If any mistakes is there please comments below,and upload property of Co2
Here final answer is purely based on the property of Co2 .these values are obtained from internet ,if you have Co2 table please upload with the question.i will re upload my answer.
2. (60 pts) Estimate the rate of heat loss from a vertical thin plate immersed in...
Estimate the rate of heat loss from a vertical thin plate immersed in Carbon Dioxide (CO2) at one atmosphere and 10°C. The plate is 4 m high and 3 m wide. It is maintained at 44°C.
Estimate the rate of heat loss from a vertical thin plate immersed in CO2 at one atmosphere and 10℃. The plate is 4 m high and 3 m wide. It is maintained at 44℃.
7.39 A long, thin metal plate is hung vertically after a heat treating process. The plate, of width W= 0.2 m, ver- tical dimension of 3 m, and an initial temperature of T-320°C, is cooled by atmospheric air of velocity V=4 m/s and Toe-30°C. Determine the initial rate of heat loss from the plate if the air is in parallel flow over the plate. Account for heat loss from both surfaces of the thin plate. Determine the initial rate of...
9-22 A 0.5-m-long thin vertical plate is subjected to uniform heat flux on one side, while the other side is exposed to cool air at 5°C. The plate surface has an emissivity of 0.73, and its midpoint temperature is 55°C. Determine the heat flux sub- jected on the plate surface.
Homework 7 heat transfer 2018-20 1) A horizontal tube of 12.5-mm dimeter with an outer srface temperature of 240°C is placed in a room with an air temperature of 20°C. Estimate the heat transfer rate per unit length of the tube due to free convection. 2) Air at -10°C flows at 10 m/s over the roof plate of two 5m length rooms whose air is at Too-200C. The roof plate is 0.20-m thick concrete (k = 0.6 w/ m. K)....
Flat-plate solar collectors have been installed on the roof of a residential building. The collectors, each measured 1-m-wide and 4-m-long, are installed side by side. The collectors are maintained at 15 °C while ambient air at 10 °C flows over the roof with a velocity of 2 m/s along the width of collectors. Determine the rate of convective heat loss from (a) the first plate and (b) the third plate V,T im 4m 田ロ田
a) what is the heat loss per unit length from the pipe in W/m? b) Estimate the heat loss per unit length if a 50 mm thick layer of insulation with a conductivity of 0.058 W/m K. Neglect radiation for this part. 3. A 0.20-m diameter, thin-walled steel pipe is used to transport saturated steam at a temperature of 486K in a room for which the air temperature is 25°C and convection heat transfer coefficient at the outer surface of...
Problem 2: Non-reacting Ideal Gas Mixture (30 pts) 5 kmole/s of a mixture of carbon monoxide CO (40% molar) and Nz (60% molar) at 47°C and 2 bar (state 1) is mixed with of a mixture of carbon dioxide CO2 (55% molar) and N2 (45% molar) at 147°C (state 2) to obtain a mixture at state 3 with 77°C, The heat transfer to the surrounding is neglected. Determine: a) b) c) The mole flow rate n2 in kmole/s. (18 pts)...
Question 1 2 pts Climate is a measure of temperature and rainfall. What determines the temperate of an object or region made of a specific material? O energy Othere is no one thing that determines it it is unknown size of object Question 2 2 pts Which of the following BEST describes the Greenhouse effect? atmosphere acting like a heat lamp powered by the Earth's own heat the trapping of the sun's heat the reflection of the sun's heat there...
Hot carbon dioxide exhaust gas at 1 atm is being cooled by flat plates. The gas at 220°C flows in parallel over the upper and lower surfaces of a 1.4-m-long flat plate at a velocity of 1.8 m/s and the flat plate surface temperature is maintained at 80°C. The properties of CO2 at Tf = (220°C + 80°C)/2 = 150°C are k = 0.02652 W/m∙K, ν = 1.627 × 10−5 m2/s, and Pr = 0.7445. Determine the local convection heat...