Question

Fig. 2 4 of Example 1 Simulate Sine wave f(t)-sin(1000 *2π*1) 1. Create a new model window by choosing "File">"Ne"> "Model" 2. Drag "Sine Wave" block from "Simulink" -> "Sources" to the model window; 3. Drag "Scope" block from "Simulink"-"Sinks" to the model window 4. Left-press the mouse when the arrow becomes a single cross by moving the mouse near to the right side of "Sine Wave; keep left button pressed and move the single cross to the left side of Scope" until you see the single cross becomes double crosses; release the button and the tow parts are connected. Fig. 3 is the finished diagram. 5. Click "Simulation" "Simulation parameters ..." and refer to Fig. 4 to set the simulation parameters. 6. Double click the "Sine 7. Press "Start simulation" to run the program 8. Double click the "Scope 9. Refer to Fig. 7 to set the parameters of "Scope" by press "Parameters" button on Wave" and set the parameters as shown in Fig. 5 "and you should see the wave similar to Fig. 6 the display panel 10. Right click on the scope; then choose "axes properties." to set "Y" scales. 1. Now you should see the picture of Fig. 8

Answer 1

as per the given instruction sinaltion will look like

enter the following in the sine block.
open scope now to see the plot