Draw a graph of the following readings for a pressure sensor to specify the linearity of...
The calibration of a pressure sensor with a range of 0-16 bar is checked by applying known inputs to it in steps of 2 bar. The following measurements were obtained. Known input pressure (bar) 0 2 4 6 8 10 12 14 16 Output reading (V) 0.00 0.55 1.25 1.70 2.35 3.15 3.65 4.05 4.85 Draw a graph by plotting the data points on a graph paper and draw a best-fit straight line through the data points. [8 marks] Use...
Which of the following scan tool readings (engine ar idle) indicates a problem. MAF sensor 3.5g/air flow Oxygen sensor between 200-800 MAP sensor between 0.88 and 1.62 v
Two pressure sensors are installed on a 9-meter-high submarine: one sensor is on the top and another one in at the bottom of the submarine. When the submarine dives, what is the difference in readings of the two pressure sensors? The density of water is 1000 kg/m.
The speed of wind is U = 22.5 m/s. The pressure sensor shows the pressure the static pressure of the middle point line of the experiment surface as 6mmH20 under atmospheric pressure. absokute pressure is 99.1 KPa and temperature is 23 celsius. calculate the dynamic and static pressure of the middle point line of the experiment surface. calculate the static pressure of the tunnel walls and compare to the previous section static pressure. Why are they different? Flow U =...
emf In the circuit above, the switch is closed for a short time. The readings are then recorded from the ammeter and the voltmeter and shown in the table below. Voltmeter Readings (V) Ammeter Readings (mA) 6.75 30 6.00 60 5.25 90 4.50 120 3.00 180 a) Draw a graph on graph paper of Voltmeter Readings against Ammeter Readings b) Find the following information from the graph: D) EMF of the battery b) Internal Resistance of the battery. c) A...
Question No 1 (CLO-1) (a) A Wind speed sensor was installed inside a wind tunnel. The sensor was tested and following output data was recorded at different wind speeds: Wind speed Vout (m/s) (V) 0 0.00 2 0.35 4 0.65 6 1.10 8 1.42 10 1.85 12 2.17 14 2.54 Sketch input output graph of the sensor using recorded data and evaluate the following: 1. Linearity II. Sensitivity (b) When a 250-lbs man gets in his car, the car body...
(20 points) Give a detail design of pressure measurement system by using strain gage as a sensor. The output signal is voltage 1) Draw circuit diagram/and sensing element with strain gauge. 2) Draw a block diagram and name a part on each block. 3) Give the sensitivity of each block 4) Give an equation to show the relationship of input pressure and output 2. voltage (20 points) Give a detail design of pressure measurement system by using strain gage as...
A square membrane of single-crystal silicon is used as a pressure sensor to detect pressure changes from 0 to 5000 Pa. Calculate the length L of the membrane side if the maximum deflection is 15% of the membrane thickness of 25 microns. A square membrane of single-crystal silicon is used as a pressure sensor to detect pressure changes from 0 to 5000 Pa. Calculate the length L of the membrane side if the maximum deflection is 15% of the membrane...
Calculate the measure electrical output (mA) of a pressure-type level sensor that has a 0-4 psi input range and a 0-20 mA output range if the pressure sensed is 3 psi.
Which of the following would NOT be considered reference data? a. Blood pressure readings Ob. CPT codes Oc Master product codes Od. State abbreviations