comparator and amplifier Design an alarm system T<160°C if P>10Pa. to detect a process condition The...
Title: Combinational Circuit Design and Simulation Objectives: a. b. c. Design combinational circuit Verify design with simulation Verify design with laboratory test data Materials Needed IBM Compatible computer, PSpice software, IC Chips (as needed), Data Switches, 4702 (1), LED (1). Pre-Lab: Problem Statement The four parameters in a chemical process control system to be monitored are temperature (T), pressure (P), flow (F), and level (L) of the fluid. The parameters are monitored by sensor circuits that produce a High logic...
Consider the unity-feedback system shown below: R(s) E(s) input: r(t), output: y(t) C(s) P(s) error: e() r(t) y(t) closed-loop transfer-function: Hyr(sD t the closed-loop transfer-function be Hyr(s) Y (s) R(s) Let the transfer-function of the plant be P(s) 10 s (s 1) (s 5) The open-loop transfer-function is G(s) P(s) C(s) DESIGN OBJECTIVES: Find a controller C(s) such that the following are satisfied i) The closed-loop system is stable. ii) The steady-state error ess due to a unit-ramp input r(t)...
summatize the following info and break them into differeng key points. write them in yojr own words
apartus
6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...