offret Secthan 18 SKETCH THE APPROPRIATE SECTIONAL VIEW. OBIECT IS MADE OF PLASTIC.
SECTIONAL VIEWS NAME CHAPTER 04 EXERCISE 06 DATE SKETCH A HALF SECTIONAL VIEW 0BJECT IS MADE OF LEAD Add cutting-plane to drawing 17
SKETCH THE AUXILIARY VIEW SKETCH THE APPROPRIATE AUXILIARY VIEW
What is the appropriate sectional view? FNCwERNG NESIGN GRAPHICS WITH AUGMENTED REALITY
A hand-operated control wheel made of aluminum has the proportions shown in the cross-sectional view (see gure on the right). The area of the total section shown is 15 200 mm2, and the wheel has a mass of 10 kg. Calculate the distance r to the centroid of the half-section. The aluminium has a density of 2.69 Mg/m3. 1. (10 points) A hand-operated control wheel made of aluminium has the proportions shown in the cross-sectional view (see figure on the...
Question The structural component shown is made from lengths of RHS with the cross-sectional dimensions as shown. For the loading shown determine the magnitudes of the stress components at points B and C. Sketch the state of stress at points B and C on an element representing each point (include coordinate axes for reference 40 300 100 2 kN 50 50 400 500 Side View 2 kN 1kN 40 00 5 (Centroidal moment of inertia for a rectangle, 7 =...
Class Name Number Score Pts. 18 Got 9. Given two views of a solid, draw the half sectional left side view. A- A Class Name Number Score Pts. 18 Got 9. Given two views of a solid, draw the half sectional left side view. A- A
(a) The H-beam is made of an elastic-plastic material for which σy = 400 MPa. Find the plastic moment Mp and the maximum elastic moment Me and determine the shape factor for the cross section of the H-beam. Also, determine the residual stresses in the top and bottom of the beam after the plastic moment MP is applied and then released. (b) The continuous beam shown in Figure is made of the same cross section as in part a and...
The H-beam is made of an elastic-plastic material for which σy = 400 MPa. Find the plastic moment Mp and the maximum elastic moment Me and determine the shape factor for the cross section of the H-beam. Also, determine the residual stresses in the top and bottom of the beam after the plastic moment MP is applied and then released. Question 4 a The H-beam is made of an elastic-plastic material for which oy 400 MPa. Find the plastic moment...
Problem 5. Pipes made of plastic are frequently used in sewers. Plastic pipe walls can be assumed smooth with the friction factor dependent upon Reynolds Number only. For the following, use a pipe diameter of 18 inches and temperature of 60° F a. Using the Moody Diagram, calculate the friction slope (hu/L) for flow rates of 6 and 10 cfs. By what percentage do the friction factors vary? b. For plastic pipes, a Manning's n value of 0.009 is often...
What is the correct? What type of sectional view is shown in the figure? Som Full section view Hall section view Offset section view Aligned section view What type of sectional view is shown in the figure? Full section view Hall section view Revolved section view Removed section view