2-(20%) Use the three orthographic views given below and freehand sketch the oblique view. The drawing...
The front and top views of an object are shown below. Freehand sketch the section view of the front view, use the cutting plane as indicated in each problem (A thru D). Hatch the full sections view by hand and place the section view below the front view. Make sure you label the section view. Your drawing should be proportional.
OBLIQUE SURFACES- SKETCH THE TOP AND ISOMETRIC PICTORIAL VIEWS V.1. 0.0. Crole FILE NUMBER GRADE IF SURFACES OR CORNERS ARE LABELED IN THE GIVEN VIEWS, SHOW THE LABELS IN ALL VIEWS. PROVE YOUR ANSWER. ISOMETRIC PICTORIAL VIEW GIVEN: FRONT AND RIGHT SIDE VIEWS REQUIRED: SKETCH THE TOP AND ISOMETRIC PICTORIAL VIEWS. 5 ORTHOGRAPHIC VIEWS 0-3 OBLIQUE SURFACES NAME DATE
Isometric & Oblique 1. Given the front, top and right side views of the object, sketch the Isometric pictorial of the object. You may use isometric grid paper if desired. Keep the object in proportion. TOP Zoo FRONT RIGHT SIDE 2. Given the front and top views of the object, sketch the Oblique Cavalier pictorial of the object on Engineering paper at 30 degrees. Keep the object in proportion. - - ТОР FRONT
Given the orthographic top view and front view, create the oblique view.
2. Draw the orthographic projections - front, top and right side views for the given figure below. (20 points)
Given: The front and top views of an object. Required: Draw the right side view and complete the bottom half as instructed. For part 2: Draw the right side view of surface 14,17,19,20,26. ORTHOGRAPHIC READING GIVEN: The front and top views of an object. 10 REQUIRED: Draw the right side view and complete the bottom half as instructed. 13 14 15 16 17 18. 26 20 22 Draw the right side view of surface 14,17,19,20,26. 14 26
sketch an isometric view given top front and right views. ㄚ Top, Front & the side views are given. Sketch an isometric view.
Draw the necessary orthographic views to describe the object in Figure D2. The drawing shall include the following views: a HALF SECTIONAL FRONT view from A a SIDE view from B ALL DIMENSIONS ARE IN MILLIMETRES PLOT THE DRAWING ON A SCALE OF 1:2. 58 32 0132 0115 5116 φ100 ф86 R4 φ64 010 THRU R3 070 ALL UNMARKED RADIIR 30 050 THRU в/ Draw the necessary orthographic views to describe the object in Figure D2. The drawing shall include...
Drawing Exercise 3: Sketch isometric AND oblique views. 75 1.25 1.00 50 1.25 25 Note: Use a suitable scale to simplify the dimensions Sketch the oblique view. 15 xe 65 Note: Use a suitable scale to simplify the dimensions. Sketch the isometric view. L00 200
please use the graphic paper Sketch the ISOMETRIC view of the object. The given TOP, FRONT and RIGHT SIDE views are complete. Use point "O" for orientation. TOP RIGHT SIDE FRONT