if delta P is not measured
then we use this form of sigma , given reference book
lab during a -84 kPa, the 5.9. Assume the following information was obtained in cavitation test...
5.9. Assume the following information was obtained in the lab during a cavitation test on an orifice: Cd0.10, P 620 kPa, P84 kPa, ug 2.69 m/s. Calculate ? (Eq. 5.1). Answer: ?=0.97
Using the information obtained from the previous study about exercise, the following data was obtained for the hypothesis test: • Hou = 9.7. H.: # 9.7 • Assume the significance level is a = 0.10. • The z- test statistic is calculated as 3.03. What is the p-value and conclusion for this hypothesis test? Move the blue dot to choose the appropriate test(left, right, or two-tailed). Use the graph below to move the slider to the test statistic in order...
The following information was obtained from independent random samples. Assume normally populations with equal Sample 1 Sample 2 12 Sample Size 10 Sample Mean 52 Sample Variance 85 We are interested in testing Hai sample 1 -Hsample 2 0 Step 2 of 3: Determine the p-value for the test. TablesKeypad Answer 1 Point Next Prev O p-value c 0.025 0.025< p-value <0.05 Op-value <0.1 。p-value > 0.2 None of the above o 2019 8 3 of 3 The following information...
CENTRE INDEX NUMBER SECTION B 30 marks] Calculate the discharge through a pipe of diameter 200 mm when the difference of pressure head between the ends of the pipe 500 m apart is 4 m of water. Take the value off= 0.009 in the formula hl= a) 19.5e/s b)2.0es e)03 m's d) 29.3 e/s 2. A scale 1:50 scale model of ship is towed through sea water at a speed of 1 ms. A force of 2 N is required...
Q1
a) Company A designed a heat pump to
supply heat into a library in Canada during
winter, so that the library can maintain to be at 20°C. The heat
pump utilizes
12,000 L/min of Refrigerant-134a as the working fluid and absorb
heat from an
industrial water stream. The water stream enters the evaporator at
50°C and exits
at 25°C. The refrigerant enters the evaporator at 10°C with 90%
moisture content
and leaves at 20°C. There is no pressure drop in...
Problem #3 (Total marks-14) Given: An engine has the following operating conditions per air-standard Otto cycle: Gasolina (SI) TYCO engine Pressure at beginning of compression process (Pal state 1 Temperature at beginning of compression process state 1) Volumetric compression ratio , Specific heat added during combustion process ( k g) (process 273) 300 1400 Data used for constant Specific Heat (standard cold-air assumption) Method: Ic ... 1.005 kJ/kg. K(C) = 0.718 kJ/kg.K. k=1.400, R -0.287 kJkgK Required: Draw a clear...
Use the following information to complete steps (a) through (d) below. A random sample of ny = 135 individuals results in xy = 40 successes. An independent sample of n2 = 150 individuals results in x2 = 60 successes. Does this represent sufficient evidence to conclude that P, <P2 at the a = 0.10 level of significance? (a) What type of test should be used? A. A hypothesis test regarding the difference between two population proportions from independent samples. B....
The
z-tests
Help with this page is greatly appreciated. I dont understand
how to show a full diagram. Thanks in advance :)
The z-test 10.1 Assume that a treatment does have an effect and that the treatment effect is being evaluated with a z hypothesis test. If all factors are held constant, how is the outcome of the hypothesis test influenced by sample size? To answer this question, do the following two tests and compare the results. For both tests,...
Refer to Figure 3 (below), depicting a regenerative Rankine cycle with a closed feedwater heater (CFWH) when considering the following system description. Saturated liquid water at a pressure of P before entering the CFWH. 12 kPa is pumped to a pressure of Pi-5 MPa After leaving the CFWH as a saturated liquid, the water continues to a Steam Generator which heats the water to a temperature of Ts 600°C. This superheated steam is used to drive a Turbine. A quantity...
Use SPSS for this exam, be sure to include all the following information to get full credits: (1) null and alternative hypotheses (15%) (2) nameofthe test(15%, explain why you chose it) (3) thetest statistic and its degree offreedom or ANOVAtable(if applicable) (30%! (4) p-value (15%), and (5) scientific conclusion (25%, using 0.05 significance). 1. Ostriches live in hot environments, and they are normally exposed to the sun for long periods Mammals in similar environments have special mechanisms for reducing the...