We need at least 10 more requests to produce the answer.
0 / 10 have requested this problem solution
The more requests, the faster the answer.
Intro Experimental Discussion 124 Discussion Data Sheet Suppose that a drug standard E with known concentration...
need help on these
Suppose you obtained the following data from two standard solutions of known concentrations using a UV-Vis spectroscope: Analysis # Conc. (mg/L) 8.00 20.00 Absorbance (at 255 nm) 0.160 0.390 What is the concentration (in mg/L) of an unknown solution with an absorbance of 0.200 at 255 nm 10 points)? The unknown solution contains the same analyte as the standard solution does (Assume a path length of 1cm). 10. You prepared a stock solution by dissolving a...
please use the information provided to fill out the
first sheet (the data)
Data Sheet: 1. Concentration of NaOH ALL volume measurements (in mL) must be recorded using two (2) digits to the right of the decimal or they are wrong. (Watch the significant figures.) SHOW ALL OF YOUR CALCULATIONS ON THE NEXT PAGE. 2. Initial volume of acid in buret (left photo) 3. Final volume of acid in buret (right photo) 4. Volume of acid (#3 #2) 5. Volume...
please use the information provided above to answer
the questions below (the 2 worksheet)
_35%. 1:59 AM Introduction In chemistry laboratory, it is sometimes necessary to experimentally determine the concentration of an unknown acid or base solution. A procedure for making this kind of determination is called an acid-base titration. In this laboratory process, a solution of known concentration, called the standard solution, is carefully added to a solution of unknown concentration until the mixture becomes neutral. The neutral point...
need help with the Molarity of both parts
EXPERIMENT 8: AN OXIDATION-REDUCTION TITRATION DATA SHEET 0.2M 10 m2 Concentration of original KMnO solution Volume of Original KMnO4 solution used Molarity of KNOWN HOCg04 D.ISOM Standardization of KMnO solution. Sample 3 Sample 1 Volume H2C204 11.00ML Initial buret reading (KMnO4) .00 mc Final buret reading (KMnO4) 12.00ML Volume KMnO4 12.00ml Molarity KMnO4 Average (KMnO4) Sample 2 4:00ML 12.00mL 13.5ML . SOL Determination of Unknown Solution Sample 3 Sample 1 4ml Volume...
help please?
this was the only other information given
REPORT SHEET Determination of the Solubility-Product Constant for a Sparingly Soluble Salt EXPERIMENT 8 A. Preparation of a Calibration Curve Initial (Cro121 0.0024 M Absorbance 5 mL Volume of 0.0024 M K Cro Total volume 1. I mL 100 mL 2. 100ML 3. 10 mL 100ml 4. 15 mL 100 ML Molar extinction coefficient for [CrO2) [Cro,2) 2.4x100M 12x1044 2.4810M 3.6810M 0.04) 2037.37 0.85 1.13 2. 3. Average molar extinction coefficient...
can you please help me with this
Data and Calculations Trial 0:29 Absorbance 0.378 Je 0.086 Trial 2 0.47 Trial 3 0.632 Trial 4 0.729 0.686 Absorbance of standard Triw. 329 0.6 6 Temperature ke [Fe(SCN) 2+]/([Fe3+] [SCN-]) Ferrag) + SCN Cag) 2 FescN2t (ag) Absorbance of standard (Trial) Temperature 0.3 Ke expression: [Fe] 0.0010 [SCN) 10.00040 [FeSCN? Jeg [Fe [SCN ] Ke value Average of Ke values Percent error (see pg 7): (Discuss this result as part of your...
Need help filling in my data sheet from a lab. My professor said
the pressure was 24.6 inches of Hg and that we needed to convert
that to moles. Im not sure i put that in the correct spot. I
included the lab protocol. Plz plz plz help me fill in the blanks
and let me know if i did something wrong Im very confused haha.
THANKS!!
Equivalent Mass by Electrolysis If the two terminals on any source of DC...
just one example/demonstration!
Data needed to be calculated is in highlighted in green boxes.
And I highlighted in red an equation (not sure if thats what you
use to calculate it) And ignore the lab instructions on completeing
a graph!! I already know how to do that in excel, just curious how
Ln (relative rate) and 1/T in K^-1 is calculated by hand*
here is the rest of that lab leading up to the question as I
know its typically...
1) What chemical is the titrant in this experiment? What
chemical is the analyte in this
experiment?
Experiment #8: Measuring the Vitamin C Content of Emergen-C™ Objectives: • Students will learn how to use a burette. • Students will learn how to use the iodine starch indicator system to monitor oxidation/reduction reactions. Students will learn how to conduct a titration to determine the amount of analyte in an unknown solution. • Students will learn about ascorbic acid's role as a...
Based on the document below,
1. Describe the hypothesis Chaudhuri et al ids attempting to
evaluate; in other words, what is the goal of this paper? Why is he
writing it?
2. Does the data presented in the paper support the hypothesis
stated in the introduction? Explain.
3.According to Chaudhuri, what is the potential role of thew
alkaline phosphatase in the cleanup of industrial waste.
CHAUDHURI et al: KINETIC BEHAVIOUR OF CALF INTESTINAL ALP WITH PNPP 8.5, 9, 9.5, 10,...