively and is the ratio of the value of "x" in the prototype to the value of "x" in the model. [4 marks) (b) Volumetric flow rate (discharge) Q through a circular pipe with diameter D can be measured by measuring...
Most questions answered within 3 hours.
-
Hello, can someone please help me answer this question?
How much heat is absorbed by a...
asked 11 minutes ago -
A business executive has the option to invest money in two
plans: Plan A guarantees that...
asked 12 minutes ago -
. A marketing researcher conducted a survey of 25 shoppers
randomly selected at the local mall...
asked 27 minutes ago -
Create an comprehensive response to the
following:
Antimicrobial agents work on a multitude of microbes (bacteria,...
asked 29 minutes ago -
6.13 LAB: Step counter. Section 6.3.
A pedometer treats walking 2,000 steps as walking 1 mile....
asked 24 minutes ago -
(14.2) A block of mass m = 10 kg riding on a frictionless
horizontal plane is...
asked 27 minutes ago -
Use any search engine to search for articles about Starbucks
partnership with Tata Companies in India...
asked 26 minutes ago -
Let’s say that for some reason Bank Excess Reserves suddenly
increase sharply. What effect would this...
asked 35 minutes ago -
Given:
Curent Assets: $600,000
Total Assets: $2,600,000
Current Liabilities: $500,000
Total Liabilities: $1,700,000
What is the...
asked 40 minutes ago -
1. What is a “Bankster”? What is insider trading? Why is it
illegal?
2. What is...
asked 38 minutes ago -
A transverse wave on a cord is given by
D(x,t)=0.18sin(2.7x−61.0t), where Dand x are in m...
asked 45 minutes ago -
ASSIGNMENT
ANSWER ANY TWO OF THE FOLLOWING IN 2-3 PARAGRAPHS OF EACH
QUESTION.
1: Where is...
asked 43 minutes ago