Please Rate
Thank you !!!!!!!!!
Question 2 The pressure gage in an air cylinder reads 1,680 kPa. The cylinder is constructed...
Question 6.102 A spherical pressure vessel of ... TRANSF PROBLEMS 6.100 Determine the normal stress in a basketball of 12-in. diameter and 0.1-in. wall thickness which has been inflated to a gage pressure of 15 psi. 6.101 A spherical gas container made of steel is 20 ft in diameter and has a uniform wall thickness of 16 in. Knowing that the internal pressure is 75 psi, deter mine the maximum normal stress and the maximum shearing stress in the con...
Plz answer 3.3 and 3.4 Question 3 10 Marks During laboratory testing of a thin-wall pressure vessel, the cylinder diameter and thickness were at 10 different locations: the resulting data were as follows If the pressure inside the vessel is measured to be P - 1 mPa (mega Pascal) with an estimated uncertainty of up-+ 6 kPa (kilo Pascal, for 95% confidence interval, the tangential or hoop stress in the vessel is given by ơe-- 3.1 Compute the uncertainty in...
please draw and solve show every thing details “” Question 3 128 Marks 2 rectangular beam shown in the figure is subjected to a fluctuating axial force. It fluctuates between 5 kN and 15 kN keeping its direction. The beam is to be machined to the dimensions shown in the figure with a transvers hole of diameter d-14 mm/ Material of the beam is AISI 1040 CD steel (S-590 stress concentration factor as 2.2. K Pa, Sy 490 MPa). Take...
Question #5 (20 pts) A pinion has 18 teeth and a diametral pitch of 9 teeth/in, a face width of 1,5 in sa pressure angle of 20° with full-depth teeth. The spur gear is made by the milling or emin required to transmit at least 11 hp horsepower with a corresponding speed and moderate applications. Which material is the best choice for the spu ones in Table 5 considering the maximum allowable bending stres (factor of safety, nd-2.5)? U quations...
pts per question) 1. A 2 m piston cylinder device contains nitroen gas at 200 kPa and 350K. Now heat is transferred to the nitrogen in the tank and the pressure of nitrogen rises to 900 kPa and volume is maintained at same. The boundary work done during this process is (a) 1080 kJ (b) 840 k (c)240 k 2. A heat engine receives heat from a source at 727°C and rejiects the waste heat to a sink at 27°C,...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...