A plate and frame HX has19 stainless steel (316SS) plates.9 m tall, 2 mm thick and .7 m wide which are spaced 5 mm apart. It is used to cool water at .012 m3/s,and inlet temperature of 35 C. The cooling medium s cold water which enters the HX at 7 C with the volumetric flow rate of 0.02 m3/s. What outlet temperature can be expected when the exchanger is new?
A plate and frame HX has19 stainless steel (316SS) plates.9 m tall, 2 mm thick and...
4 Several solar collectors are used to obtain energy from the sun to heat ethylene lycol. The ethylene glycol flows at 0.006 m3/s from the collectors to a plate and frame heat exchanger. The ethylene glycol enters the heat exchanger at 24°C where it transfers heat to fresh water. The water enters the exchanger at 0.005 m3/s, with a temperature of 1 4.3 mm. There are 15 plates made of 304SS (stainless steel) that are 0.8 mm thick x 0....
Several solar collectors are used to obtain energy from the sun to heat ethylene glycol. The ethylene glycol flows at 0.006 m3/s from the collectors to a plate and frame heat exchanger. The ethylene glycol enters the heat exchanger at 24°C, where it transfers heat to fresh water. The water enters the exchanger at 0.005 m3/s, with a temperature of 10°C. The plate height is 1.5 m, and a plate spacing of 4.3 mm. There are 15 plates made of...
2. Two stainless steel plate 10 mm thick are subjected to a constant pressure of 1 bar under vacuum conditions for which there is an overall temperature drop of 100°C across the plate. What would be effect of loading silicone oil on metallic interface? TABLE 3.1 Thermal contact resistance for (a) metallic interfaces under vacuum conditions and (b) aluminum interface (10-um surface roughness, 105 Nm2 with different interfacial fluids [1 Thermal Resistance, Rzc x 10 (m2-K/W) (a) Vacuum Interface Contact...
summarizr the followung info and write them in your own words and break them into different key points. 6.5 Metering Chamber: 6.5.1 The minimum size of the metering box is governed by the metering area required to obtain a representative test area for the specimen (see 7.2) and for maintenance of reasonable test accuracy. For example, for specimens incorporating air spaces or stud spaces, the metering area shall span an integral number of spaces (see 5.5). The depth of...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...