Problem 3 To help support a vertical retaining wall, a metal rod is pushed into the...
EMT 101- Engineering Programming Homework 3 Deflection of an I-Beam(100 %) You are to develop a program that calculates and plots the vertical deflection of a beam subjected to a force acting on it as given in Figure 1. The I-Beam has length, L 2m with its left end fixed at the wall (no deflection at wall) The right end of the beam is applied with a vertical load force P with a vertical deflection function (3L -a) EI wherer...
Which solution is correct the question is same
Practice Problem #3 For the retaining wall shown in Figure 13.19a, determine the force per unit length of the wall for Rankine's active state. Also find the location of the resultant. y = 16 kN/m = 30 d' = 0 Groundwater table Y = 18 kNm = 35° 0% = 7zK, -20'/K. 20 Ø 1:32 Answer 1 of 1 D + Ramkine ra' active Pressure y z k-2 - SKA Po or...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...
Solve problem 2 and 3 with details . Thank you
Notre Dame University-Louaize Faculty of Natural& Applied Sciences Department of Physics& Astronomy PHS 212-Electridity & Magnetism Fall 2018 Final Exam (22Dec18, 120min) Closed-book, Closed-notes, Close-everything Exam List in detail any assumptions that you make. Show all your work. You can use a calcalater Useful Constants: e1.6x 10C, charge of 1 electron k-8.9875x10 Nm/C2 mass of 1 electron: 9.11 x 10 kg 1. Three point charges, q +15 C, q +35...