Homework Answers
Add Answer to:
HW 33 Update Problem 9.106-Copy 3 of 3> The brake piston consists of a full circular...
Take that a 50 mm and b - 160mm Part A Determine the moment of inertia...
Take that a 50 mm and b - 160mm Part A Determine the moment of inertia of the cross-sectional area of the beam with respect to the taxis passing through the control of the cross section Figure 1) Express your answer to three significant figures and include the appropriate units. Value mm Figure 1 of 1 > Submit Previous Answer Request Answer * Incorrect: Try Again: 4 attempts remaining Provide Feedback
PartA The pipe system shown in (Figure 1) consists of a 3-in.-diameter, 100-ft-long galvanized iron pipe,...
PartA The pipe system shown in (Figure 1) consists of a 3-in.-diameter, 100-ft-long galvanized iron pipe, a fully opened gate valve, four elbows, a flush entrance, and a pump with the pump head curve shown in (Figure 2). The friction factor is 0.022 Estimate the flow Express your answer using two significant figures gal/min Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining ▼ Part B Estimate the corresponding pump head generated by the pump Express your...
The cylinder in the figure(Figure 1) has a moveable piston attached to a spring. The cylinder's...
The cylinder in the figure(Figure 1) has a moveable piston attached to a spring. The cylinder's cross-section area is 10 cm”, it contains 0.0051 mol of gas, and the spring constant is 1500 N/m. At 17 °C the spring is neither compressed nor stretched. Part A How far is the spring compressed if the gas temperature is raised to 120 °C? Express your answer to two significant figures and include the appropriate units. Ar = 0.94 cm cm Submit Previous...
The pendulum consists of a 8-kg circular disk A, a 2-kg circular disk B, and a...
The pendulum consists of a 8-kg circular disk A, a 2-kg circular disk B, and a 6-kg slender rod. Suppose that a 0.6 m,b= 1.1 m, c 0.6 m, and d 0.3 m. (Figure 1) Part A Determine the radius of gyration of the pendulum about an axis perpendicular to the page and passing through point O. Express your answer to three significant figures and include the appropriate units. ko=0.95 m Previous Answers Request Answer Submit X Incorrect; Try Again;...
Review I Co A parallel-plate capacitor consists of two plates, each with an area of 29...
Review I Co A parallel-plate capacitor consists of two plates, each with an area of 29 cm2 separated by 3.0 mm. The charge on the capacitor is 5.8 nC. A proton is released from rest next to the positive plate Part A How long does it take for the proton to reach the negative plate? Express your answer to two significant figures and include the appropriate units. - 6.5-10-9 6.5 109S Submit Previous Answers Request Answer X Incorrect; Try Again;...
record 10000022257212104610301 Collar <Lesson14 Assignment - Chapter 10.1-10.4 Fundamental Problem 10.6 7017 Take that a =...
record 10000022257212104610301 Collar <Lesson14 Assignment - Chapter 10.1-10.4 Fundamental Problem 10.6 7017 Take that a = 190 mm and b = 310 mm Reven Part A Figure 1 of 1 Determine the moment of inertia of the beam's cross-sectional about the centro del mis (Figure 1) Express your answer to three significant figures and include the appropriate units. 30 mm 1. - 163462500 mm im - 130 mm Submit Previous Answers Request Answer b 30 mm * Incorrect; Try Again;...
HW 02 Electric Flux and Gauss Law Problem 10 10 of 20 What is the electric...
HW 02 Electric Flux and Gauss Law Problem 10 10 of 20 What is the electric flux through the surface A1 that encloses all threo objects? Express your answer to two significant figures and include the appropriate units. Constants In (Figure 1), two objects, Oi and O2, have charges +1.0 μC and-5.5 μC, respectively, and a third object, Os, is electrically neutral e-508474.6 Nm2C-1 Submit Previous Answers Request Answer X Incorrect: Try Again; 7 attempts remaining Figure 1 of 1...
Review Part A A single circular loop of radius 0.23 m carries a current of 2.6...
Review Part A A single circular loop of radius 0.23 m carries a current of 2.6 A in a magnetic field of 0.96 T What is the maximum torque exerted on this loop? Express your answer using two significant figures. N.m Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining
Problem 10.51 The shaft has a radius of 15 mm and is made of L2 tool...
Problem 10.51 The shaft has a radius of 15 mm and is made of L2 tool steel. A torque T = 2.4 kN.m is applied to the shaft. The shear modulus for the material is 75 GPa (Figure 1) Determine the strain in direction. Express your answer using three significant figures. EVO AL vec ? -0.00209813 Submit Previous Answers Request Answer X Incorrect; Try Again; 3 attempts remaining Part B Determine the strain in y direction. Express your answer using...
The square detorms into the position shown by the dashed lines. (Figure 1) The dirmensions are S56mm, s' = 59 mm, Δ...
The square detorms into the position shown by the dashed lines. (Figure 1) The dirmensions are S56mm, s' = 59 mm, Δ#1 = 4 mm, and Δ*2 = 6 mm. Side D 'B'remains horizantal. (vi),,--0.221 rad Submit X Incorrect; Try Again; One attempt remaining Part C Determine the shear strain at C relative to the z, y axes. Figure 1 of 1 Express your anser to three significant figures and include appropriate units. As y0.2062 rad 91.5 Submit Previous Answers...
Take that a 50 mm and b - 160mm Part A Determine the moment of inertia of the cross-sectional area of the beam with respect to the taxis passing through the control of the cross section Figure 1) Express your answer to three significant figures and include the appropriate units. Value mm Figure 1 of 1 > Submit Previous Answer Request Answer * Incorrect: Try Again: 4 attempts remaining Provide Feedback
PartA The pipe system shown in (Figure 1) consists of a 3-in.-diameter, 100-ft-long galvanized iron pipe, a fully opened gate valve, four elbows, a flush entrance, and a pump with the pump head curve shown in (Figure 2). The friction factor is 0.022 Estimate the flow Express your answer using two significant figures gal/min Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining ▼ Part B Estimate the corresponding pump head generated by the pump Express your...
The cylinder in the figure(Figure 1) has a moveable piston attached to a spring. The cylinder's cross-section area is 10 cm”, it contains 0.0051 mol of gas, and the spring constant is 1500 N/m. At 17 °C the spring is neither compressed nor stretched. Part A How far is the spring compressed if the gas temperature is raised to 120 °C? Express your answer to two significant figures and include the appropriate units. Ar = 0.94 cm cm Submit Previous...
The pendulum consists of a 8-kg circular disk A, a 2-kg circular disk B, and a 6-kg slender rod. Suppose that a 0.6 m,b= 1.1 m, c 0.6 m, and d 0.3 m. (Figure 1) Part A Determine the radius of gyration of the pendulum about an axis perpendicular to the page and passing through point O. Express your answer to three significant figures and include the appropriate units. ko=0.95 m Previous Answers Request Answer Submit X Incorrect; Try Again;...
Review I Co A parallel-plate capacitor consists of two plates, each with an area of 29 cm2 separated by 3.0 mm. The charge on the capacitor is 5.8 nC. A proton is released from rest next to the positive plate Part A How long does it take for the proton to reach the negative plate? Express your answer to two significant figures and include the appropriate units. - 6.5-10-9 6.5 109S Submit Previous Answers Request Answer X Incorrect; Try Again;...
record 10000022257212104610301 Collar <Lesson14 Assignment - Chapter 10.1-10.4 Fundamental Problem 10.6 7017 Take that a = 190 mm and b = 310 mm Reven Part A Figure 1 of 1 Determine the moment of inertia of the beam's cross-sectional about the centro del mis (Figure 1) Express your answer to three significant figures and include the appropriate units. 30 mm 1. - 163462500 mm im - 130 mm Submit Previous Answers Request Answer b 30 mm * Incorrect; Try Again;...
HW 02 Electric Flux and Gauss Law Problem 10 10 of 20 What is the electric flux through the surface A1 that encloses all threo objects? Express your answer to two significant figures and include the appropriate units. Constants In (Figure 1), two objects, Oi and O2, have charges +1.0 μC and-5.5 μC, respectively, and a third object, Os, is electrically neutral e-508474.6 Nm2C-1 Submit Previous Answers Request Answer X Incorrect: Try Again; 7 attempts remaining Figure 1 of 1...
Review Part A A single circular loop of radius 0.23 m carries a current of 2.6 A in a magnetic field of 0.96 T What is the maximum torque exerted on this loop? Express your answer using two significant figures. N.m Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining
Problem 10.51 The shaft has a radius of 15 mm and is made of L2 tool steel. A torque T = 2.4 kN.m is applied to the shaft. The shear modulus for the material is 75 GPa (Figure 1) Determine the strain in direction. Express your answer using three significant figures. EVO AL vec ? -0.00209813 Submit Previous Answers Request Answer X Incorrect; Try Again; 3 attempts remaining Part B Determine the strain in y direction. Express your answer using...
The square detorms into the position shown by the dashed lines. (Figure 1) The dirmensions are S56mm, s' = 59 mm, Δ#1 = 4 mm, and Δ*2 = 6 mm. Side D 'B'remains horizantal. (vi),,--0.221 rad Submit X Incorrect; Try Again; One attempt remaining Part C Determine the shear strain at C relative to the z, y axes. Figure 1 of 1 Express your anser to three significant figures and include appropriate units. As y0.2062 rad 91.5 Submit Previous Answers...
Most questions answered within 3 hours.
-
An software company has three different promotion plans for
its software purchase:
plan A: each software...
asked 5 minutes ago -
If
P(A)=.62, P(B)=.47, & P(A or B)=.88. What is the likeliness of
selecting only A?
A)...
asked 4 minutes ago -
What is the FUTURE VALUE of $500 invested for 3 years at 7% with
ANNUAL Compounding...
asked 14 minutes ago -
Modify the method so that instead of manually making teams, it
reads it from a text...
asked 12 minutes ago -
1. Which of the following is not a principle to apply to
construction:
Select one:
a....
asked 14 minutes ago -
In what way is a Christian’s position made more challenging by
revealing faith in the workplace?...
asked 21 minutes ago -
1) There are four categories of customer benefits in B2B
(business-to-business) markets. Which of the following...
asked 18 minutes ago -
What is the pH of a 150.0 mL solution of 0.0273 M NaOH (strong
base)?
asked 28 minutes ago -
A thin ball shell is shaped like a hollow ball with a radius of
26.6 cm....
asked 33 minutes ago -
What mass of KX (Mm= 180 g/mol) is required to prepare 483 mL of
a pH...
asked 33 minutes ago -
In a lottery game, 4 numbers from 1 to 29 are selected. Winners
must match all...
asked 44 minutes ago -
A catfish is 2.5 m below the surface of a smooth lake.
(a) What is the...
asked 46 minutes ago