Pressure at a point in a static fluid=Pa+dgh, where Pa is atmospheric pressure, d is density of the fluid ,g is gravitational acceleration,h is depth of the point from the surface.
Since, for both the given points, depth of the point from the surface is same(=1 m), pressure at both points must be same,as other parameters(Pa,d and g) are also same.
So, the pressure one meter below the surface of water is same at the shallow end and the deep end.
Question 2 1 pts Consider a full swimming pool. The pressure one meter below the surface...
Consider a full swimming pool. The pressure one meter below the surface of the water A. is lower at the shallow end than at the deep end. B. is the same at the shallow end and the deep end. C. is higher at the shallow end than at the deep end
Question 19 2 pts The atmospheric pressure at the surface of a swimming pool is 101.3 kPa. What is the pressure 3.94 m below the surface? (InkPa, a kPa is a kilopascal or 1000 N/m)
4. Measured along the surface of the water, a rectangular swimming pool has a length of 20m. The pool is divided in half into a "shallow end" which is 0.8m deep and a deep end. the deep end results because at the exact halfway point of the pool the bottom slopes downward at an angle of 35 degrees until it reaches the far wall. a) find the pressure at both ends of the pool b) find the change in the...
A cube of wood floats on the surface of a swimming pool. Each side of the cube is 0.25 cm long and the cube has a density of 750 kg m-3 . a.) What fraction of the cube is submerged? b.) If the cube is replaced by one made from another material, what is the maximum allowed density for the new cube to float? c.) The pressure at the bottom of the deep end of the pool is 1.4 x...
A swimming pool is 20 ft wide and 40 ft long and its bottom is an inclined plane, the shallow end having a depth of 3 ft and the deep end, 10 ft. Assume the pool is full of water. (Round your answers to the nearest whole number. Recall that the weight density of water is 62.5 lb/ft3.) swimming pool is 20 ft wide and 40 ft long and its bottom is an inclined plane, the shallow end having a...
(c10p4) A swimming pool is 50 m long by 23 m wide and is less deep at one end than at the other. The depth at the shallow end is 1.02 m, and the depth at the deep end is 4.65 m. The slope is continuous (smooth) from one end to the other. What is the difference in pressure on the bottom at opposite ends of the pool?(expressed in Pa)
An engineer is hired to design a swimming pool 15 6 m wide by 2 m deep. For water supply, he dech 600 m of 5 m long by tlay ay y main to the pool during the pressure at the water main cm pipe (f 0.020) from a nearb pool The pipe will discharge free entire filling process. The average p ly into the the difference in elevation between the two ends of the pipe is 10 m, with...
6: Time to Fill a Pool -10.0 pts possible Question Water flows into a swimming pool at the rate of 13.7 gal/min If the pool dimensions are 32.5 ft wide, 41.7 ft long and 14.5 ft deep, how long dod it take to fill the pool? (1 gallon 231 cubic inches) Answer in units of min. @2019 Colleg Quest Learning & Assessment is pro
Water has a density of 1000 kg/m^2. The depth of a swimming pool at the deep end is about 5.0 meters. a. What is the volume of a column of water 5.0 m deep red 0.8 m^2 in cross-sectional area? b. What is the mass of this columns of water? c. What is weight of this column of water in newtons? d. What is the pressure on the bottom of the pool?
What is the gauge pressure (in Pascals) at a depth of 3.13m below the surface of a swimming pool Assume the density of water is 1000 kg/m QUESTION 2 At what depth (in meters) in the ocean is the gauge pressure 10 times larger than atmospheric pressure? Assume that the density of water in the ocean is 1000 kg/m3 and that atmospheric pressure is 101,325 Pa