stion No:3 (30 pts) Assume any missing data, use only LRDF method For the connection shown...
follow australian codes
(a) The rigid bolted connection shown in Figure 4 is used to transmit a total vertical load of 350 kN applied as shown. Two bracket plates are connected to the flanges of the I section using the bolt groups (refer figure 4) and hence, the bolts are loaded in- plane. Determine if the bolted connection shown in Figure 4 can safely support the applied load (use cl. 9.4.1 AS4100 1998). The bolts are M20 of 8.8S grade...
Question 8.
Section 2-3 Shear Stresses 6. In the bolted connection of Fig. 2-8, assume that the bolts are , in. in diameter and that the allowable shear stress for the bolts is 14,500 psi. Based on bolt shear only, compute the safe allowable load P that may be applied 7. Compute the force required to punch a 1 in. diameter hole through a ½ in, thick boiler plate. The ultimate shear strength for the material is 42,000 psi. 8....
Standard design practice, as exhibited by the solutions to Probs. 8-66 to 8-70, is to assume that the bolts, or rivets, share the shear equally. For many situations, such an assumption may lead to an unsafe design. Consider the yoke bracket of Prob. 8-61, for example. Suppose this bracket is bolted to a wide-flange column with the centerline through the two bolts in the vertical direction. A vertical load through the yoke-pin hole at distance B from the column flange...