Question

Problem 10.22 Consider the frame shown in (Figure 1). Assume the supports at A and B are foxed. Er is constant Click on 'add vertical line off to add discontinuity lines. Then click on "add segment" button to add functions betwe lines, Note 1. Make sure you place only one vertical line at places that require a vertical line. If you inadvertently place two lines at the same place, it will appear correct visually because the lines overlap, but the system will mark it wrong. Note 2 - Draw a vertical line to denote local maximum or minimum. Note 3 . You should not draw an extra vertical line at the point where the curve passes the x-axis. Note 4. The curve you choose from the drop down is only a pictorial representation of a real quadratic/cubic curve. The equation of this curve is not mathematically equivalent to the correct answer. Consequently, slopes at discontinuities ar intercepts with the x-axis (if any) are not accurate Note 5. Be sure to indicate the correct types of the functions between the lines, e.g. in your answer the type of a function linear increasing slope" for the function that actually has linear decreasing slope, the answer will be graded as incorrect the button "change segment if necessary. 30 kN/m No elements selected A 3 m M (Nm) 30 20 10 10 Figure Add discontinuity ines and select segments to add to the carwas 3 Suomi PAHA x correct Try Again attempte remaining

Answer 1

Your figure is not visible

It's blurred

I have still done the question by guessing the values,

SFD AB dst wodne 11.1037 5 Eve (SF), - (55) s Area of En وليه) EX landingdia.be oef3-X) (SF)-(SA) As of loading dia. b/w B & E Yxnx 30 x B A 33.8963 Arce= E 5x2 30 low -ll:(037-05- 512 x = 1.5m