Question

how to do this drawing with loft, using autocad solid model

Draw as a loft the C Clamp shown. Use the shapes (A,B,C,and D) as the cross sections and the polyline (in color) as the guide curve. Add $1 unit cylinders to the ends. Make one cylinder.125H (Height) and the other 1.125H (Height). The cylinders should be centered on profile D and located at the ends of the loft as shown. Make a 0.625 hole through the larger cylinder .250 2x R.250 1.500 1.250 1.000 3X R.125 С B Cross Sections 500 2.250 D Layout

Answer 1

Answer :  

Step 1: Open Autocad software an and select 2D annotations module.

Step 2 : Take align command and draw as per given below profile.

ye B -R O BARR D

Step 3 : After drawing the above profile by using the line command, circle command and must be carefully joined without any open loops.

Please don't use any JOIN command because in this solid component there is a different cross sections at different points so we shouldn't use "JOIN COMMAND".

Step 4 : In this 2D drafting module draw A,B,C,D away from the tab attached line diagram given specification.

Step 5 : Now select the 3D drafting on the near the command bar settings.

Step 5 : Now select the "LOFT COMMAND" in 3D module after that select the B section and C section and draw as per given a 2D diagram in water position it has and after selecting Loft command select the B Section and C section and the 2D profile as per three-dimensional object and automatically the solid formation take place .

8 ہے ه B

Step 6: Repeat the above steps at different sections in different points and the final required three-dimensional object will be formed.