A rectangular block of ice 14 m on each side and 1.7 m thick floats in seawater. The density of the seawater is 1025 kg/m3. The density of ice is 917 kg/m3.
If the ice block is pressed down even with the surface and then released, it will bounce up and down, until friction causes it to settle back to the equilibrium position. Ignoring friction, what maximum height will it reach above the surface?
A rectangular block of ice 14 m on each side and 1.7 m thick floats in...
need help a) b) c)
A rectangular block of ice 5 m on each side and 1.8 m thick floats in seawater. The density of the seawater is 1025 kg/m? The density of ice is 917 kg/m? a) How high does the top of the ice block float above the water level? m Help Reset Enter 1.61 1.61 NO b) How many penguins of mass 24 kg each can stand on the ice block before they get their feet wet?...
An ice cube floats in a beaker of ice cold water. Since the water is ice cold, the ice cube is not melting and hence its volume is not changing. The density of water and ice are, respectively, ρw = 1,000 kg/m3 and ρi = 917 kg/m3. (Assume one of the ice cube's faces is parallel to the water's surface.) (a) If the ice cube is 17.0 mm on each side, how far below the surface (in mm) is the...
ice: pomiv 0. A 3.35 kg block of ice floats on sea water. 89.1% of the ice is under water. The density of the ice is 0.917x103 kg/m3. What is the density of the sea water? A. 32.8 kg/m3 B. 1.00*10*3 kg/m3 C. 1.03*10*3 kg/m3 D. 1.12*10*3 kg/m3 E. 817. kg/m3 V= 3.35 917-103 vom
A cubical block of wood, 11.0 cm on a side, floats at the interface between oil and water with its lower surface 2.40cm below the interface (the figure (Figure 1)). The density of the oil is 790 kg/m3. What is the mass of the block? What is the density of the block?
21. Oil having a density of 930 kg/m floats on water. A rectangular block of wood 6.00 cm high and with a density of 960 kg/m) floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block? (15 points) oil Wood block water I
A cubical block of wood, 10.7 cm on a side, floats at the interface between oil and water with its lower surface 2.10 cm below the interface (the figure ). The densityof the oil is 790 kg/m^3.a) What is the gauge pressure at the upper face of the block?? Pab)What is the gauge pressure at the lower face of the block?? Pac)What is the mass of the block?? kgd)What is the density of the block?? kg/m^3
A rectangular metal block is 0.6 m long, 0.2 m wide, and 0.1 m tall. The block weighs 270 N. The block is lowered into an unknown fluid until it is completely submerged. In the fluid, the block weighs 164 N. What is the density of the fluid (in kg/m3)? Use g = 9.79 m/s2.
A 12 kg block is pressed against a spring with spring constant k = 1424 N/m. The spring is normally 65 cm long but the block is pressed against it to compress the spring until it is only 27 cm long. The block is then released and the spring pushes it forward onto a frictionless surface. a)How fast is the block moving immediately after it leaves the spring? b) The mass then slides across a 2.5 m wide surface with...
1 point) A block of ice is held 2 m below the surface of the water and then released. What is the magnitude of its initial acceleration? (calculators permitted in this question) m/s2 If its mass is 1.9 kg and its frictional factor is 3 kg/s, what is the terminal upward speed? (Use 920 kg/m2 for the density of ice.) Hint: Use Eqn 13-11, and think about how you need to balance the bouyant, gravitational, and drag forces if you...
A 9.00-kg block of ice, released from rest at the top of a 1.44-m-long frictionless ramp, slides downhill, reaching a speed of 2.88 m/s at the bottom. the angle between the ramp and the horizontal is 17.1 degrees. What would be the speed of the ice at the bottom if the motion were opposed by a constant friction force of 10.8 N parallel to the surface of the ramp? v=?