A 17.0 m-high and 12.0 m-long wall under construction and its bracing are shown in the...

Question

Question

A 17.0 m-high and 12.0 m-long wall under construction and its bracing are shown in the figure below. The wall is in stable eq

Answer 1

Answer #1

Second condition of caulibrium 31, wind 1 twind - 1x10FB - 1. Fosino (8.5) Fwind - 8.5x F3 (10) Sin (35) F = Fwind losin (35)

Answer 2

Similar Homework Help Questions

A 17.0-m-high wall is under construction and its bracing is shown in the figure. This is...

A 17.0-m-high wall is under construction and its bracing is shown in the figure. This is the bracing per foot along the length of the wall. The wall is in static equilibrium but needs the bracing to withstand wind pressure. It can pivot at its base. Fwind 17.0m 8.5 m 359 Calculate the force exerted by the brace if a strong wind exerts a horizontal force of 650 N on the wall. Assume that the net force from the wind...
20.0 I- A 10 000-N shark is supported by a cable attached to a 4.00-m rod that can pivot at its base. Calculate the ten...

20.0 I- A 10 000-N shark is supported by a cable attached to a 4.00-m rod that can pivot at its base. Calculate the ten- sion in the tie-rope between the wall and the rod if it is holding the system in the position shown in Figure P12.49. Find the horizontal and vertical forces exerted on the base of the rod. (Neglect the weight of the rod.) where T is the force exerted by the Achilles tendon on the foot...
a 3 m long ladder weighing 200 N rests against a smooth vertical wall with its...

a 3 m long ladder weighing 200 N rests against a smooth vertical wall with its base on a horizontal rough floor, a distance of 1 m away from the wall. If the center of mass of the ladder is 1.20 m from the base, what frictional force must the floor exert on the base of the ladder in order for the ladder to be in static equilibrium?

A uniform ladder 5.0 m long rests against a frictionless, vertical wall with its lower end...

A uniform ladder 5.0 m long rests against a frictionless, vertical wall with its lower end 3.0 m from the wall. The ladder weighs 160 N. The coefficient of static friction between the foot of the ladder and the ground is 0.40. A man weighing 740 N climbs slowly up the ladder. What is the maximum frictional force that the ground can exert on the ladder at its lower end? What is the actual frictional force when the man has...
Auge Steel Framing Details 1. Complete all light g auge steel componente ir the following wall se...

auge Steel Framing Details 1. Complete all light g auge steel componente ir the following wall section, including floor joists, wall studs, roof rafters, and required clips angles, stiffeners, and fasteners. Label all components. Roof sheathing Wall sheathing 。 Interior wallboard Subflooring Foundation 103 Scale: l square =2" (50 mm) Name: necessity of cutting holes in m on the construction ste 12.11. 12.15). Thack etions a sed for top and bottom plates, e construction, shemperature that col tural shapes. Prers...