Consider the message signal m(t)=2cos(2001Tt)+3sin(4001Tt). Work out by hand the expected frequency spectrum and output waveform...
4. (20%) An AM modulator operates with the message signal m(t) - 9 cos(207t)-8 cos(60!). The unmodulated carrier is given by 110 cos 200r), and the system operates with an index of 0.8. (10%) (a) Given that the minimum value ofm(t) is-12.9, write the equation for m, (t). and determine the power of m,(r) (i.e.. m,())) (b) Determine the efficiency of the modulator 5%) (500) (c) Sketch the double-sided spectrum of the modulator output AM signal. 4. (20%) An AM...
Consider the message signal m(t):a. Sketch the AM signal u(t)=[ A + m(t) ] Cos(wct) for modulation indexes μ = 0.5 and μ = 2.0 by assuming the carrier frequency to be much higher than the bandwidth of m(t) b. Determine the efficiency percentage (η = ps/pt) for μ = 0.5. Herein, Ps and Pt are sideband and total powers respectively, and Pt= Ps + Pc , in which Pc is the carrier power. Hint : Take into account the Parseval's property. c. If the AM waveforms corresponding...
Problem No. 1: Let us consider that a baseband message signal m(t)=4cos(2000xt) has to be transmitted from a location 'A' to its destination 'B' using a carrier signal given by c(t)=2cos(10000#t). The signal s() m(t)c(i) is the modulated signal which will be transmitted. Consider that the signal is transmitted through a noiseless channel and received at the receiver at location 'B' as the signal s(t). Based on this information, perform the following tasks. 1. Find, sketch and label the spectrum...
Assume that an AM transmitter is modulated with a video testing signal given by em(t) = =20 + 60 sin (2πf1t), where f1 = 3.57 MHz. Let the carrier signal c(t) = Ac cos(2πfct), where Ac = 100 and fc = 100 MHz. The AM signal is fed into a 50-Ω load. (a) Derive an expression for the AM DSB-FC signal in time domain. (b) Construct the AM waveform, giving numerical values of the maximum amplitude, Amax and the minimum...
Please answer ASAP Question 3: The input signal m (t)-2cos(4000π) and the carrier signal is 100 cos(100Km). Determine and plot the spectrum using AM traditional modulation
Solve using Matlab: FM spectrum: A message signal m(t) (shown below) is used to modulate a carrier with frequency (fc) in a FM system with kr 90, find and plot the FM signal s(t) in both time and frequency domains. Use the value of fc-1000. m(t) (V) 3.5 t (ms) 250 [Note that m(t) is zero for t<0 and t>250 ms FM spectrum: A message signal m(t) (shown below) is used to modulate a carrier with frequency (fc) in a...
3. a. For the message signal m(t)-2sgnit) and unmodulated carrier cos(u,ti, draw the output of phase modulator with m(t) (n/4) cos(ω-') - For the message signal m(t)--2sgn(t) and unmodulated carrier cos(w,t) shown above where -20m, draw the output of frequency modulator with m(t) (k-10n) 3. a. For the message signal m(t)-2sgnit) and unmodulated carrier cos(u,ti, draw the output of phase modulator with m(t) (n/4) cos(ω-') - For the message signal m(t)--2sgn(t) and unmodulated carrier cos(w,t) shown above where -20m, draw...
TO 2, the signal m(t) 20 sinc ( 400't) is an input to a ring modulator with carrier frequency 10 fm where fm is the maximum frequency of m(t)} (a) Draw the block diagram of the used ring modulator and write down equation of the output signal of the modulator (b) Sketch spectrum of the modulated transmitted AM signal (c) Sketch the corresponding VSB AM spectrum with 25% of visitgal band relative to the other band. TO 2, the signal...
3.8 An AM modulator operates with the message signal m(t)-9 cos(20π)--8 cos(60π) m(t) = 9 cos(20π) + 8 cos(60x1) The unmodulated carrier is given by 110cos(200)Same steps with another signal. and the system operates with an index of 0.8 the system operates with an indet or (a) Write the equation for ma(t), the normalized sig- nal with a minimum value of- (b) Determine (m the power in m (c) Determine the efficiency of the modulator (d) Sketch the double-sided spectrum...
got 50 min sgn(t) and unmodulated carrier cos(wct), draw the output of unmodulate 3. a. For the message signal m(t)-2sgn(t) phase modulator with m(t) (k/4) cos(o t b. For the message signal m(t)--2sgn(t) and unmodulated carrier cos(wet ) shown above where ue-207, draw the output of frequency modulator with m(t) (k-10n) sgn(t) and unmodulated carrier cos(wct), draw the output of unmodulate 3. a. For the message signal m(t)-2sgn(t) phase modulator with m(t) (k/4) cos(o t b. For the message signal...