Given the orthographic top view and front view, create the oblique view.
2-(20%) Use the three orthographic views given below and freehand sketch the oblique view. The drawing should be somewhat proportional. TOP FRONT RIGHT SIDE
OBLIQUE SURFACES- SKETCH THE TOP AND ISOMETRIC PICTORIAL VIEWS V.1. 0.0. Crole FILE NUMBER GRADE IF SURFACES OR CORNERS ARE LABELED IN THE GIVEN VIEWS, SHOW THE LABELS IN ALL VIEWS. PROVE YOUR ANSWER. ISOMETRIC PICTORIAL VIEW GIVEN: FRONT AND RIGHT SIDE VIEWS REQUIRED: SKETCH THE TOP AND ISOMETRIC PICTORIAL VIEWS. 5 ORTHOGRAPHIC VIEWS 0-3 OBLIQUE SURFACES NAME DATE
Isometric & Oblique 1. Given the front, top and right side views of the object, sketch the Isometric pictorial of the object. You may use isometric grid paper if desired. Keep the object in proportion. TOP Zoo FRONT RIGHT SIDE 2. Given the front and top views of the object, sketch the Oblique Cavalier pictorial of the object on Engineering paper at 30 degrees. Keep the object in proportion. - - ТОР FRONT
Sketch the object represented by the orthographic projection. TOP TOP FRONT FRONT SIDE TOP 0861 01 FRONT FRONT
2. Draw the orthographic projections - front, top and right side views for the given figure below. (20 points)
Given: The front and top views of an object. Required: Draw the right side view and complete the bottom half as instructed. For part 2: Draw the right side view of surface 14,17,19,20,26. ORTHOGRAPHIC READING GIVEN: The front and top views of an object. 10 REQUIRED: Draw the right side view and complete the bottom half as instructed. 13 14 15 16 17 18. 26 20 22 Draw the right side view of surface 14,17,19,20,26. 14 26
given the front and left side use 45 angle projection and draw the top view. then complete another 3 orthographic views by first drawing the front view revolved clockwise on A as a pivot until milled slot is horizontal for cutting on a milling machine, then project top and left side. dimension all views. Milling Cutter .5 .38 1.5O 1.62 3.25 45 3.50 Milling Cutter .5 .38 1.5O 1.62 3.25 45 3.50
sketch an isometric view given top front and right views. ㄚ Top, Front & the side views are given. Sketch an isometric view.
II. Given the Isometric view of an object. Create a neat Frono View and Top View ot the part. E though dimensions are not given, proportions should be matntained as given in the isometric view Hatness tolerance for the surface pointed out with an arrow mark in the Front View. Use any arbitrary . Give a value for tolerance. Is the Right Side view necessary? Justify. (50 Pts.)
Cepyright 1988 FILE NUMBER ISOMETRIC PICTORIAL VIEW GRADE GIVEN: TOP AND LEFT SIDE MEWS. A: SKETCH FRONT OFFSET MEW A A. B: SKETCH ISOMETRIC PICTORIAL SECTION A A MATERIAL: STEEL ORTHOGRAPHIC VEWS DATE NAME S-12 SECTIONAL VIEWS Cepyright 1988 FILE NUMBER ISOMETRIC PICTORIAL VIEW GRADE GIVEN: TOP AND LEFT SIDE MEWS. A: SKETCH FRONT OFFSET MEW A A. B: SKETCH ISOMETRIC PICTORIAL SECTION A A MATERIAL: STEEL ORTHOGRAPHIC VEWS DATE NAME S-12 SECTIONAL VIEWS