L
Outline how you would determine the amount of head needed to pump water from a low...
Could you give me a worked example on how to determine pump head needed in piping system with branch?
2. The head-discharge relationship of a pump is given by: h = 38 – 650Q2 in which h is the head in metres, and Q is the discharge in cubic metres per second. It is fitted in a pipeline having a total head loss due to pipe friction as: h = 3043Q2. If the pump is used to lift water from a reservoir to another 15 m higher level reservoir, determine: i. ii. The head and discharge at the operating...
Q4. A pump draws water from a large reservoir and delivers it to another reservoir whose water surface is 10 m higher than the pump centreline and that the pump is 1.5 meter above the suction reservoir. The total suction and deliver pipe used is 21.1 m in length, 9 cm in diameter and has a Darcy friction factor f0.0339. The pump operates at 750 rpm and its characteristic performances are given in table below: Q (m3 s H (m)15...
diameter as shown in the A pump is used to deliver water from an opened reservoir through a pipe with 4 cm of figure. The water flows through the system with a rate of 360 m hour and d head loss is measured to be 7 m, calculate the useful power of pump of water in reservoir while point 2 is set correction factor to be 1.0 scharged to the atmosphere. If the total in unit of Pa. Point 1...
1. how do you determine the culture amount needed to prepare a bacterial smear? 2. what would be possible outcomes of a staining done in a slide with high cell concentrations? 3. what would be he problem if your smear has a low cell concentration?
The figure below shows a condenser/cooling tower pipe system needed to remove heat from a water cooled refrigeration condenser and reject the heat to the atmosphere. The amount of heat to be rejected to the atmosphere is 480,000 Btu/hr. The water enters the condenser at 85"F, and the temperature rise of the water through the condenser is 10°F. The total length of the piping in the system is 60 ft. Fittings are as shown. Assume bends to be as shown...
Design an arrangement for a sump pump to remove 12 inches of water from a 20 ft by 20 ft basement in one hour. Use the performance curve given and determine where to put the pump to pump the water up 30 feet, and how big an electric motor is needed. Note: Make sure the NPSH is obeyed.
You need to perform gravimetric analysis of a water sample in order to determine the amount of Ag present. List three aqueous solutions that would be suitable for mixing with the sample to perform the analysis b. a. Would adding KNO3(aq) allow you to perform the analysis? Assume you have performed the analysis and the silver solid that formed is moderately soluble. How might this affect your analysis results? C. You need to perform gravimetric analysis of a water sample...
A turbo pump transfers water from tank 1 to tank to tank 2 as shown in the picture below. The diameter of the piping system is D= 4in and the total length of pipes is L=620 ft. the elevation difference is Z1-Z2= 30ft. Use the chart for KL values. a) determine the flow rate (Q) b) power of the pump in HP Note that you can write out both mass balance equation and energy equation of the head form for...
A turbo pump transfers water from tank 1 to tank to tank 2 as shown in the picture below. The diameter of the piping system is D= 4in and the total length of pipes is L=620 ft. the elevation difference is Z1-Z2= 30ft. Use the chart for KL values. a) determine the flow rate (Q) b) power of the pump in HP Note that you can write out both mass balance equation and energy equation of the head form for...