112 CHAPTER 4 MAGNETIC CIRCUITS AND TRANSFORMERS 4.5 The electromagnetic system shown in Fig. 4.33 has...
2. The magnetic circuit of Fig. 1 consists of rings of magnetic material in a stack of height h. The rings have inner radius Ri and outer radius Ro. Assume that the iron is of infinite permeability (μ → x) and neglect the effects of magnetic leakage and fringing Ri N turns For Ri-3.2 cm, Roー4.1 cm, ћ-1.8 cm, g = 0.15 cm, N-72 turns, calculate a. The mean core length le and the core corss-sectional area Ac. b. The...
[Magnetic circuits – 20 points] A two-legged magnetic core with an airgap is shown in the below figure. The cross-sectional area of the core is A. = 20 cm?, the mean length of the core is l. =80 cm, and the length of the airgap is 0.06 cm. The number of turns on the coil is 200. The relative permeability of the core can be assumed to be constant and equal to 2000. The fringing effect causes a 6% increase...
3. [Magnetic circuits – 20 points] A two-legged magnetic core with an airgap is shown in the below figure. The cross-sectional area of the core is A = 20 cm², the mean length of the core is l. =80 cm, and the length of the airgap is 0.06 cm. The number of turns on the coil is 200. The relative permeability of the core can be assumed to be constant and equal to 2000. The fringing effect causes a 6%...
Question 7 A magnetic core is shown in Figure 1. Relative permeability of the core is 14 = 2000. Total number of winding turns in the left winding is NL = 100 and in the right winding is Nr = 10. Assume that the core cross section is uniform and the combined length of all air-gaps is much smaller than the dimensions of the core cross-section. Calculate the following: a) The magnetomotive force in the core if i = 2...
explain in a simple way Assignment Report Q1. For the Magnetic circuit shown in Fig. 5.1, relative permeability of the core material is 6000, its rectangular cross section is 2 cm by 3 cm. The coil has 500 turns and the core thickness is 3 cm. If flux density in the gap is 0.25 T. Find the following: a) The gap reluctance (assume that fringing increases effective cross-sectional area of air gap by 50%). b) The required airgap mmf. c)...
Learning Goal: To understand the concepts explaining the operation of transformers.One of the advantages of alternating current (ac) over direct current (dc) is the ease with which voltage levels can be increased or decreased. Such a need is alwayspresent due to the practical requirements of energy distribution. On the one hand, the voltage supplied to the end users must be reasonably low for safety reasons(depending on the country, that voltage may be 110 volts, 220 volts, or some other value...