1. Use the voltage divider equation to determine V 12 V 20A 2. Use the current...
0 - ZOOM + 1. Use current divider rule to find ii and iz + 120 4 0 , 323R, 30 A 123 R2 Enter Full Screen 2. Use Nodal Analysis to find Vị and V2 v 15 12 23 240 3100 593 O 4 A Ref. 3. Use Nodal Analysis to find V. 6V 1
1. Using Nodal analysis, determine the current i, and the voltage v 3 v 6 2
Use mesh analysis to determine the voltage across current source
(vx).
4. Use mesh analysis to determine the voltage across current source (%). ΙΩ 2Ω 2Ω
The circuit below is used as a voltage divider. The input voltage is 12 V. The output voltage (that is the voltage across R2) must be 8.3 V. The current consumed by the divider must be 4.2 mA. Find the required resistances R1 and R2. (Unit:Ohm) RI X NAA R1 - R2- Submit Answer Incorrect. Tries 1/3 Previous Tries
a) Using nodal analysis determine the voltage across
the 1 ohm resistor.
b) using mesh analysis determine the current
across the voltage source.
nr )edder me nu current Nh) wsern esh analysis
use mesh nodal or branch analysis
MW2201 Ri measured = Vabs R24 Rc w - 1 k 2 R2 measured Ob RA measured 10 V 217 90.) 995K 995K -995k RB measured 1 ΚΩ 1kΩ RC measured FIG. 17.4 (b) Calculate the source current I and the voltage Vab using any method other than a 4-Y conversion (that is, mesh analysis, nodal analysis, and so on).
Use voltage divider rule to
determine the value of current Io1 in the following schematic
2mA(↓ V Iol
Why the value of 12 at mesh 2,3 ??
2.26 The current ia and the voltage source in Fig. P2.26 PSPICE are 1 A and 2V respectively. If the current ig is 1 A: a) Find the mesh currents. b) Find the power dissipated in each resistor c) Find vg d) Find the cumulative power dissipated across all MULTISIM the resistors put together in the given circuit. Figure P2.26 362 3Ω 2Ω 1Ω 2 V 2Ω
Q4/// What is the current of the 40 v ?voltage source of the circuit below SA 202 w 802 w 103 40 20 V 40 V Current source Voltage source leave question o 13 A 0.5 A O 12A O 10 A 1A O أخرى: Q5/// The maximum power dissipated in a 4 load is 100 w when connected to a d.c. voltage V and internal resistance R. Calculate: the current in the load, internal *.resistance R, and voltage V...
confused on the eqautions
based L LIDER 1. Draw the circuit diagram of a voltare divider biased JF terminals. VOD . 10mA 690 2m DAN I lov boron 33. 3k Zm3 Test-01 10/15/2019 4 Determine the point of the circuit in Question 1 (Show all steps below). Mark the Q-point and its coordinates on the graph in Question 3 5. Determine the following for the circuit in Question 1. (A) Drain voltage (B) Source voltage (C) Gate voltage (D) Gate...